CraftUnique CraftBot XL Manuel utilisateur
1
CraftBot
PETG DOME COVER
INSTALLATION MANUAL
2
CraftBot
HARDWARE
1. First, unplug the machine. Then, care-
fully remove the rear panel of the
printer, using care with the case fan ca-
ble (red-black-yellow). Place the dome
cover on top of the machine, but do
not screw it together yet.
2. The next step is to disconnect the case
fan.
3
CraftBot
3. Connect the appropriate end of the “Y”
wire of the dome cover fan to the case
fan socket.
4. After that, connect the case fan con-
nector to the other end of the “Y” wire.
4
CraftBot
FIRMWARE SETTINGS
• In the temperature setting menu, by pressing the icon, the dome cover settings menu will be
displayed.
• Here, with the ON / OFF button, you can enable or disable the operation of the dome fan. This
feature setting will not change when the printer is turned o and on.
5. Finally, screw in the rear panel and the
dome cover. The correct location of the
lament guide tube and the fan wiring
are shown in the following gures.
Autres manuels CraftUnique Imprimante 3D
CraftUnique
CraftUnique CraftBot Manuel utilisateur
CraftUnique
CraftUnique CraftBot Plus Manuel utilisateur
CraftUnique
CraftUnique CraftBot Manuel utilisateur
CraftUnique
CraftUnique CraftBot 3 Manuel utilisateur
CraftUnique
CraftUnique CraftBot 3 Supervisor Manuel utilisateur
CraftUnique
CraftUnique CraftBot PlusPro Manuel utilisateur
