2.4G
Regulation and operating procedure of 2.4G RC System
Binding for RC System of each model has been completed in factory, without needing to debug
again.
Normal operation manifested as below:
Power on the transmitter, the indicator of 2.4G transmitter will twinkle for 3 seconds, which indicates
that transmitter is sending code binding information. After 3 seconds, the twinkling 2.4G transmitter
indicator becomes solid, Then connect the receiver or 4in 1 mix controller, observe the receiver
or 4 in 1 mix controller, 2.4G transmitter indicator twinkles two times and gets solid, which indicates
that the reception of the channel data is successful and are ready to fly.
Turn on the transmitter and power on the helicopter. LED indicator of receiver or 4 in 1 mix controller
go out after twinkling two times, indicating that binding is failing and need to unbind firstly and rebind.
State indicator Bind keystoke
How to unbind?
Turn off the transmitter Connecting the
battery to receiver, Press the bind keystoke
for 1 or 2 seconds LED indicator of Receiver
will twinkle constantly, which indicates that unbinding has completed. (As shown in the right picture)
Rebind
Firstly disconnect the receiver and 4 in 1 mix controller, then connect the receiver or 4 in 1 mix controller
to the power the state indicator twinkles slowly, which indicates that receiver is receiving signal.
Then Power on the transmitter if the indicator of RX display from slow twinkling to rapid twinkling,
then solid, which indicate the binding is successful.(Note: transmitter just will transmit code in first 3
seconds, if receiver can not receive code within 3 seconds, please turn on the transmitter again.)
2.4G
2.4G TRANSMITTER INSTRUCTION MANUAL
52.4G Remote control system adopts Advanced Spread Spectrum Technology and digital FSK (frequency shift key) Coding Technology.
