Crestron HBK-3000 Manuel utilisateur

Crestron HBK-3000 & SMK-3000

Hatchback and Swivel Mount Kits

Installation Guide

This document was prepared and written by the Technical Documentation department at:

Crestron Electronics, Inc.

15 Volvo Drive

Rockleigh, NJ 07647

1-888-CRESTRON

All brand names, product names and trademarks are the property of their respective owners.

Crestron HBK-3000 & SMK-3000 Hatch Back & Swivel Mount Kits

Contents

Hatchback & Swivel Mount Kits: HBK-3000 & SMK-3000 1

Description .......................................................................................1

Supplied Hardware...........................................................................2

Installation........................................................................................2

HBK-3000 Assembly/Installation Procedure........................2

SMK-3000 Assembly/Installation Procedure........................3

Further Inquiries...............................................................................6

Future Updates .................................................................................6

Return and Warranty Policies ..........................................................7

Merchandise Returns / Repair Service ..................................7

CRESTRON Limited Warranty ............................................7

Installation Guide – DOC. 6110 Contents •i

Crestron HBK-3000 & SMK-3000 Hatch Back & Swivel Mount Kits

Hatchback & Swivel Mount Kits:

HBK-3000 & SMK-3000

Description

The Hatchback and Swivel Mount Kits, HBK-3000 and SMK-3000

(each sold separately), are designed for attachment to the Crestron

TPS-3000 tilt touchpanels.

The HBK-3000 hatchback is a sleekly designed rear-cover option that

provides cable management, wire strain relief, and prevents

unauthorized users from disconnecting the touchpanel. The wire exit

hole at the rear of the HBK-3000 is sized to accommodate all cables that

would typically be connected to the touchpanel. These include the

Crestron-furnished 10- and 8-position, Siamese network/video and audio

cable, an RS-232 cable, and a headphone cable. (Cables not provided

with HBK-3000 or SMK-3000 kits.)

The SMK-3000 swivel mount accessory reduces the chance of theft

while improving viewing convenience. The base rotates 330 degrees,

mounts on the desktop, in a lectern, or on a conference table, and

accommodates surface thicknesses from 3/4-inch minimum to

1 3/8-inches maximum, using the hardware provided. The swivel mount

kit includes the same mounting bracket, rear cover, and attaching screws

as the HBK-3000 option, which covers the cable connections. Routing

the cables down through the center of the swivel assembly keeps the

cables completely hidden from the work surface.

Installation Guide – DOC. 6110 Hatchback & Swivel Mount Kits: HBK-3000 & SMK-3000 •1

Hatch Back & Swivel Mount Kits Crestron HBK-3000 & SMK-3000

Supplied Hardware

The hardware supplied in the kits is listed in the following table.

Supplied Hardware of the HBK-3000 and SMK-3000 (Hatchback &

Swivel Mount Kits)

HBK-3000 SMK-3000*

One (1) Metal Bracket One (1) Swivel Mount Assembly

One (1) Plastic Cover One (1) Metal Bracket

Four (4) Screws 4-40 X 3/16 inch One (1) Metal Plate

One (1) Plastic Cover

Sixteen (16) Screws

(4) 4-40 X 3/16-inch

(4) 6-32 X 1/2-inch

(4) 8-32 X 5/8-inch

(4) 8-32 X 1-inch

* The SMK-3000 mounting kit includes a template for preparing the mounting

surface.

Installation

This section provides an installation procedure for each kit. The only

tools required are #1, #2, and #3 Phillips screwdrivers.

HBK-3000 Assembly/Installation Procedure

To attach the HBK-3000 Hatch Back Kit to the TPS-3000 Touchpanel,

refer to the illustration on page 3 and perform the associated procedures.

1. Remove the two screws Afrom the rear of the touchpanel that

correspond to the holes in the mounting tabs of the Metal Bracket.

2. Put the Metal Bracket in position on the rear of the touchpanel

base (mounting holes should align, and standoff posts should be

oriented as shown in the illustration). Secure the Metal Bracket to

the touchpanel using the two screws Aremoved in step 1.

3. Make certain cable connections are secure, put the Plastic Cover

in position with the cables routed through the rear opening. Secure

the cover to the Metal Bracket using the four # 4-40X 3/16-inch

screws Bsupplied.

2 •Hatchback & Swivel Mount Kits: HBK-3000 & SMK-3000 Installation Guide – DOC. 6110

Crestron HBK-3000 & SMK-3000 Hatch Back & Swivel Mount Kits

HBK-3000 Assembly View

SMK-3000 Assembly/Installation Procedure

To attach the SMK-3000 Swivel Mount Kit to the TPS-3000 Touchpanel

and install the assembly on a suitable mounting surface, refer to the

following procedures and the illustration on page 5.

1. Prepare the mounting surface using the template provided with the

kit. The center hole for the swivel assembly should be 2.5-inches

minimum; 2.6-inches maximum. Position the template so that the

edge indicated as ‘front’ aligns with desired front position of the

touchpanel. Observe the dashed line indicating front edge of the

touchpanel base to ensure the touchpanel will not overhang the

mounting surface.

2. If necessary, to prevent errors when reconnecting, label and

disconnect any cables connected to the touchpanel.

3. Place the touchpanel face down on a padded surface to prevent

damage to the display screen. Adjust tilt angle if needed. Avoid

putting pressure on the display housing.

4. Refer to the assembly view for the HBK-3000 Hatchback Kit

above and remove the two screws Afrom the rear of the

touchpanel that correspond to the Mounting Holes in the Metal

Bracket.

Installation Guide – DOC. 6110 Hatchback & Swivel Mount Kits: HBK-3000 & SMK-3000 •3

Hatch Back & Swivel Mount Kits Crestron HBK-3000 & SMK-3000

5. Put the Metal Bracket in position on the rear of the touchpanel

base (mounting holes should align, and standoff posts should be

oriented as shown in the illustration). Secure the Metal Bracket to

the touchpanel using the two screws Aremoved in step 4.

6. Refer to the illustration on page 5, and route the cables from the

interface box up through the Metal Plate, through the mounting

surface and through the Swivel Assembly, then through the area

of the bracket shown in the figure, and connect to the appropriate

touchpanel ports. Route the cables carefully to avoid chafing.

7. Being careful to avoid damage to the cables, attach the Swivel

Assembly to the base of the touchpanel, using the supplied four

#6-32 X 1/2 inch screws Cthrough the swivel assembly standoff

posts into the threaded holes in the touchpanel base. Make certain

the cables are not twisted or crimped and have sufficient slack at

the port connections before fully tightening the screws.

8. Make certain tab Dis positioned to the front of the swivel

assembly, and that it is directly opposite bent tab F, and place the

touchpanel and swivel mount assembly down on the Mounting

Surface.

9. Hold the Metal Plate in position under the mounting surface and

secure the assembly in place using the #8-32 screws Gprovided

(use the 5/8-inch screws for surfaces 3/4-inch to 1 1/8-inches

thick; use the 1-inch screws for surfaces 1 1/8 to 1 3/8 inches

thick). Use screws Eto adjust tension of the swivel assembly.

10.Again, refer to the HBK-3000 illustration on page 3, and put the

Plastic Cover in position and secure to the Metal Bracket using

the four #4-40 X 3/16-inch screws Bsupplied.

4 •Hatchback & Swivel Mount Kits: HBK-3000 & SMK-3000 Installation Guide – DOC. 6110

Crestron HBK-3000 & SMK-3000 Hatch Back & Swivel Mount Kits

SMK-3000 Swivel Mount Kit Assembly Diagram

FRONT

From

Interface Box

Touchpanel

Mounting Surface

Swivel

Assembly

Metal Plate

Bottom of

Touchpanel

Mounting

Holes(2)

Mounting

Holes(4)

RouteCables

ThroughThis

Opening

Installation Guide – DOC. 6110 Hatchback & Swivel Mount Kits: HBK-3000 & SMK-3000 •5

Hatch Back & Swivel Mount Kits Crestron HBK-3000 & SMK-3000

Further Inquiries

If after reviewing this Installation Guide, you cannot locate specific

information or have questions, please take advantage of Crestron's award

winning customer service team by calling:

• In the US and Canada, call Crestron’s corporate headquarters

at 1-888-CRESTRON [1-888-273-7876].

• In Europe, call Crestron International at +32-15-50-99-50.

• In Asia, call Crestron Asia at +852-2341-2016.

• In Latin America, call Crestron Latin America at

+5255-5093-2160.

• In Australia and New Zealand, call Crestron Pacific at

+613-9480-2999.

As of the date of manufacture, the HBK-3000 and SMK-3000 have been

tested and found to comply with specifications for CE marking.

Future Updates

As Crestron improves functions, adds new features, and extends the

capabilities of the HBK-3000 or SMK-3000, additional information may

be made available as manual updates. These updates are solely

electronic and serve as intermediary supplements prior to the release of a

complete technical documentation revision.

Check the Crestron website (www.crestron.com) periodically for manual

update availability and its subjective value. Updates are available from

the Downloads | Product Manuals section and are identified as an

“Addendum” in the Download column.

6 •Hatchback & Swivel Mount Kits: HBK-3000 & SMK-3000 Installation Guide – DOC. 6110

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Crestron Support et étagère

Crestron

Crestron WMKU-4SM Manuel utilisateur

Crestron

Crestron CAEN-UMP1X2-DIN-PWS Manuel utilisateur

Crestron

Crestron MMK-V15 Manuel utilisateur

Crestron

Crestron HBK-6000 Manuel utilisateur

Crestron

Crestron MMK-4000L Manuel utilisateur

Crestron

Crestron PMK-4L Manuel utilisateur

Crestron

Crestron CNXRMAK Manuel utilisateur

Crestron

Crestron TMK-12L Manuel utilisateur

Crestron

Crestron TMK-4000L Manuel utilisateur

Crestron

Crestron TPS-6X-DSW Manuel utilisateur

Crestron

Crestron CSA-DECOR3-BRKT-163-EC-MTL Manuel utilisateur

Crestron

Crestron FlipTop Basic FT-600 Comment utiliser

Crestron

Crestron SSW-MUMK Manuel utilisateur

Crestron

Crestron TS-70 Series Manuel utilisateur

Crestron

Crestron PMK-1000L Manuel utilisateur

Crestron

Crestron FTI-PWR-D Comment utiliser

Crestron

Crestron TSW-550-BBI Manuel utilisateur

Crestron

Crestron RMK-12L Manuel utilisateur

Crestron

Crestron TSW-1070-RMB-4 Manuel utilisateur

Crestron

Crestron Mud Ring Mount Kit for Cameo 2 MMK-CBF-T Manuel utilisateur

Crestron

Crestron TMK-4L Manuel utilisateur

Crestron

Crestron CNWM-29A Manuel utilisateur

Crestron

Crestron CCS-UC-200-WSTND Manuel utilisateur

Crestron

Crestron MMK-V12 Manuel utilisateur

Manuels Support et étagère populaires d'autres marques

Salamander

Salamander Acadia AC/W/L400/WH Manuel utilisateur

Fohhn

Fohhn VAT-09 Guide de l'utilisateur

ricoo

ricoo FS0522 Manuel utilisateur

AMSOIL

AMSOIL BMK-22 Guide rapide

Kargo Master

Kargo Master 48220 Manuel utilisateur

Milestone AV Technologies

Milestone AV Technologies SIMPLICITY SLF2 Manuel utilisateur

ricoo

ricoo S1222 Manuel utilisateur

Ready-Set-Mount

Ready-Set-Mount RSMCM602 Manuel utilisateur

VidaBox

VidaBox VB MNT FFS2 Manuel utilisateur

Welch Allyn

Welch Allyn 48960 Manuel utilisateur

Arkon

Arkon CM035-ST-2 Manuel utilisateur

PROEL

PROEL PLWIN60C Manuel utilisateur

Agilent Technologies

Agilent Technologies E2609B Manuel utilisateur

Mustang

Mustang MV-ARM4 Manuel utilisateur

Mounting Solutions

Mounting Solutions WRM-320 Manuel utilisateur

Pyle

Pyle PMKSPAD1 Manuel utilisateur

ShelterIt

ShelterIt 21208 Manuel utilisateur

SPL

SPL RackPack?4 1040 Manuel utilisateur