DHM PRO VORON 2.4 KIT 4 Manuel utilisateur
VORON 2.4
KIT 4
∙A / B DRIVE
WWW.VORONDESIGN.COM
INTRODUCTION
Before you begin on your journey, a word of caution.
In the comfort of your own home you are about to assemble a robot. This
machine can maim, burn, and electrocute you if you are not careful. Please
do not become the rst VORON fatality. There is no special Reddit air for that.
Please, read the entire manual before you start assembly. As you begin wrenching,
please check our Discord channels for any tips and questions that may halt your progress.
Most of all, good luck!
THE VORON TEAM
WWW.VORONDESIGN.COM
A/B DRIVES AND IDLERS
01
WWW.VORONDESIGN.COM
A Drive
B Drive
A Idler
B Idler
OVERVIEW
02
WWW.VORONDESIGN.COM
Heat Set Insert
M5 Nut
PREPARATION
03
WWW.VORONDESIGN.COM
M5x40 SHCS
ASSEMBLY AID
This bolt is used to align
components and will be
removed in a later step.
M5 Shim
F695 Bearing
A IDLER
04
WWW.VORONDESIGN.COM
REMOVE ASSEMBLY AID
Remove the bolt and slide the
tension arm into place.
M5x40 SHCS
A IDLER
05
WWW.VORONDESIGN.COM
M3x40 SHCS
M3 Washer
A IDLER
06
WWW.VORONDESIGN.COM
CHECK YOUR WORK
Compare your assembled parts
to the graphics shown here. Pay
attention to the features highlighted
by the circles.
A IDLER
07
WWW.VORONDESIGN.COM
M5x40 SHCS
ASSEMBLY AID
This bolt is used to align
components and will be
removed in a later step.
M5 Shim
F695 Bearing
B IDLER
08
Ce manuel convient aux modèles suivants
1
Autres manuels DHM PRO Imprimante 3D
