Danfoss DEVIreg 316 Manuel utilisateur

www.DEVI.com

Installation Guide

DEVIreg™ 316

Electronic Thermostat

The English language is used for the original instructions.

Other languages are a translation of the original instructions.

(Directive 2006/42/EC)

DEVIreg™ 316

3Installation Guide

1 Introduction

DEVIreg™ 316 is an electronic thermostat to be installed in

electric cabinets with DIN rail attachment. The thermostat

must be installed via an all-pole disconnection switch.

DEVIreg™ 316 applies to the control of room temperature,

oor temperature, ventilation, cooling or to the control of

snow melting in gutters and similar installations.

For measuring purposes either a wire sensor or an external

air sensor is used.

Table of Contents

1 Introduction . . . . . . . . . . . . . . . . . . . . . 3

1.1 Technical Specications . . . . . . . . . . . 4

1.2 Safety Instructions . . . . . . . . . . . . . . . 5

2 Mounting Instructions . . . . . . . . . . . . . . . 6

3 Settings . . . . . . . . . . . . . . . . . . . . . . . . 7

3.1 Hysteresis . . . . . . . . . . . . . . . . . . . . 7

3.2 Minimum Temperature Limiter . . . . . . . 8

3.3 Temperature Set-back . . . . . . . . . . . . 9

4 Warranty. . . . . . . . . . . . . . . . . . . . . . . 10

5 Disposal Instruction . . . . . . . . . . . . . . . 13

DEVIreg™ 316

Installation Guide4

The thermostat has a button to adjust the temperature

setting with a scale from -10°C to +50°C . An LED indicator

shows standby periods and heating periods (red light).

More information on this product can also be found at:

devireg.devi.com.

1.1 Technical Specications

Operation voltage 220 - 240V~, 50Hz

Standby power consumption Max 0.25W

Relay:

Resistive load

Inductive load

Max 16A / 3680W @ 230V

cos φ= 0.3 max 1A

Sensing units NTC 15 kOhm at 25 °C

Sensing values:

0 °C

25 °C

50 °C

42 kOhm

15 kOhm

6 kOhm

Hysteresis 0 ° to 6 °C

Ambient temperature -10 °C to +45 °C

Lowering in economy periods 0 ° to 8 °C

Temperature range -10 ° to +50 °C

Minimum temperature range -10 °C to +5 °C

Cable specication max 1 x 4 mm or 2 x 2,5 mm

Ball pressure temperature 75 °C

DEVIreg™ 316

5Installation Guide

Pollution degree 2 (domestic use)

Type 1B

Storage temperature -20 °C to +65 °C

IP class 30

Protection class Class II -

Dimensions 86 x 36 x 58 mm

Weight 180 g

The product complies with the EN/IEC Standard“Automatic

electrical controls for household and similar use”:

• EN/IEC 60730-1 (general)

• EN/IEC 60730-2-9 (thermostat)

1.2 Safety Instructions

Make sure the mains supply to the thermostat is turned o

before installation.

IMPORTANT: When the thermostat is used to control a

oor heating element in connection with a wooden oor or

similar material, always use a oor sensor and never set the

maximum oor temperature to more than 35°C.

Please also note the following:

• The installation of the thermostat must be done by an

authorized and qualied installer according to local

regulations.

DEVIreg™ 316

Installation Guide6

• The thermostat must be connected to a power supply

via an all-pole disconnection switch.

• Always connect the thermostat to continuous power

supply.

• Do not expose the thermostat to moisture, water,

dust, and excessive heat.

2 Mounting Instructions

Please observe the following placement guidelines:

• Install the thermostat in an electric cabinet with DIN

rail attachment or a separate DIN attachment accord-

ing to local regulation on IP classes.

• Do not place the thermostat in a way that it will be

exposed to direct sunlight.

Follow the steps below to mount the thermostat:

1. Click the thermostat on to the DIN rail attachment.

2. Connect the thermostat according to the connection

diagram.

IP20

-10T50 D316

121110987

654321 N

Mains

220-240V~

250V~

16 (1) A

SensorMin.

Danfoss A/S

Ulvehavevej 61

7100 Vejle

Denmark

DEVIreg™ 316

7Installation Guide

The screen of the heating cable must be connected to

the earth conductor of the power supply cable by

using a separate connector.

Note: When you use the wire sensor for oor heating,

always install the sensor in a conduit.

3. Turn on the power supply.

Protective separation

The thermostat is designed so that the sensor circuit is gal-

vanically separated from the high voltage part which means

that the sensor part is regarded as a low voltage part.

3 Settings

Night set-back

Minimum tempera-

ture limiter

Hysteresis

3.1 Hysteresis

When the thermostat is used to apply with either heating

systems or refrigerating systems, and the requested

DEVIreg™ 316

Installation Guide8

temperature is between -10°C to +50°C, then it is recom-

mendable also to adjust the hysteresis (C) according to the

requested regulating range.

As an example if the temperature is set at 18°C and the

hysteresis at 3°C the thermostat will switch on at 18°C and

o at 21°C.

For controlling of room temperature the Hysteresis is rec-

ommended to the set point of 1°C.

3.2 Minimum Temperature Limiter

When the thermostat is used in connection with snow and

ice melting systems, it is recommendable also to use and

adjust the minimum temperature limiter (B) which ensures

both an upper and lower temperature range in between

which the thermostat allows the system to heat.

The requested maximum temperature range has to be

between -10°C to +50°C and the requested minimum tem-

perature range has to be between -10°C to +5°C.

An link between terminal 9+10 must be connected to acti-

vate the use of the minimum temperature feature when the

thermostat controls snow and ice melting in gutters, valley

gutters and down pipes, where the waste of unnecessary

energy must be avoided. In particular by extremely cold

weather where owing water or moisture does not occur.

DEVIreg™ 316

9Installation Guide

When the temperature drops below the minimum tem-

perature set value, the thermostat stops heating and the

LED indicator turns yellow.

When the temperature exceeds the maximum temperature

setting, the thermostat stops heating and both the indica-

tor for minimum and maximum temperature disappears.

3.3 Temperature Set-back

By connecting an external timer to terminals 4 and 6, the

thermostat can be set to reduce the temperature by 0°C to

8°C (A).

DEVIreg™ 316

Installation Guide10

4 Warranty

A 2-year product warranty is valid for:

• thermostats: DEVIreg™ 316.

Should you, against all expectations, experience a problem with your DEVI product,

you will nd that Danfoss oers DEVIwarranty valid from the date of purchase on

the following conditions: During the warranty period Danfoss shall oer a new com-

parable product or repair the product if the product is found to be faulty by reason

of defective design, materials or workmanship.The repair or replacement.

The decision to either repair or replace will be solely at the discretion of Danfoss.

Danfoss shall not be liable for any consequential or incidental damages including,

but not limited to, damages to property or extra utility expenses. No extension of the

warranty period following repairs undertaken is granted.

The warranty shall be valid only if the WARRANTY CERTIFICATE is completed

correctly and in accordance with the instructions, the fault is submitted to the

installer or the seller without undue delay and proof of purchase is provided. Please

note that the WARRANTY CERTIFICATE must be lled in, stamped and signed by the

authorized installer performing the installation (Installation date must be indicated).

After the installation is performed, store and keep the WARRANTY CERTIFICATE and

purchase documents (invoice, receipt or similar) during the whole warranty period.

DEVIwarranty shall not cover any damage caused by incorrect conditions of use,

incorrect installation or if installation has been carried out by non-authorized electri-

cians. All work will be invoiced in full if Danfoss is required to inspect or repair faults

that have arisen as a result of any of the above.The DEVIwarranty shall not extend to

products which have not been paid in full. Danfoss will, at all times, provide a rapid

and eective response to all complaints and inquiries from our customers.

The warranty explicitly excludes all claims exceeding the above conditions.

For full warranty text visit www.devi.com.

devi.danfoss.com/en/warranty/

Table des matières

Autres manuels Danfoss Thermostat

Danfoss

Danfoss RA 2000 valve Manuel utilisateur

Danfoss

Danfoss KP Series Manuel utilisateur

Danfoss

Danfoss REP24 Manuel utilisateur

Danfoss

Danfoss GreenCon RC-T2 Manuel utilisateur

Danfoss

Danfoss Icon Master Manuel utilisateur

Danfoss

Danfoss Icon Master Manuel utilisateur

Danfoss

Danfoss BasicPlus2 WT-DM Manuel utilisateur

Danfoss

Danfoss TP5E Manuel utilisateur

Danfoss

Danfoss 088U0210 Manuel utilisateur

Danfoss

Danfoss RTW-RA Manuel utilisateur

Danfoss

Danfoss DEVI DEVIreg 532 Manuel utilisateur

Danfoss

Danfoss TS715 Si Instructions de montage

Danfoss

Danfoss REPI Series Manuel utilisateur

Danfoss

Danfoss FH-RT Manuel

Danfoss

Danfoss RET2000B-RF + RX1-S Manuel utilisateur

Danfoss

Danfoss FH-CWD Manuel utilisateur

Danfoss

Danfoss CET2000B-RF Manuel utilisateur

Danfoss

Danfoss CF-RP 088U0211 Manuel utilisateur

Danfoss

Danfoss ECtemp Next Plus Manuel utilisateur

Danfoss

Danfoss TP5000 RF Si Manuel utilisateur

Danfoss

Danfoss ECL Comfort 210 Manuel utilisateur

Danfoss

Danfoss TP7001 series Manuel utilisateur

Danfoss

Danfoss RAS-C2 Combi Manuel utilisateur

Danfoss

Danfoss RET230P Manuel utilisateur

Manuels Thermostat populaires d'autres marques

EWELLY

EWELLY EW-181 Manuel utilisateur

Prolon

Prolon T1100 Instructions d'installation

Computherm

Computherm Q20 Manuel utilisateur

Heatmiser

Heatmiser neoStat Manuel utilisateur

Aube Technologies

Aube Technologies TH111GFCI-NP 240 VCA Manuel utilisateur

Mars

Mars HEAT CONTROLLER IR Wireless Thermostat Manuel utilisateur

Saswell

Saswell SAS920XWHB-7-S-RF Mode d’emploi

Aircalo

Aircalo TFP1-ET85P2 Manuel utilisateur

Honeywell

Honeywell CM721 Manuel utilisateur

Carrier

Carrier DEBONAIR 33CS Manuel utilisateur

Lennox

Lennox iHarmony Zone Thermostat Instructions de montage

Gemtech

Gemtech GT7000 Mode d’emploi

Rollei

Rollei Smartes 45000 Manuel utilisateur

Sinope

Sinope TH1300RF Manuel utilisateur

Honeywell

Honeywell RLV4305 Manuel utilisateur

Honeywell

Honeywell Prestige 2.0 THX9421 Manuel utilisateur

NuTone

NuTone NTBZ48 Instructions d'utilisation d'origine

Stelpro

Stelpro MAESTRO ASMT402AD Manuel utilisateur