Comnet FVT11MAC Manuel utilisateur

INS_FVT11MAC_REV–

03/08/10

PAGE 1

INSTALLATION AND OPERATION MANUAL

FVT11MAC

Single Channel Mini Video Transmitter

24VAC Transformer Isolated

The FVT11MAC video mini-transmitter supports transmission of a fixed video

signal using AM (amplitude modulation) on one multimode fiber optic cable. The

FVT11MAC video transmitter is compatible with the FVR11M, FVR10M, FVR21,

and FVR22 receivers. Installation requires no electrical or optical adjustments.

The transmitter incorporates a bi-color (Red/Green) indicating LED for monitoring

proper system operation.

The unit operates on 24VAC power.

The FVT11MAC mini unit operates as a standalone module only.

See Figures 1 – 3 for complete installation details.

INS_FVT11MAC_REV–

03/08/10

PAGE 2

MULTIMODE

OPTICAL FIBER

24VAC INPUT

ACH

ACL

FIGURE 1 – FVT11MAC

FIGURE 2 – FVT11MAC FIGURE 3 – LED INDICATOR

INSTALLATION AND OPERATION MANUAL FVT11MAC

REAR PANELFRONT PANEL

TECH SUPPORT: 1.888.678.9427

VIDEO PRESENT

GREEN A Video signal is

present.

RED No Video signal is

present.

OFF Unit not powered up.

INS_FVT11MAC_REV–

03/08/10

PAGE 3

3 CORPORATE DRIVE | DANBURY, CT 06810 | USA

T: 203.796.5300 | F: 203.796.5303 | TECH SUPPORT: 1.888.678.9427 | INFO@COMNET.NET

8 TURNBERRY PARK ROAD | GILDERSOME | MORLEY | LEEDS, UK LS27 7LE

T: +44 (0)113 307 6400 | F: +44 (0)113 253 7462 | INFO-EUROPE@COMNET.NET

MECHANICAL INSTALLATION INSTRUCTIONS

FIGURE A

Dimensions are for a standard ComNet™ “mini” module

INSTALLATION CONSIDERATIONS

This fiber-optic link is supplied as a Standalone/Rack module. Units

should be installed in dry locations protected from extremes of

temperature and humidity.

C1-US, C1-EU, C1-AU OR C1-CH CARD CAGE RACKS

CAUTION: Although the units are hot-swappable and may be installed

without turning power off to the rack, ComNet recommends that

the power supply be turned off and that the rack power supply

is disconnected from any power source. Note: Remove electrical

connector before installing in card cage rack.

1. Make sure that the card is oriented right side up, and slide it into

the card guides in the rack until the edge connector at the back

of the card seats in the corresponding slot in the rack’s connector

panel. Seating may require thumb pressure on the top and bottom

of the card’s front panel.

CAUTION: Take care not to press on any of the LEDs.

2. Tighten the two thumb screws on the card until the front panel of

the card is seated against the front of the rack.

WARNING: Unit is to be used with a Listed Class 2 or LPS power supply rated

9-12 VDC @ 1A.

IMPORTANT SAFEGUARDS:

A) Elevated Operating Ambient - If installed in a closed or multi-unit rack

assembly, the operating ambient temperature of the rack environment may

be greater than room ambient. Therefore, consideration should be given to

installing the equipment in an environment compatible with the maximum

ambient temperature (Tma) specified by the manufacturer.

B) Reduced Air Flow - Installation of the equipment in a rack should be such

that the amount of air flow required for safe operation of the equipment is

not compromised.

Table des matières

Autres manuels Comnet Émetteur

Comnet

Comnet FVT4014 Manuel utilisateur

Comnet

Comnet FVTR1D1A2C1M1 Manuel utilisateur

Comnet

Comnet FVT801 Manuel utilisateur

Comnet

Comnet FVT10 Manuel utilisateur

Comnet

Comnet netwave NWKED Manuel utilisateur

Comnet

Comnet FVT4014SHR Manuel utilisateur

Comnet

Comnet FVT80D4SFP Manuel utilisateur

Comnet

Comnet FVT8014 Manuel utilisateur

Comnet

Comnet FVT80D8SFP Manuel utilisateur

Comnet

Comnet FDC8ISOT1 Manuel utilisateur

Comnet

Comnet FVR1031 series Manuel du propriétaire

Comnet

Comnet FVR1031S1 Manuel utilisateur

Comnet

Comnet FVT1C1BM1-M Manuel utilisateur

Comnet

Comnet FVT20 Manuel utilisateur

Comnet

Comnet FVT10C1(M,S)1/M Series Manuel utilisateur

Comnet

Comnet FVT40SFP Series Manuel utilisateur

Comnet

Comnet FVT1031 Manuel utilisateur

Comnet

Comnet FVTR Manuel utilisateur

Comnet

Comnet FVR1021 Series Manuel utilisateur

Manuels Émetteur populaires d'autres marques

NIVELCO

NIVELCO EasyTREK SCA-300 Series Manuel du propriétaire

Honeywell

Honeywell 5816WMBR Manuel utilisateur

Kamstrup

Kamstrup READy MTU Mode d'emploi

Omega

Omega ZW Series Manuel utilisateur

ABB

ABB Field 264H Mode d’emploi

Alinco

Alinco DJ-V17T Manuel utilisateur

Dejero

Dejero EnGo 3x Manuel utilisateur

Rosemount

Rosemount 4600 Manuel utilisateur

Speaka Professional

Speaka Professional 2342740 Manuel utilisateur

trubomat

trubomat GAB 1000 Manuel utilisateur

Teledyne Analytical Instruments

Teledyne Analytical Instruments LXT-380 Manuel utilisateur

Rondish

Rondish UT-11 Manuel utilisateur

MG 10JRE Manuel utilisateur

Burkert

Burkert 8177 Manuel utilisateur

Firetide

Firetide HotPort 3203 Manuel

Tele Radio

Tele Radio T9-02 Manuel utilisateur

Rotronic

Rotronic HygroFlex HF3 Series Manuel utilisateur

Jamara

Jamara FCX6 Pro Tel Manuel utilisateur