Edelbrock 68452 Manuel utilisateur

Rev. 5/06 - DA/mc Catalog #68452, #68453

Brochure #63-68452

Page 1 of 2

SHORTY HEADER

for 1986-1993 Ford Mustang, Capri, Mark,

5.0L (302 V8) with E.F.I., Auto & Standard Transmission

Catalog #68452, #68453

INSTALLATION INSTRUCTIONS

PLEASE study these instructions carefully before installing your new Shorty Header. If you have any questions, please call

our Technical Hotline at: 1-800-416-8628 from 7:00 am - 5:00 pm, Monday-Friday, Pacific Standard Time or e-mail

us at [email protected]. Please fill out and mail your warranty card.

HEADERS: These components are designed to improve the exhaust efficiency of the Ford 5.0 Litre V8 engine with E.F.I.

(Electronic Fuel Injection). These tubular manifolds are a direct replacement for the factory exhaust manifolds. A

performance gain can be expected by the installation of this system. This system does not require welding for installation

and retains all O.E.M. emissions equipment.

SUGGESTED TOOLS FOR INSTALLATION:

❑3/8" ratchet socket set with extensions and sockets ❑Jackstands, screwdrivers, pliers, crescent wrench, etc.

❑Combination set of open-end wrenches ❑Liquid penetrant, anti-seize compound

SPECIAL NOTICE: This Edelbrock part has received an Executive Order (E.O. #) from the California Air Resources Board

(C.A.R.B.) making it legal for street use on pollution-controlled motor vehicles in all 50 states. To assist you with emissions

equipment certification, we have included a silver fan shroud decal to help testing personnel verify that this part is a legal

replacement part on the vehicle for which it is cataloged. The adhesive-backed decal should be affixed to your fan shroud

next to the existing emission and engine specification decal. Do not cover your original equipment specification decal with

the Edelbrock fan shroud decal.

WARNING: The use of "Thermal Wrap" or any aftermarket coating process will void the warranty on your

headers. Those products can cause excessive heat and moisture buildup resulting in corrosion and early

failure of the system.

NOTE: High temperature spark plug wires and boots are recommended to withstand heat from Headers.

IMPORTANT NOTE:

Proper installation is the responsibility of the installer. Improper installation will void warranty and may

result in poor performance and engine or vehicle damage.

Rev. 5/06 - DA/mc Catalog #68452, #68453

Brochure #63-68452

Page 2 of 2

Edelbrock Corporation, 2700 California St., Torrance, CA 90503

Tech Line: (800) 416-8628

Office: (310) 781-2222

E-Mail: [email protected]

• DISASSEMBLY

1. Disconnect negative cable from battery.

2. Use penetrating oil on all nuts and bolts to be

removed. This will prevent the possibility of

broken or stripped nuts and bolts.

3. Unbolt exhaust pipes from both exhaust

manifolds.

4. Unbolt and remove both exhaust manifolds.

5. Clean and inspect all sealing surfaces before

assembly.

• ASSEMBLY - LEFT SIDE

1. With manifold port gasket in place, start a

header bolt with lock and flat washer in the

rearmost bolt hole leaving enough room for the

manifold to slip into position.

2. Start balance of header bolts with lock washers

and tighten evenly.

• ASSEMBLY - RIGHT SIDE

1. With gasket in place, start all bolts except the

rear bolt with lock and flat washers on each.

2. Start rear bolt with A.I.R. tube support bracket in

place.

3. Tighten balance of header bolts evenly.

4. Re-attach exhaust pipes to TES manifolds using

your original nuts.

5. Connect all parts including battery.

6. Start engine and bring up to normal running

temperature, then turn off and let cool.

7. When cool, re-tighten all manifold nuts and bolts.

INSTALLATION INSTRUCTIONS

HARDWARE SUPPLIED

Catalog #68452 (Ceramic-Coated), #68453 (Ti-Tech Coated)

Qty.Description Qty.Description

❑1 #25-9269 Header left side (#68452) ❑16 Header bolts; 3/8”-16 x 1”

❑1 #25-9272 Header right side (#68452) ❑16 Lockwashers; 3/8”

❑1 #25-9036 Header left side (#68453)

❑1 A.I.R. tube support bracket

❑1 #25-9035 Header right side (#68453)

❑1 Hex nut; 1/4” - 20

❑2 Manifold port gaskets ❑1 Lockwasher; 1/4”

❑4 Flat washers; 3/8” ❑1 Hex cap screw; 1/4”-20 x 3/4”

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Edelbrock Pièce automobile

Edelbrock

Edelbrock 71852 Manuel utilisateur

Edelbrock

Edelbrock 5708 Manuel utilisateur

Edelbrock

Edelbrock 1403-1413 Manuel utilisateur

Edelbrock

Edelbrock Russell 651105 Manuel utilisateur

Edelbrock

Edelbrock 1797 Guide de démarrage rapide

Edelbrock

Edelbrock 66013 Manuel utilisateur

Edelbrock

Edelbrock THUNDER SERIES AVS 1803 Manuel utilisateur

Edelbrock

Edelbrock Performer RPM 351-W Ford V8 Manuel utilisateur

Edelbrock

Edelbrock 4742 Manuel utilisateur

Edelbrock

Edelbrock 65003 Manuel utilisateur

Edelbrock

Edelbrock 6510 Manuel utilisateur

Edelbrock

Edelbrock 60509 Manuel utilisateur

Edelbrock

Edelbrock 15008 Manuel utilisateur

Edelbrock

Edelbrock 5588 Manuel utilisateur

Edelbrock

Edelbrock 5674 Manuel utilisateur

Edelbrock

Edelbrock 61949 Manuel utilisateur

Edelbrock

Edelbrock 460 Ford Manuel utilisateur

Edelbrock

Edelbrock 5683 Manuel utilisateur

Edelbrock

Edelbrock 5282 Manuel utilisateur

Edelbrock

Edelbrock 94 Manuel utilisateur

Edelbrock

Edelbrock 66042 Manuel utilisateur

Edelbrock

Edelbrock 5204 Manuel utilisateur

Edelbrock

Edelbrock 33505 Manuel utilisateur

Edelbrock

Edelbrock 262-400 Manuel utilisateur

Manuels Pièce automobile populaires d'autres marques

Dakota Digital

Dakota Digital 650277 Manuel utilisateur

bosal

bosal 037031 Manuel utilisateur

Vintage Air

Vintage Air 571063 Manuel utilisateur

GFB

GFB EX38 Manuel utilisateur

bosal

bosal 028091 Manuel utilisateur

Dodge

Dodge 8W-43 Guide de démarrage rapide

ICI

ICI Magnum FBM10DGN Manuel utilisateur

Volant Perfomance

Volant Perfomance 19435 Manuel utilisateur

BENDIX

BENDIX GEN 4 GEN 5 ABS Manuel utilisateur

Vintage Air

Vintage Air 571065 Manuel utilisateur

Rugged Ridge

Rugged Ridge 11503.13 Manuel utilisateur

BENDIX

BENDIX CYCLONE DURADRAIN TRAILER WATER Manuel utilisateur

Porsche

Porsche 968 - ASSEMBLY INSPECTION PROCEDURE AND MAINTENANCE... Mode d’emploi

Sumitomo

Sumitomo FINE CYCLO FC-A 15 G Manuel utilisateur

Toshiba

Toshiba 48-1250 A Manuel utilisateur

aldes

aldes EHT2 Manuel utilisateur

Go Rhino

Go Rhino 24371T Manuel utilisateur

BBK

BBK 18950 Manuel utilisateur