Dimplex EOS-2006 Guide de démarrage rapide

PARTS AND SERVICE MANUAL

FOR THE

ELECTRIC PATIO STOVE

Model EOS2006

TABLE OF CONTENTS

OPERATION PAGE 2

PARTS DRAWING PAGE 4

PARTS LIST PAGE 5

WIRING DIAGRAM PAGE 6

LIGHT BULB REPLACEMENT PAGE 7

FLAME ROD AND MOTOR REPLACEMENT PAGE 8

CIRCUIT BOARD REPLACEMENT PAGE 9

SWITCH REPLACEMENT PAGE 10

POWER CORD REPLACEMENT PAGE 11

EOS2006

OPERATION

To access the controls go to the back of the Stove.

A. MAIN ON/OFF SWITCH

The on/off switch supplies power to all unit functions (flame/towel warmer)

B. TOWEL WARMER ON/OFF SWITCH

The towel warmer on/off switch supplies power to the towel warmer. The main on/off

switch must be on to activate towel warmer switch.

NOTE: When the Towel Warmer is switched ON, the warmer will operate. The warmer will

not operate if the cooler insert is still in place within the unit.

BEVERAGE COOLER

This stove has a convenient hidden beverage cooler located under the flip top lid. To use the

cooler ensure that cooler is inserted. Ice may be used. Place beverages in cooler insert and

surround with ice.

TOWEL WARMER

This unit has a convenient towel warmer built in. To operate the towel warmer remove cooler

insert, activate towel warmer switch (fig.2), and place dry towels in towel warmer

compartment. THIS IS NOT A TOWEL DRYER, DO NOT PLACE DAMP OR WET

TOWELS IN COMPARTMENT

EOS2006

REPLACEMENT PARTS

OUTDOOR ELECTRIC STOVE

CATALOGUE NO. EOS2006

PART NO. 6903510159

REPLACEMENT PART

1. MOTOR, ASSEMBLY 2000220100RP

2. CIRCUIT BOARD 3000570100RP

3. MIRROR 5900820100RP

4. FLAME ROD 5900340100RP

5. BUSHING 8500000400RP

6. LOGSET 0438270100RP

7. POWER CORD 4100170200RP

8. SWITCH, SPLASHPROOF 2800130200RP

9. TERMINAL BLOCK 4000070100RP

10. CAPACITOR 3200030100RP

11. COOLER ASSEMBLY 0478060100RP

WIRING DIAGRAM

EOS2006

LIGHT BULB REPLACEMENT

Allow at least 5 minutes for light bulbs to cool off before touching bulbs to avoid accidental

burning of skin.

Light bulbs need to be replaced when you notice a dark section of the flame or when the

clarity and detail of the log exterior disappears. There are three bulbs under the log set

which generate the flames and embers.

HELPFUL HINTS

It is a good idea to replace all light bulbs at one time if they are close to the end of their rated

life. Group replacement will reduce the number of times you need to open the unit to replace

light bulbs.

LIGHT BULB REPLACEMENT

1. Open door by pulling the handles.

2. Remove the screw from the logset located in the center of the emberbed and remove

the logset from the unit.

3. Locate and examine the bulbs to determine which bulb(s) required replacement.

4. Locate and remove the light bulb(s).

5. Insert new bulb(s).

6. Install the logset into the unit, pushing firmly against the glass. Replace the logset

retaining screw into the ember bed.

7. Close the doors.

LIGHT BULB REQUIREMENTS

Quantity of 3 clear chandelier or candelabra bulbs with an E-12 (small) socket base,

60 watt rating.

EOS2006

If unit was operating prior to servicing allow at least 10 minutes for light bulbs and heating

element to cool off to avoid accidental burning of skin.

Disconnect power before attempting any maintenance or cleaning to reduce the risk of

electric shock or damage to persons.

FLAME ROD AND MOTOR REPLACEMENT

1. Open door by pulling the handles.

2. Remove the screw from the logset located in the center of the emberbed and remove the

logset from the unit.

1. While holding the mirror to prevent it from moving, remove the 2 mirror retaining bracket

screws. Carefully remove the mirror and store in a safe place to prevent damage.

2. Remove the 3 screws securing rear reflector to the unit.

3. Remove the reflector rod from the flame motor by pulling the end of the rod to the left and

carefully remove flame rod from rubber sleeve.

4. Remove the 2 screws securing the flame motor to the flame motor bracket

5. Disconnect motor wiring connections from circuit board.

6. Discard the old motor.

7. Reassemble in the reverse order as above.

EOS2006

If unit was operating prior to servicing allow at least 10 minutes for light bulbs and heating

element to cool off to avoid accidental burning of skin.

Disconnect power before attempting any maintenance or cleaning to reduce the risk of

electric shock or damage to persons.

CIRCUIT BOARD REPLACEMENT

1. Open door by pulling the handles.

2. Remove the screw from the logset located in the center of the emberbed and remove the

logset from the unit

3. While holding the mirror to prevent it from moving, remove the 2 mirror retaining bracket

screws. Carefully remove the mirror and store in a safe place to prevent damage.

4. Remove the 3 screws securing rear reflector to the unit.

5. Locate the circuit board on the underside of the rear reflector bracket.

6. Remove wiring connections from circuit board noting their original locations.

7. From the underside of the circuit board, break off the 4 mounting studs by grasping with

pliers and twisting on the protruding part of the stud, push the remainder of the studs out

through the top panel.

8. NOTE: New mounting studs are supplied with the replacement circuit board

9. Reassemble in the reverse order as above.

Autres manuels pour EOS-2006

Table des matières

Autres manuels Dimplex Poêle

Dimplex

Dimplex Westcott Manuel utilisateur

Dimplex

Dimplex Delaware DWR20 Manuel utilisateur

Dimplex

Dimplex TDS8515T Manuel utilisateur

Dimplex

Dimplex Stockbridge SKG20BL Mode d’emploi

Dimplex

Dimplex Bayport BYP20 Mode d’emploi

Dimplex

Dimplex DS4411 Manuel utilisateur

Dimplex

Dimplex Langbrook LBK5 Manuel utilisateur

Dimplex

Dimplex CS33116A Manuel utilisateur

Dimplex

Dimplex Willowbrook WLL20-INT Manuel utilisateur

Dimplex

Dimplex DS2205 Manuel utilisateur

Dimplex

Dimplex STOCKBRIDGE SKG20BL Manuel utilisateur

Dimplex

Dimplex ELECTRALOG CS1205 Manuel utilisateur

Dimplex

Dimplex DMCS13R Manuel utilisateur

Dimplex

Dimplex Langbrook LBK5SE Manuel utilisateur

Dimplex

Dimplex DS4411 Manuel utilisateur

Dimplex

Dimplex DS5598 Manuel utilisateur

Dimplex

Dimplex MILANOef EDS7001F Guide de démarrage rapide

Dimplex

Dimplex ELECTRIC STOVE Manuel utilisateur

Dimplex

Dimplex Brayford BFD20 Manuel utilisateur

Dimplex

Dimplex Westcott 12kW Stove Manuel utilisateur

Dimplex

Dimplex Ritz Manuel utilisateur

Dimplex

Dimplex OPTIMYST RTOPSTV20 Manuel utilisateur

Dimplex

Dimplex ELECTRALOG CS3311 Guide de démarrage rapide

Dimplex

Dimplex COURCHEVEL CVL20E Mode d’emploi

Manuels Poêle populaires d'autres marques

Arada

Arada Cassette Stove Manuel utilisateur

Parmco

Parmco FS 600 Manuel utilisateur

MCZ

MCZ SUITE AIR 10 M2 Manuel utilisateur

HearthStone

HearthStone Stowe DV 8321 Guide de dépannage

Cattara

Cattara FAMILY Manuel utilisateur

Stanley

Stanley Argon F500 OVAL Manuel utilisateur

Avalon

Avalon B-VENT Manuel utilisateur

Nordpeis

Nordpeis Vega Manuel utilisateur

Exquisit

Exquisit EKC601-5 Manuel d'utilisation

Stanley

Stanley Oisin Oil MK II Manuel du propriétaire

Thermocet

Thermocet Brookfield S/CC Manuel utilisateur

HASE

HASE delhi Manuel utilisateur

Vermont Castings

Vermont Castings Intrepid 2 Manuel utilisateur

Italiana Camini

Italiana Camini CLASSICA Guide de démarrage rapide

Avalon

Avalon Vashon Avanti DVS FS Manuel utilisateur

Spartherm

Spartherm ambiente a1 Manuel utilisateur

Warmlite

Warmlite WL46040 Manuel utilisateur

Regency

Regency Ultimate U39E Series Guide de démarrage rapide