Danfoss DEVIreg 330 Manuel utilisateur
DEVIreg™ 330 (-10 to +10°C)
3Installation Guide
1 Introduction
DEVIreg™ 330 is an electronic thermostat to be installed in
electric cabinets with DIN rail attachment. Used primarily for
controlling a lower temperature range as by frost protection.
The thermostat must be installed via an all-pole disconnection
switch. Either a wire sensor or an external air sensor must be
used to measure and control the desired temperature.
The thermostat has a button to adjust the temperature set-
ting, with a scale from -10° to +10°C. An LED indicator shows
standby periods (green light) and heating periods (red light).
More information on this product can also be found at:
devireg.devi.com
1 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
1.1 Technical Specications . . . . . . . . . . . . . . . . . . . . 4
1.2 Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . 5
2 Mounting Instructions . . . . . . . . . . . . . . . . . . . . . . . . 6
3 Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
4 Disposal Instruction . . . . . . . . . . . . . . . . . . . . . . . . . 10
Table of Contents
DEVIreg™ 330 (-10 to +10°C)
Installation Guide4
1.1 Technical Specications
Operation voltage 220-240 V~, 50 Hz
Standby power consumption Max 0,25 W
Relay:
Resistive load
Inductive load
Max 16 A / 3680 W @ 230 V
cos φ= 0,3 max1A
Sensing units NTC 15 kOhm at 25 °C
Sensing values:
0 °C
25 °C
50 °C
42 kOhm
15 kOhm
6 kOhm
Hysteresis ± 0,2 °C
Ambient temperature 10 °C to +50 °C
Lowering in economy periods -5 °C
Temperature range -10 °C to +10 °C
Cable specication max 1x4 mm2or 2x2,5 mm2
Ball pressure temperature 75 °C
Pollution degree 2 (domestic use)
Type 1C
Storage temperature -20 °C to +65 °C
IP class 20
DEVIreg™ 330 (-10 to +10°C)
5Installation Guide
Protection class Class II -
Dimensions 86 x 36 x 58 mm
Weight 83 g
The product complies with the EN/IEC Standard“Automatic
electrical controls for household and similar use”:
• EN/IEC 60730-1 (general)
• EN/IEC 60730-2-9 (thermostat)
1.2 Safety Instructions
Make sure the mains supply to the thermostat is turned o
before installation.
Please also note the following:
• The installation of the thermostat must be done by an
authorized and qualied installer according to local
regulations.
• The thermostat must be connected to a power supply
via an all-pole disconnection switch.
• The sensor is to be considered as live voltage. Have this
in mind if the sensor must be extended.
• Always connect the thermostat to continuous power
supply.
• Do not expose the thermostat to moisture, water, dust,
and excessive heat.
DEVIreg™ 330 (-10 to +10°C)
Installation Guide6
2 Mounting Instructions
Please observe the following placement guidelines:
• Install the thermostat in an electric cabinet with DIN
rail attachment or a separate DIN attachment accord-
ing to local regulation on IP classes.
• Do not place the thermostat in a way that it will be
exposed to direct sunlight.
Follow the steps below to mount the thermostat:
1. Click the thermostat on to the DIN rail attachment.
2. Connect the thermostat according to the connection
diagram.
-10°C to
+10°C
DEVIreg™ 330 (-10 to +10°C)
7Installation Guide
N
L
PE
The screen of the heating cable must be connected
to the earth conductor of the power supply cable by
using a separate connector.
Note: When you use the wire sensor for oor heating,
always install the sensor in a conduit.
3. Turn on the power supply.
DEVIreg™ 330 (-10 to +10°C)
Installation Guide8
3 Warranty
A 2-year product warranty is valid for:
• thermostats: DEVIreg™ 330 (-10 °С to +10 °C).
Should you, against all expectations, experience a problem with your DEVI product,
you will nd that Danfoss oers DEVIwarranty valid from the date of purchase on
the following conditions: During the warranty period Danfoss shall oer a new com-
parable product or repair the product if the product is found to be faulty by reason
of defective design, materials or workmanship.The repair or replacement.
The decision to either repair or replace will be solely at the discretion of Danfoss.
Danfoss shall not be liable for any consequential or incidental damages including,
but not limited to, damages to property or extra utility expenses. No extension of the
warranty period following repairs undertaken is granted.
The warranty shall be valid only if the WARRANTY CERTIFICATE is completed
correctly and in accordance with the instructions, the fault is submitted to the
installer or the seller without undue delay and proof of purchase is provided. Please
note that the WARRANTY CERTIFICATE must be lled in, stamped and signed by the
authorized installer performing the installation (Installation date must be indicated).
After the installation is performed, store and keep the WARRANTY CERTIFICATE and
purchase documents (invoice, receipt or similar) during the whole warranty period.
DEVIwarranty shall not cover any damage caused by incorrect conditions of use,
incorrect installation or if installation has been carried out by non-authorized electri-
cians. All work will be invoiced in full if Danfoss is required to inspect or repair faults
that have arisen as a result of any of the above. The DEVIwarranty shall not extend to
products which have not been paid in full. Danfoss will, at all times, provide a rapid
and eective response to all complaints and inquiries from our customers.
The warranty explicitly excludes all claims exceeding the above conditions.
For full warranty text visit www.devi.com.
devi.danfoss.com/en/warranty/
DEVIreg™ 330 (-10 to +10°C)
9Installation Guide
WARRANTY CERTIFICATE
The DEVIwarranty is granted to:
Address Stamp
Purchase date
Serial number of the product
Product Art. No.
*Connected output [W]
Installation Date
& Signature
Connection Date
& Signature
*Not mandatory
DEVIreg™ 330 (-10 to +10°C)
Installation Guide10
4 Disposal Instruction
Autres manuels pour DEVIreg 330
1
Ce manuel convient aux modèles suivants
1
Table des matières
Autres manuels Danfoss Thermostat
Danfoss
Danfoss TP5001 series Manuel utilisateur
Danfoss
Danfoss ECtemp 330 Manuel utilisateur
Danfoss
Danfoss MBC 8000 Manuel utilisateur
Danfoss
Danfoss ECtemp 550 Manuel utilisateur
Danfoss
Danfoss DEVIreg Room 140F1161 Manuel utilisateur
Danfoss
Danfoss RT1 Instructions de montage
Danfoss
Danfoss DEVIreg Opti Manuel utilisateur
Danfoss
Danfoss ECtemp Next Plus Manuel utilisateur
Danfoss
Danfoss Devireg 535 Instructions d'utilisation
Danfoss
Danfoss ECtemp Touch Manuel utilisateur
Danfoss
Danfoss WP75-RF Manuel utilisateur
Danfoss
Danfoss TS715Si Manuel utilisateur
Danfoss
Danfoss Eco Manuel utilisateur
Danfoss
Danfoss ECtemp Next Plus HW Manuel utilisateur
Danfoss
Danfoss 088L5130 Manuel utilisateur
Danfoss
Danfoss Icon Master Manuel utilisateur
Danfoss
Danfoss KP Series Manuel utilisateur
Danfoss
Danfoss Icon Master Manuel utilisateur
Danfoss
Danfoss 088L5130 Manuel utilisateur
Danfoss
Danfoss DBR Manuel utilisateur
Manuels Thermostat populaires d'autres marques
EWELLY
EWELLY EW-181 Manuel utilisateur
Prolon
Prolon T1100 Instructions d'installation
Computherm
Computherm Q20 Manuel utilisateur
Heatmiser
Heatmiser neoStat Manuel utilisateur
Aube Technologies
Aube Technologies TH111GFCI-NP 240 VCA Manuel utilisateur
Mars
Mars HEAT CONTROLLER IR Wireless Thermostat Manuel utilisateur
