Dell 8 Manuel utilisateur

Dell FC8PT

Pass-Through Module

Quick Start Guide

Guía Rápido de Inicialización

Guide rapide de démarrage

Schnellanleitung

Guia de Início Rápido

빠른 시작 가이드

快速入门指南

快速入門指引

クイックスタートガイド

Краткое руководство по установке

Instrukcja skrócona i instrukcja obsługi

Stručný návod

Οδηγός γρήγορης εκκίνησης

Panduan Cepat Memulai

HızlıBaşlangıç Kılavuzu

Regulatory Model: FC8PT

Regulatory Type: FC8PT

Dell FC8PT

Pass-Through Module

Quick Start Guide

Regulatory Model: FC8PT

Regulatory Type: FC8PT

Notes, Cautions, and Warnings

NOTE: A NOTE indicates important information that helps you make better use of

your computer.

CAUTION: A CAUTION indicates potential damage to hardware or loss of data if

instructions are not followed.

WARNING: A WARNING indicates a potential for property damage, personal

injury, or death.

____________________

Information in this publication is subject to change without notice.

Reproduction of these materials in any manner whatsoever without the written permission of Dell Inc.

is strictly forbidden.

Trademarks used in this text: Dell™ and the DELL logo are trademarks of Dell Inc. Emulex®is a

registered trademark of Emulex. QLogic®is a registered trademark of QLogic Corporation.

Other trademarks and trade names may be used in this publication to refer to either the entities claiming

the marks and names or their products. Dell Inc. disclaims any proprietary interest in trademarks and trade

names other than its own.

Regulatory Model: FC8PT

Regulatory Type: FC8PT

March 2011 P/N VFNH3 Rev. A01

P006304-01A Rev. A

FC8PT Pass-Through Module 5

1. Install the Pass-Through Module

NOTE: Computer equipment contains static-sensitive components that may be

damaged during handling. Static precautions such as grounded wrist straps are

recommended during the installation process.

Remove the pin cover from the connector pins at the back of the pass-

through module, as shown in Figure 1-1, Removing the Pin Cover.

Figure 1-1. Removing the Pin Cover

Locate an empty module bay in the server.

If the selected bay contains an I/O module blank, remove it.

Make sure that the latching arm is in the unlatched position, and slide the

pass-through module into the bay until it stops.

6FC8PT Pass-Through Module

Figure 1-2. Installing the Pass-Through Module

Rotate the latching arm upward until it is flush against the front panel,

and the top of the arm is seated in the latch, as shown in Figure 1-2,

Installing the Pass-Through Module.

2. Attach a Fiber Optic Cable

(Optional)

Install a fiber optic cable between the pass-through module and the target

device. With short-wave lasers, use multimode fiber optic cable that adheres

to the following specifications.

Fiber Optic Cable Maximum Length Minimum

Length

Connector

62.5/125 μm (multimode) 200

MHz*km bandwidth cable

150 meters at 2.125 Gb/s

70 meters at 4.25 Gb/s

21 meters at 8.5 Gb/s

.5 meters LC

FC8PT Pass-Through Module 7

Connect the fiber optic cables to the LC connectors on the pass-through

module.

Connect the other end of the cable to the target Fibre Channel device.

3. View Status LEDs

The pass-through module contains several light-

emitting diodes (LEDs). Each port includes a pair of

LEDs (one green and one yellow) that indicate the

status of the ports on the SFP. Power-on self test

(POST) conditions and results are summarized in

Tables 1-1 and 1-2. In addition, at the bottom of the

pass-through module faceplate is an additional pair

of LEDs (one blue and one green) that provide the

status of the pass-through module. Pass-through

module status LEDs are shown in Table 1-3, Pass-

Through Module Status LEDs.

NOTE: For the link rate conditions, there is a one

second pause when the LED is off between each

group of fast blinks (2, 3, or 4). You should observe the LED sequence for several

seconds to ensure that the pause is correctly identified.

50/125 μm (multimode) 500

MHz*km bandwidth cable

300 meters at 2.125 Gb/s

150 meters at 4.25 Gb/s

50 meters at 8.5 Gb/S

.5 meters LC

Table 1-1. Port Status LED – Emulex

Yellow LED Green LED State

Off Off Wake-up failure (dead board)

On Off POST failure (dead board)

Slow blink Off Wake-up failure monitor

Fast blink Off POST failure

Flashing Off POST processing in progress

Off On Failure while functioning

Fiber Optic Cable Maximum Length Minimum

Length

Connector

8FC8PT Pass-Through Module

On On Failure while functioning

2 fast blinks On 2-Gb link rate – normal link up

3 fast blinks On 4-Gb link rate – normal link up

4 fast blinks On 8-Gb link rate – normal link up

Off Slow blink Normal link down or not started

Slow blink Slow blink Off-line for download

Fast blink Slow blink Restricted off-line mode (waiting for restart)

Flashing Slow blink Restricted off-line mode (test active)

Table 1-2. Port Status LED – QLogic

Yellow LED Green LED State

Off Off Power off

On On Power on (before firmware initialization)

Flash Flash Firmware fault

Off On Link up

Off Flash Activity

Flash Off Beacon

Table 1-3. Pass-Through Module Status LEDs

Green LED Yellow/Blue LED State

Off Off The pass-through module is powered off or

an error condition exists

On On (blue) The pass-through module is healthy

On Blinking (yellow) Pass-through module fault

On Off Booting up

On Blinking (blue) Chassis Management Controller identifies

pass-through module

Table 1-1. Port Status LED – Emulex (continued)

Yellow LED Green LED State

FC8PT Pass-Through Module 9

4. Install Drivers

There are no drivers, firmware, or boot code for this device. Utility software, if

applicable, is located in the Technical Support section of the Dell website

(www.dell.com).

5. Having Problems?

Notwithstanding language to the contrary in any other Dell documentation

or on any Dell website, the limited warranty applicable to Dell branded

products described in the Product Information Guide and/or on the local

country Dell website shall apply to the FC8PT Pass-Through Module.

6. Laser Safety

Install only CDRH Certified Class 1 Laser Devices.

Dell FC8PT

Pass-Through Module

Guía Rápido de Inicialización

Model de reglamentación: FC8PT

Tipo de reglamentación: FC8PT

Autres manuels pour 8

Ce manuel convient aux modèles suivants

Table des matières

Langues :

Autres manuels Dell Matériel informatique

Dell

Dell Embedded Box PC5000 Manuel utilisateur

Dell

Dell Dimension 4600 Series Manuel utilisateur

Dell

Dell Latitude E4200 Manuel utilisateur

Dell

Dell PowerEdge systems 6300 Manuel de service

Dell

Dell Embedded Box PC 5000 Manuel utilisateur

Dell

Dell Streak 5 Manuel utilisateur

Dell

Dell PowerEdge 2600 Manuel utilisateur

Dell

Dell PowerConnect W-7200 Series Manuel utilisateur

Dell

Dell ADVANCED PORT REPLICATOR Manuel utilisateur

Dell

Dell Precision FX100 Manuel du propriétaire

Dell

Dell Precision R5500 Manuel utilisateur

Dell

Dell PowerEdge 1650 Manuel utilisateur

Dell

Dell Mellanox ConnectX-3 Manuel utilisateur

Dell

Dell POWEREDGE RAID H700 Manuel utilisateur

Dell

Dell PowerEdge 2600 Manuel utilisateur

Dell

Dell PowerEdge 1650 Manuel utilisateur

Dell

Dell PowerEdge 1650 Manuel utilisateur

Dell

Dell OptiPlex XE4 Small Form Factor Manuel utilisateur

Dell

Dell PowerEdge 800 Manuel utilisateur

Dell

Dell PowerVault 770N Manuel technique

Dell

Dell poweredge VRTX Manuel utilisateur

Dell

Dell Micro-USB dongle Manuel utilisateur

Dell

Dell PowerEdge R310 Manuel de la liste des pièces

Dell

Dell HBA355i Manuel utilisateur

Manuels Matériel informatique populaires d'autres marques

EMC2

EMC2 VNX Series Manuel du propriétaire

Panasonic

Panasonic DV0PM20105 Manuel utilisateur

Mitsubishi Electric

Mitsubishi Electric Q81BD-J61BT11 Manuel utilisateur

Gigabyte

Gigabyte B660M DS3H AX DDR4 Manuel utilisateur

Raidon

Raidon iT2300 Manuel utilisateur

National Instruments

National Instruments PXI-8186 Manuel utilisateur

Hauppauge

Hauppauge WinTV-HVR-2250 Manuel utilisateur

Kontron

Kontron CP6002 Manuel utilisateur

Manhattan

Manhattan 702843 Manuel utilisateur

Aphex

Aphex 230 Manuel utilisateur

AMD

AMD Phenom II Manuel d'exploitation

Intel

Intel NUC 12 Pro Manuel utilisateur

dbx

dbx Zone Pro 1260 Manuel utilisateur

Galaxy

Galaxy GHDX2-2430S-24F4D Manuel utilisateur

Intel

Intel AXXRMFBU4 Manuel utilisateur

Kontron

Kontron DIMM-PC/MD Manuel utilisateur

ST X-NUCLEO-SAFEA1B Mode d'emploi

STEINWAY LYNGDORF

STEINWAY LYNGDORF SP-1 Manuel utilisateur