Edge-Core ES4626F Manuel de programmation

Management Guide

ES4626F/ES4650F

24/48-Port

Stackable Layer 3

Gigabit Ethernet Switch

Management Guide

ES4626F Gigabit Ethernet Switch

Stackable Layer 3 Switch

with 20 10/100/1000BASE-T (RJ-45) Ports,

4 Gigabit Combination Ports (RJ-45/SFP),

2 10-Gigabit Extender Module Slots,

and 2 Stacking Ports

ES4650F Gigabit Ethernet Switch

Stackable Layer 3 Switch

with 44 10/100/1000BASE-T (RJ-45) Ports,

4 Gigabit Combination Ports (RJ-45/SFP),

2 10-Gigabit Extender Module Slots,

and 2 Stacking Ports

ES4626F, ES4650F

F1.1.0.2 E062009-R01/ST

149100000013A

About This Guide

Purpose

This guide gives specific information on how to operate and use the management

functions of the switch.

Audience

The guide is intended for use by network administrators who are responsible for operating

and maintaining network equipment; consequently, it assumes a basic working

knowledge of general switch functions, the Internet Protocol (IP), and Simple Network

Management Protocol (SNMP).

Conventions

The following conventions are used throughout this guide to show information:

Note: Emphasizes important information or calls your attention to related features or

instructions.

Caution: Alerts you to a potential hazard that could cause loss of data, or damage the

system or equipment.

Warning: Alerts you to a potential hazard that could cause personal injury.

Related Publications

The following publication details the hardware features of the switch, including the

physical and performance-related characteristics, and how to install the switch:

The Installation Guide

Also, as part of the switch’s software, there is an online web-based help that describes all

management related features.

Revision History

This section summarizes the changes in each revision of this guide.

June 2009 Revision

This is the first release of this guide.

iii

Contents

Section I: Getting Started

Chapter 1: Introduction 1-1

Key Features 1-1

Description of Software Features 1-2

System Defaults 1-7

Chapter 2: Initial Configuration 2-1

Connecting to the Switch 2-1

Configuration Options 2-1

Required Connections 2-2

Remote Connections 2-3

Stack Operations 2-3

Selecting the Stack Master 2-3

Selecting the Backup Unit 2-4

Recovering from Stack Failure or Topology Change 2-4

Broken Link for Line and Wrap-around Topologies 2-4

Resilient IP Interface for Management Access 2-5

Resilient Configuration 2-5

Renumbering the Stack 2-5

Ensuring Consistent Code is Used Across the Stack 2-5

Basic Configuration 2-6

Console Connection 2-6

Setting Passwords 2-7

Setting an IP Address 2-7

Manual Configuration 2-8

Dynamic Configuration 2-11

Enabling SNMP Management Access 2-13

Community Strings (for SNMP version 1 and 2c clients) 2-13

Trap Receivers 2-14

Configuring Access for SNMP Version 3 Clients 2-15

Managing System Files 2-15

Saving Configuration Settings 2-16

Section II: Switch Management

Chapter 3: Configuring the Switch 3-1

Using the Web Interface 3-1

Navigating the Web Browser Interface 3-2

Home Page 3-2

Configuration Options 3-3

Panel Display 3-3

Contents

Main Menu 3-4

Chapter 4: Basic Management Tasks 4-1

Displaying System Information 4-1

Displaying Switch Hardware/Software Versions 4-3

Displaying Bridge Extension Capabilities 4-4

Setting the Switch’s IP Address (IP Version 4) 4-5

Manual Configuration 4-7

Using DHCP/BOOTP 4-8

Setting the Switch’s IP Address (IP Version 6) 4-9

Configuring an IPv6 Address 4-9

Configuring an IPv6 General Network Prefix 4-15

Configuring Neighbor Detection Protocol and Static Entries 4-17

Configuring Support for Jumbo Frames 4-21

Managing Firmware 4-21

Downloading System Software from a Server 4-22

Saving or Restoring Configuration Settings 4-24

Downloading Configuration Settings from a Server 4-25

Console Port Settings 4-26

Telnet Settings 4-28

Configuring Event Logging 4-30

System Log Configuration 4-30

Remote Log Configuration 4-31

Displaying Log Messages 4-33

Sending Simple Mail Transfer Protocol Alerts 4-33

Renumbering the Stack 4-35

Resetting the System 4-36

Setting the System Clock 4-36

Setting the Current Time 4-37

Configuring SNTP 4-37

Setting the Time Zone 4-39

Configuring Summer Time 4-40

Chapter 5: Simple Network Management Protocol 5-1

Enabling the SNMP Agent 5-2

Setting Community Access Strings 5-3

Specifying Trap Managers and Trap Types 5-4

Configuring SNMPv3 Management Access 5-7

Setting a Local Engine ID 5-7

Specifying a Remote Engine ID 5-8

Configuring SNMPv3 Users 5-9

Configuring Remote SNMPv3 Users 5-11

Configuring SNMPv3 Groups 5-13

Setting SNMPv3 Views 5-17

Contents

Chapter 6: User Authentication 6-1

Configuring User Accounts 6-1

Configuring Local/Remote Logon Authentication 6-2

Configuring HTTPS 6-5

Replacing the Default Secure-site Certificate 6-7

Configuring the Secure Shell 6-8

Generating the Host Key Pair 6-10

Importing User Public Keys 6-12

Configuring the SSH Server 6-14

Configuring Port Security 6-16

Configuring 802.1X Port Authentication 6-18

Displaying 802.1X Global Settings 6-19

Configuring 802.1X Global Settings 6-20

Configuring Port Settings for 802.1X 6-20

Displaying 802.1X Statistics 6-24

Filtering IP Addresses for Management Access 6-26

Chapter 7: Access Control Lists 7-1

Configuring Access Control Lists 7-1

Setting the ACL Name and Type 7-1

Configuring a Standard IPv4 ACL 7-2

Configuring an Extended IPv4 ACL 7-3

Configuring a MAC ACL 7-6

Configuring a Standard IPv6 ACL 7-7

Configuring an Extended IPv6 ACL 7-8

Binding a Port to an Access Control List 7-11

Chapter 8: Port Configuration 8-1

Displaying Connection Status 8-1

Configuring Interface Connections 8-3

Creating Trunk Groups 8-6

Statically Configuring a Trunk 8-7

Enabling LACP on Selected Ports 8-8

Configuring LACP Parameters 8-10

Displaying LACP Port Counters 8-13

Displaying LACP Settings and Status for the Local Side 8-14

Displaying LACP Settings and Status for the Remote Side 8-16

Setting Broadcast Storm Thresholds 8-17

Configuring Port Mirroring 8-19

Configuring Rate Limits 8-20

Showing Port Statistics 8-22

Chapter 9: Address Table Settings 9-1

Setting Static Addresses 9-1

Displaying the Address Table 9-2

Changing the Aging Time 9-4

Contents

Chapter 10: Spanning Tree Algorithm 10-1

Displaying Global Settings 10-3

Configuring Global Settings 10-6

Displaying Interface Settings 10-10

Configuring Interface Settings 10-13

Configuring Multiple Spanning Trees 10-16

Displaying Interface Settings for MSTP 10-19

Configuring Interface Settings for MSTP 10-20

Chapter 11: VLAN Configuration 11-1

IEEE 802.1Q VLANs 11-1

Enabling or Disabling GVRP (Global Setting) 11-4

Displaying Basic VLAN Information 11-4

Displaying Current VLANs 11-5

Creating VLANs 11-6

Adding Static Members to VLANs (VLAN Index) 11-7

Adding Static Members to VLANs (Port Index) 11-9

Configuring VLAN Behavior for Interfaces 11-10

Configuring IEEE 802.1Q Tunneling 11-12

Enabling QinQ Tunneling on the Switch 11-16

Adding an Interface to a QinQ Tunnel 11-17

Configuring Private VLANs 11-18

Enabling Private VLANs 11-19

Configuring Uplink and Downlink Ports 11-19

Configuring Protocol-Based VLANs 11-20

Configuring Protocol Groups 11-20

Mapping Protocols to VLANs 11-21

Chapter 12: Link Layer Discovery Protocol 12-1

Setting Basic LLDP Timing Attributes 12-1

Configuring LLDP Interface Attributes 12-3

Displaying LLDP Local Device Information 12-5

Displaying LLDP Remote Port Information 12-8

Displaying LLDP Remote Information Details 12-9

Displaying Device Statistics 12-11

Displaying Detailed Device Statistics 12-13

Chapter 13: Class of Service 13-1

Layer 2 Queue Settings 13-1

Setting the Default Priority for Interfaces 13-1

Mapping CoS Values to Egress Queues 13-3

Selecting the Queue Mode 13-5

Setting the Service Weight for Traffic Classes 13-6

Layer 3/4 Priority Settings 13-7

Mapping Layer 3/4 Priorities to CoS Values 13-7

Selecting IP Precedence/DSCP Priority 13-7

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Edge-Core Changer

Edge-Core

Edge-Core Wedge100BF-65X Manuel utilisateur

Edge-Core

Edge-Core ECS4125-10P Manuel utilisateur

Edge-Core

Edge-Core ECS4150-54T Manuel utilisateur

Edge-Core

Edge-Core ECS4650-54T Manuel utilisateur

Edge-Core

Edge-Core AS4600-54T Manuel utilisateur

Edge-Core

Edge-Core ECS2100-10P Manuel utilisateur

Edge-Core

Edge-Core AS4610-30T Manuel utilisateur

Edge-Core

Edge-Core ES3510MA-DC Manuel de programmation

Edge-Core

Edge-Core ECS4120 Series Manuel utilisateur

Edge-Core

Edge-Core AS7535-28XBE Manuel utilisateur

Edge-Core

Edge-Core ECS3510-26P Manuel utilisateur

Edge-Core

Edge-Core ECS4810-12M Manuel utilisateur

Edge-Core

Edge-Core AS6701-32X Manuel utilisateur

Edge-Core

Edge-Core ECS4510-12PD Manuel de programmation

Edge-Core

Edge-Core ES4512C Manuel utilisateur

Edge-Core

Edge-Core AS5610-52X Manuel utilisateur

Edge-Core

Edge-Core AGR420 Manuel utilisateur

Edge-Core

Edge-Core ES4624-SFP Manuel utilisateur

Edge-Core

Edge-Core ECS4660-28F Manuel de programmation

Edge-Core

Edge-Core Wedge100BF-32X Manuel utilisateur

Edge-Core

Edge-Core AS7816-64X Manuel utilisateur

Edge-Core

Edge-Core Gigabit Ethernet Switch Manuel utilisateur

Edge-Core

Edge-Core AS7326-56X Mode d'emploi

Edge-Core

Edge-Core ECS4620-28P Mode d’emploi

Manuels Changer populaires d'autres marques

URC

URC Total Control MFS-8 Manuel utilisateur

Azbil

Azbil HPQ-D11 Manuel utilisateur

Sony

Sony DFS-900M Manuel utilisateur

SICK

SICK i17S Manuel utilisateur

F&F

F&F SZR-277 Manuel utilisateur

Shure

Shure UAMS/BK Manuel utilisateur

Dräger

Dräger X-zone Switch Off Manuel utilisateur

Asco

Asco Joucomatic 349 Series Manuel utilisateur

BT Mini Hub Manuel utilisateur

D-Link

D-Link DES-1226G Manuel utilisateur

Johnson Controls

Johnson Controls FS80-C Manuel utilisateur

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Manuel utilisateur

MicroNet

MicroNet SP1200A Manuel utilisateur

Ruijie

Ruijie RG-PF2920 Series Manuel d'installation et d'exploitation

Altinex

Altinex DA1914SX Manuel utilisateur

MiLAN

MiLAN MIL-SM2401M Manuel utilisateur

RJM

RJM MASTERMIND PBC/6X Manuel utilisateur

Atlas

Atlas MMK-KVM8 Manuel utilisateur