MICRODELTA REWORK INTRODUCTION
The MicroDelta Rework is developed by eMotion Tech. This new 3D
printer is easy to assemble and to operate without loss of performances.
Data sheet :
DATAS
• Printing surface : Ø150x200mm
• Layer height : [0.1 - 0.4]
• Electronic type : eMotronic (32 bits, 96 MHz)
• Motors : NEMA 17
• Belt type : GT2
• Extrusion Head : Hexagon 0.4
• Dimensions : Height 440mm, Width 250mm, Depth 250mm
• Nominal printing speed : 80mm/s
• Max speed : 200mm/s
• Nominal travel speed : 150mm/s
• Average precision (X,Y) : 100 microns
• Average precision (Z) : 50 microns
• Operating system : Windows, Linux and Mac OS
• Consumable : PLA 1.75mm (or ABS and others plastics with heated
bed option)
• Provided with Repetier-Host pre-congured for µdelta
• Connectivity : USB
• Power supply provided : 24V, 150W
STRUCTURE
• Upper and lower plates made of bended stainless steel
• Machined aluminium core
• 10mm rectied Smooth rods
• Plastic injected sliders
ERGONOMY
Easy to mount : A 3D printer kit with an intuitive assembly
• Simple electronic, no soldering
• Easy wiring and assembly
• Belt adjustment with ergonomic belt tensioners
Easy to calibrate : A simplied software
• Fully software calibration
• Pre-congured open-source software (no rmware upload required,
Repetier Host and Slic3r pre-congured)
Easy to maintain
• Quick height adjustement with the software
• Easy to reload the lament
