Data Video DAC-2 Fiche technique

DAC-2 Quick Setup with Adobe Premiere 6.5 on Windows

This setup guide will cover four specific areas:

A. Explanation of front panel functions

B. Verify which EPROM is in the DAC-2

C. Preview Monitor Connections

D. Initial Software configuration

A. Explanation of front panel functions

Button Functions

DV Input

Select/Reset The DV Button, has two functions:

It selects DV as the input source and is also a reset.

Resetting the DAC-2 will put it into its default setting based on its Firmware version.

Composite

Video, S-

Video, Y.U.V.

This button is for analog input source selection: Composite video (RCA), S-Video

(Y/C), and Y.U.V. (Component)

12/16 bit

Audio/Mode

Selection

The A Encode button has two important functions; it selects the encoding audio

frequency between 12 bit (32 KHz) or 16 bit (48 KHz) and if it is held down for 3

seconds it switches modes.

B. Verify which EPROM is in the DAC-2.

On the underside of the DAC-2 there is a serial number sticker, which has a version number on it, the version

number is stamped or on a sticker.

Please find your version number in the table below:

1. Datavideo NTSC DAC-2 Firmware Table

Firmware Version Preset / Default Mode Details

4.7 Mac/Windows XP Preset Mac/Windows XP

4.8 Windows 2000 Refer to 4.8/5.2 Instructions

5.2 Windows 2000 Refer to 4.8/5.2 Instructions

5.3 or Higher Mac/Windows XP Preset Mac/Windows XP

If you want a different chip contact Datavideo USA, (562) 696-2324, [email protected].

2. Versions 4.8/5.2 Instructions

Mode 1 (Power Up Mode) Windows 2000.

Mode 2 MACs (running OS X) or Windows XP computers.

Mode 3 General setting for other DV devices (Cameras, etc.)

Mac Users: Disconnect your FireWire connection before changing modes or your Mac

computer will lock up.

To change modes please do the following:

To go to mode 2, press and hold the encode button for 3 seconds and release. The 12

bit and 16 bit encode LED's will alternate as a confirmation.

To go to mode 3 press and hold the encode button again for 3 seconds and release.

The CV and S/YUV LED's will alternate as a confirmation.

If the encode button is pressed and held again the DAC-2 will go back Mode 1”. It is confirmed

by the 12 bit and 16 bit encode LED's staying lit for 2 seconds.

Sometimes one power supply can get confused with another. The DAC-2 uses a 9 VDC 1200mA,

AC adaptor. Using the wrong power supply can cause the DAC-2 to become unstable or not power on.

C. Preview Monitor Connections

If you would like to monitor your video, a composite video cable can be used to connect a

video monitor. Connect a composite RCA cable from the rear of the DAC-2 and connect the

opposite end to the input of your monitor.

Note: S-video cables only carry a video signal, so you will need to connect your RCA audio

cables to the converter to capture sound.

D. Initial Software configuration

Adobe Premiere 6.5 in Windows (Windows XP Screen shots are shown for reference only)

Autres manuels pour DAC-2

2

Table des matières

Autres manuels Data Video Moniteur

Data Video

Data Video TLM-170KR Manuel utilisateur

Data Video

Data Video TLM-700K Manuel utilisateur

Data Video

Data Video TLM-702HD Manuel utilisateur

Data Video

Data Video TLM-170F Manuel utilisateur

Data Video

Data Video TLM-702HD Manuel utilisateur

Data Video

Data Video TLM-70D Manuel

Data Video

Data Video TLM-170G Manuel utilisateur

Data Video

Data Video TLM-350 Manuel utilisateur

Data Video

Data Video TLM-434H Manuel utilisateur

Data Video

Data Video TLM-700HD Manuel utilisateur

Data Video

Data Video TLM-170G Manuel utilisateur

Data Video

Data Video TLM-404H Manuel utilisateur

Data Video

Data Video TLM-700HD Manuel utilisateur

Data Video

Data Video TLM-404 Manuel

Data Video

Data Video TLM-170H Manuel utilisateur

Data Video

Data Video TLM 170 Manuel utilisateur

Data Video

Data Video TLM-404H Manuel utilisateur

Data Video

Data Video TLM-102 Manuel utilisateur

Data Video

Data Video SE-1000 Manuel

Data Video

Data Video TLM-170L Manuel utilisateur

Data Video

Data Video TLM-170K Manuel utilisateur

Data Video

Data Video TLM-700HD Manuel utilisateur

Data Video

Data Video TLM-170LM Manuel utilisateur

Data Video

Data Video SE-800 Guide de démarrage rapide

Manuels Moniteur populaires d'autres marques

Linear Acoustic

Linear Acoustic LQ-1000 Manuel utilisateur

AOC

AOC I2579V Manuel utilisateur

Gateway

Gateway FPD1520 Manuel utilisateur

Furuno

Furuno Mu 120c Manuel utilisateur

Asus

Asus VB171D - 17" LCD Monitor Manuel utilisateur

Dell

Dell S2230MX Instructions d'utilisation

Philips

Philips 107C64 Manuel utilisateur

Dell

Dell S2409WFP Manuel utilisateur

EverFocus

EverFocus EN-7517E Manuel utilisateur

Panasonic

Panasonic TH152UX1 - 152" PLASMA TV Manuel utilisateur

Dell

Dell Precision 7680 Mode d’emploi

LG

LG 50PM1M - - 50" Plasma Panel Manuel utilisateur

Bosch

Bosch DDU 9 Manuel utilisateur

Acer

Acer A231HL Manuel utilisateur

Philips

Philips 86BDL4152T Manuel utilisateur

NEC

NEC AccuSync LCD5V Manuel utilisateur

Emay

Emay SleepO2 Manuel utilisateur

IBM

IBM 6360 Instructions d'installation