Edelbrock 5588 Manuel utilisateur

Edelbrock Rebuildable Race Muffler

Repack Kit

Installation Instructions

Catalog #5588/55881

§PLEASE study these instructions carefully before installing your Headers. If you have any questions or

problems, please call our Technical Hotline at: 1-800-416-8628 from 8:00 am -5:00 pm, Monday-

Friday, Pacific Standard Time or e-mail us at [email protected].

§TOOLS NEEDED

1. Drill motor

2. 3/16 Drill bit

3. Pop rivet gun

§HOW TO TELL IF IT’S TIME TO REPACK YOUR EDELBROCK REBUILDABLE RACE MUFFLER

1. If you have noticed a sound level change from the time when the mufflers were first installed.

2. When tapping on the outside of the muffler case it has an empty or hollow sound, it probably needs to be

repacked.

Note 1: Track size, number of laps run, engine condition and tune, type of fuel used, muffler placement, etc. all

have an effect on the muffler packing life. Typical S.C.R.A. Sprint Car that were tested with the

Edelbrock Rebuildable Race Muffler have been getting between 5 to 10 nights of racing on new or

repacked mufflers.

Note 2: Collector turndowns can be used to further quiet your vehicle. Turn downs can be installed to deflect

sound down to the ground or under the car and away from the D.B. meters.

§DISASSEMBLY

1. Using the drill motor and the 3/16 drill bit, drill out all of the rivets in the muffler case being cautious not to

enlarge the rivet holes.

2. Disassemble the muffler assembly.

3. Remove what is left of the old packing, clean were needed, be sure to remove any pieces of the old rivets that

may be remaining in the outer case.

§ASSEMBLY

1. Slip on the new steel wool sleeve (Note: On the 3 ½” diameter muffler, a piece of 3” diameter tubing flared

to 3 ½” I.D. on one end will make this job much easier).

2. Wrap the ceramic packing around the installed steel wool sleeve.

3. Wrap the ceramic cloth material around the outside of the ceramic packing.

Note: Position the seam or the end of the packing and the cloth on opposite sides of the muffler. Rubber

bands or masking tape can be used to hold the packing in place.

4. Slide the outer case over the outside of the ceramic cloth and packing. Stand the muffler on the outlet end,

gently squeeze the packing at the top and begin working down while the outer case slips down over the new

packing.

Note: Make sure the packing and ceramic cloth stay in place as the outer case is worked down. The better

the repack job the longer it will be between repacks.

5. When the outer case has been completely slipped down, install the inlet end of muffler and align the rivet

holes. Using the rivet gun install the rivets.

Note: After the muffler goes through a number of repacks it may be necessary to drill additional or new

holes to hold the muffler case securely together.

Edelbrock Corporation • 2700 California Street • Torrance • California 90503

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Edelbrock Pièce automobile

Edelbrock

Edelbrock 1713 Manuel utilisateur

Edelbrock

Edelbrock 72282 Manuel utilisateur

Edelbrock

Edelbrock 67322 Manuel utilisateur

Edelbrock

Edelbrock 65022 Manuel utilisateur

Edelbrock

Edelbrock 15041 Manuel utilisateur

Edelbrock

Edelbrock 72279 Manuel utilisateur

Edelbrock

Edelbrock Russell DOT R08463S Manuel utilisateur

Edelbrock

Edelbrock 66062 Manuel utilisateur

Edelbrock

Edelbrock 5758 Manuel utilisateur

Edelbrock

Edelbrock Chevrolet/GMC Trucks 454 SS Manuel utilisateur

Edelbrock

Edelbrock Honda 99-LATER Manuel du propriétaire

Edelbrock

Edelbrock 66082 Manuel utilisateur

Edelbrock

Edelbrock Torker II 5081 Manuel utilisateur

Edelbrock

Edelbrock 2010 Manuel utilisateur

Edelbrock

Edelbrock 1472 Manuel utilisateur

Edelbrock

Edelbrock 72310 Manuel utilisateur

Edelbrock

Edelbrock 2980 Manuel utilisateur

Edelbrock

Edelbrock 541583 Manuel utilisateur

Edelbrock

Edelbrock 4790 Manuel utilisateur

Edelbrock

Edelbrock 66013 Manuel utilisateur

Edelbrock

Edelbrock 6500 Manuel utilisateur

Edelbrock

Edelbrock 7880 Manuel utilisateur

Edelbrock

Edelbrock 66182 Manuel utilisateur

Edelbrock

Edelbrock 9629 Manuel utilisateur

Manuels Pièce automobile populaires d'autres marques

Dakota Digital

Dakota Digital 650277 Manuel utilisateur

bosal

bosal 037031 Manuel utilisateur

Vintage Air

Vintage Air 571063 Manuel utilisateur

GFB

GFB EX38 Manuel utilisateur

bosal

bosal 028091 Manuel utilisateur

Dodge

Dodge 8W-43 Guide de démarrage rapide

ICI

ICI Magnum FBM10DGN Manuel utilisateur

Volant Perfomance

Volant Perfomance 19435 Manuel utilisateur

BENDIX

BENDIX GEN 4 GEN 5 ABS Manuel utilisateur

Vintage Air

Vintage Air 571065 Manuel utilisateur

Rugged Ridge

Rugged Ridge 11503.13 Manuel utilisateur

BENDIX

BENDIX CYCLONE DURADRAIN TRAILER WATER Manuel utilisateur

Porsche

Porsche 968 - ASSEMBLY INSPECTION PROCEDURE AND MAINTENANCE... Mode d’emploi

Sumitomo

Sumitomo FINE CYCLO FC-A 15 G Manuel utilisateur

Toshiba

Toshiba 48-1250 A Manuel utilisateur

aldes

aldes EHT2 Manuel utilisateur

Go Rhino

Go Rhino 24371T Manuel utilisateur

BBK

BBK 18950 Manuel utilisateur