DeLonghi HFX30 Series Manuel utilisateur

RADIATEUR SOUFFLANT CÉRAMIQUE

Mode d’emploi . Conservez cette notice

Visitez www.delonghi.com pour y voir une liste des centres de répara-

tion proches de chez vous.

CARACTÉRISTIQUES ÉLECTRIQUES

120 V~ 60 Hz1500 W

INSTANT CERAMIC HEATER

Instructions for use. Keep these instructions

Visit www.delonghi.com for a list of service centers near you.

ELECTRIC CHARACTERISTICS

120 V~ 60 Hz1500 W

HFX30 Series

www.delonghi.com

5711413221_01_0517 Printed in China

IMPORTANT

SAFEGUARDS

When using any electrical appliance, some basic safety

precautions should always be observed to reduce the

risk of re, electric shock, and/or injury to persons. Read

all instructions carefully before using the appliance.

Specically:

Danger!

Failure to observe the warning may result in life threatening

injury by electric shock.

- The appliance must not be placed

immediately under a xed power

socket.

- Do not use the appliance outdoors.

- Do not operate any heater with

a damaged cord or plug or after

the heater malfunctions, has

been dropped or damaged in

any manner. Return heater

to authorized service facility

for examination, electrical or

mechanical adjustment, or

repair.

- This heater is not intended for use in

bathrooms, laundry areas and similar

indoor locations. Never locate heater

where it may fall into a bath tub or

other water container.

- If the power cable is damaged, stop

using the product. Power cable must

be replaced by the manufacturer, an

authorisedservicecentreoraqualied

electrician in order to eliminate all

risk.

- Do not use this heater in the

immediate surroundings of a bath, a

shower and sinks or a swimming pool.

- Do not insert or allow foreign objects

to enter any ventilation or exhaust

opening as this may cause an electric

shock, re, or damage the heater.

- CAUTION: to prevent electric

shock match wide blade of plug

to wide slot, then fully insert.

- CAUTION: In order to avoid a hazard

due to inadvertent resetting of

thermal cutout, this appliance must

not be supplied through an external

switching device, such as a timer, or

connected to a circuit that is regulary

switched on and o by the utility.

- If you intend to x your appliance to

the wall, make sure that the switch or

other control devices are not within

reachofpersons in thebathorshower.

Important!

Failure to observe the warning could result in injury or

damage to the appliance.

-The appliance is not intended for use

by persons (including children) with

reduced physical, sensory or mental

capabilities, or lack of experience

and knowledge, unless they have

been given supervision or instruction

concerning use of the appliance by a

person responsible for their safety.

Children should be supervised to

ensure that they do not play with the

appliance.

- CAUTION — Some parts of this

product can become very hot and

cause burns.

- Extreme caution is necessary when

any heater is used by or near children

and whenever the heater is left

operating and unattended.

- Always disconnect the plug from the

power outlet when the appliance is

not in use.

- Do not wrap the cord around the ap-

pliance immediately after use.

- Theinternalpartsof the appliance can

become very hot or produce sparks

during operation. Do not use the

appliance in areas where gasoline,

paints, or other ammable liquids are

used or stored.

- Use this heater only as described

in this manual. Any other use not

recommended by the manufacturer

may cause re, electric shock, or

injury to persons.

- To prevent overload and blown fuses,

be sure that no other appliance

is plugged into the same outlet

(receptacle) or into another outlet

(receptacle) wired into the same

circuit.

- Make sure that the plug is fully

inserted into the outlet.

Wall outlets may deteriorate with

time,sochecktheplugperiodicallyfor

signs of overheating or deformation.

If the outlet has deteriorated, stop

using it and have it repaired.

- Do not use the appliance in small

rooms when they are occupied by

persons that are not capable of

leaving the room, unless constant

supervision is provided.

Danger of burns!!

Failure to observe the warning could result in burns or

scalds.

- WARNING: To avoid

overheating, never under

any circumstances cover the

appliance during operation as this

would lead to a dangerous rise in

temperature, and risk of re.

- Do not use the appliance on soft

surfaces, such as beds, where the

openings may become blocked.

- This heater is hot when in use. To

prevent burns, do not let bare skin

touch hot surfaces. Use handle when

moving this heater. To prevent burns,

do not touch hot surfaces with bare

skin. Use the handle when moving

the appliance. Keep all ammable

materials, such as furniture, pillows,

bedding, paper, clothing, and curtains

at least 90 cm (3 feet) from the front

and top of the appliance also avoid

contact with the sides and back.

- Do not run cord under carpeting.

Do not cover cord with throw rugs,

runners, or the like. Arrange cord

away from trac area and where it

will not be tripped over.

- It is normal for the heater’s plug and

cord to feel warm to the touch. A plug

or cord which becomes hot tothe

touch or becomes distorted in shape

may be a result of a worn electrical

outlet. Worn outlets or receptacles

should be replaced prior to further use

of the heater. Plugging heater into a

worn outlet /receptacle/ may result in

overheating of the power cord or re.

- WARNING: Do not cover the appliance

while it is functioning in order to

avoid overheating which may cause

risk of re.

Symbol meaning

This simbol indicates:

(If provided) Class II equipment

Please note:

This symbol indicates recommendations and important

information for the user.

-If your appliance is equipped with a

polythene tape used as carry handle,

removeitbeforeconnectingappliance

to the outlet.

- Alwaysusetheapplianceinanupright

position.

- To disconnect heater, turn controls to

o, then remove plug from outlet.

- Connect to properly polarized outlets

only.

- This heater is not intended for use

with an extension cord or outlet

strip. Plug the cord directly into an

appropriate wall receptable.

- Check that neither the appliance nor

the power cable have been damaged

in any way during transportation.

- Makesurethatnopiecesofpolystyrene

or other packaging material have

been left on the appliance. It may be

necessary to pass over the appliance

with a vacuum cleaner.

- When switching on the appliance for

the rst time, allow it to run at full

power for at least two hours to get

rid of the unpleasant smell. Make sure

that the room in which the appliance

is located is well ventilated during

this operation. It is normal for the

appliance to emit small cracking

sounds when you turn it on.

- Do not use the appliance in rooms

with a oor area of less than 4mq (43

square feet).

- Before putting the appliance away,

make sure it is completely o and

unplugged from the mains socket.

Wrap the cable around the base.

Do not store in dusty atmospheres.

- Do not rest anything on the appliance.

- Do not obstruct the air intake and

outlet grilles (danger of overheating).

- Do not place the heater near a bed

because objects such as pillows or

blankets can fall o the bed and be

ignited by the heater.

(Certain models only)

A tip over safety

device turns the appliance o if it falls

over or is positioned inappropriately

in such a way as to jeopardise safety.

The appliance resumes operation

a few seconds after being placed

in an upright position again. See

troubleshooting session.

SAVE THESE

INSTRUCTIONS

THIS PRODUCT IS FOR HOUSEHOLD USE

ONLY

DESCRIPTION

A Thermostat

B Function selector

C Indicator light

DTip over switch (certain models only)

E Foldable support

USE

Installation

The appliance can be used on any horizontal surface.

Do not overload the electrical circuit. Avoid using the same

socket for other appliances.

Electrical connection

- Before plugging into the outlet, make sure the voltage

of your power supply corresponds to the value V indica-

ted on the appliance and that the socket and power line

are appropriate for the load required.

- THIS APPLIANCE COMPLIES WITH DIRECTIVE 2004/108/

EC ON ELECTROMAGNETIC COMPATIBILITY.

Functioning and use

Please note:

pull out the support outwards by placing

ngers in the slot (see gure on page 3). If the support isn’t

pulled out, the product will not stand up and fall down.

Always operate the heater in upright position only.

Any other position could create a hazardous situation.

1. Plug the appliance into the outlet.

2. Turn the thermostat dial to maximum.

3. Summer mode (fan only): turn the function selector to

the position (the indicator light will go on).

4. Low power operation: turn the function selector to posi-

tion 1(the indicator light will go on).

5. High power operation: turn the function selector to po-

sition 2(the indicator light will go on).

6. Switching o: turn the function selector to the“0”posi-

tion (the indicator light will go o).

Setting the thermostat

Position the thermostat on maximum.

When the room has reached the required temperature, turn

the thermostat dial slowly counterclockwise until you hear a

click and the fan goes o (the indicator light stays on). The

thermostat will then keep room temperature at the selected

level automatically.

Frost prevention mode

With the function selector in position 2and the thermostat

dial in position , the appliance maintains room tempera-

ture at about

5°C

(41°F)

, preventing freezing with minimal

energy consumption (the indicator light will stay on).

MAINTENANCE

- Always unplug from the outlet before cleaning.

- Clean the air intake and outlet grilles regularly.

- Do not use abrasive products or solvents to clean the

appliance.

SAFETY FUNCTIONS

-Safety device: the appliance is tted with a safety

device that switches it o in the event of accidental

overheating (e.g. obstruction of air intake and outlet

grilles, motor turning slowly or not at all).

To reset, unplug the appliance from the outlet for a few

minutes, remove the cause of overheating, then plug in

again. If the appliance doesn’t work please contact the

De’Longhi Customer Service.

- Tip-over safety device: certain models are tted

with a tip-over switch (D) which turns the appliance o

if it falls over. To restart the appliance, simply place it

upright again.

PROBLEM CAUSE SOLUTION

The appliance doesn’t work Be sure it is plugged in and that the

electrical outlet is working.

Check for any obstruction.

The function selector is in the ”0” po-

sition.

The thermostat may be set too low.

Plug into the outlet.

Remove the obstruction, unplug the

heater and let the appliance cool down.

If the appliance doesn't work please

contact the De longhi toll free number.

Turn the function selector to the position

or“1”or ”2”.

Turn the thermostat clockwise to a higher

setting until the heater restarts.

The tip-over switch has been activated

(certain models only).

Make sure the appliance is standing

upright on a at surface, if the problem

persists contact our toll free number to

assist you.

TROUBLESHOOTING

Autres manuels pour HFX30 Series

Table des matières

Autres manuels DeLonghi Chauffage

DeLonghi

DeLonghi TCH 8993ER.BC Manuel utilisateur

DeLonghi

DeLonghi HVF3555TB Manuel utilisateur

DeLonghi

DeLonghi EW7707CB Manuel utilisateur

DeLonghi

DeLonghi HOR KH770715CB Manuel utilisateur

DeLonghi

DeLonghi EW 7707CM Manuel d'instructions d'installation

DeLonghi

DeLonghi Horizontal HTC 4030 Manuel utilisateur

DeLonghi

DeLonghi HBC3052T Manuel utilisateur

DeLonghi

DeLonghi TRD40820 Manuel utilisateur

DeLonghi

DeLonghi DR 18TTW Manuel utilisateur

DeLonghi

DeLonghi ECLIPSE SDH2000 Manuel utilisateur

DeLonghi

DeLonghi HOR KH770920 Manuel utilisateur

DeLonghi

DeLonghi TCH7915ER Manuel utilisateur

DeLonghi

DeLonghi HMP1500 Manuel d'instructions d'installation

DeLonghi

DeLonghi DCH4530 Manuel utilisateur

DeLonghi

DeLonghi HFS50D15 Manuel utilisateur

DeLonghi

DeLonghi TRRSE Series Manuel utilisateur

DeLonghi

DeLonghi HVF3031 Manuel du système

DeLonghi

DeLonghi HFS70B Manuel utilisateur

DeLonghi

DeLonghi OIL FILLED RADIATORS Manuel utilisateur

DeLonghi

DeLonghi HSX2320 Series Manuel utilisateur

DeLonghi

DeLonghi DRAGON 4 Manuel utilisateur

DeLonghi

DeLonghi DCH 4590 ER Manuel utilisateur

DeLonghi

DeLonghi Electric radiator Manuel d'instructions d'installation

DeLonghi

DeLonghi EW7507EBM Manuel utilisateur

Manuels Chauffage populaires d'autres marques

oventrop

oventrop Regucor Series Manuel utilisateur

Blaze King

Blaze King CLARITY CL2118.IPI.1 Manuel utilisateur

ELMEKO

ELMEKO ML 150 Manuel utilisateur

BN Thermic

BN Thermic 830T Manuel utilisateur

KING

KING K Series Mode d’emploi

Empire Comfort Systems

Empire Comfort Systems RH-50-5 Guide de démarrage rapide

Well Straler

Well Straler RC-16B Manuel utilisateur

EUROM

EUROM 333299 Manuel utilisateur

Heylo

Heylo K 170 Manuel utilisateur

Eterna

Eterna TR70W Manuel utilisateur

Clarke

Clarke GRH15 Mode d’emploi

IRSAP

IRSAP The Radiator Company Ovali Manuel utilisateur

Empire Heating Systems

Empire Heating Systems WCC65 Manuel utilisateur

Wetekom

Wetekom 92 86 43 Manuel utilisateur

Desa

Desa SPC170-F Manuel utilisateur

Watlow

Watlow Watrod Electric Tubular Heaters Manuel utilisateur

Haverland

Haverland ECO-DRY GPS Series Manuel de la liste des pièces

Stelpro

Stelpro ASILVC2060 Series Manuel utilisateur