Specifications MS5/5+12EC 5dB-4
MS5/5+12EL 5dB-4
MS5/5+12EC 10dB-4
MS5/5+12EL 10dB-4
MS5/5+16EC 5dB-4
MS5/5+16EL 5dB-4
MS5/5+16EC 10dB-4
MS5/5+16EL 10dB-4
Isolation of inputs 20 dB min) at user outputs, 25 dB min) at trunk outputs
Max. input signal level TERR 110 dBμV, SAT 90 dBuV
Max. output signal
level user outputs)
TERR 86 dBuV
SAT 85 dBuV
TERR 83 dBuV
SAT 80 dBuV
TERR 85 dBuV
SAT 85 dBuV
TERR 82 dBuV
SAT 80 dBuV
Current consumption 50 mA 18V) each receiver
Dimensions 18.2 x 15.2 x 4.5 cm
Temperature Range
−25 – +60 °C
*TERR: EN 50083-3/60dB IMA3 [dBuV]; SAT: EN 50083-3/35dB IMA3 [dBuV]
3) roduct Takeover
Make sure that the product is not damaged. Please contact your dealer in the case of damage.
4) roduct Storing and Installation
We recommend the device to be installed and serviced by the qualified technician.
The product must not be stored and installed
•in the place with excessive humidity
•in the place with excessive dust pollution, mechanical vibrations or impacts
•in the place out of temperature limits specified in the section 2) Technical Specifications
•close to heat sources radiators or air ventilators, direct sunshine etc.)
•in the reach of children.
Do not expose the apparatus to dripping or splashing. Use the apparatus only in moderate climates not in
tropical climate).
Fix the product firmly on a wall or another hard and inflammable surface with screws and dowels.
•The product shall be in no case held only by the connected cables.
•Do not cover the product with curtains etc.).
•Do not place any containers with liquids vases, glasses etc.) or naked flame sources lighted
candle etc.) on the product or near the product.
5) roduct connection
Connect the product in accordance with this manual and valid regulation in your country. Use high quality
75 Ω coaxial cable designed for satellite reception. Mount the F connectors screw, crimp or compress type)
on the ends of coaxial cables. Connect the F connectors into the F sockets of product and fasten them with
an appropriate force. The coaxial cables shall not be broken, the minimum bending radius should be 5 cm.
Where appropriate it is possible to use quick Fm–Fm adapters instead of cable jumpers.
•Connect input F sockets marked A–D and TERR IN with output F sockets of preceding element of
cascade LNB, cascadable multiswitch or amplifier).
•Connect output F sockets marked A–D and TERR OUT with input F sockets of next element of
cascade cascadable multiswitch, amplifier or termination block).
•Connect user outputs 1–12 or 1–16, according to type) to suitable wall sockets.
2 of 4
