CDA ECNK90 Guide de démarrage rapide

www.cda.eu

ECNK90

Island Extractor

Installation, use and maintenance

Contents:

3 Important information

5 Important safety warnings

6 Using your extractor

7 Care and maintenance

8 Changing the charcoal ﬁlter

9 Changing a light bulb (contact CDA Customer Care)

10 Mains electricity connection

11 Electrical information

11 Troubleshooting

12 Installation - preparation

13 Ducting

14 Installation

17 Installation height diagrams

19 Energy eciency information

Important

The CDA Group Ltd. cannot be held responsible for injuries

or losses caused by incorrect use or installation of this

product. Please note that The CDA Group Ltd. reserves the

right to invalidate the guarantee supplied with this product

following incorrect installation or misuse of the appliance or

use in a commercial environment.

This appliance is not designed to be used by people

(including children) with reduced physical, sensorial or

mental capacity, or who lack experience or knowledge

about it, unless they have had supervision or instructions on

how to use the appliance by someone who is responsible

for their safety.

Under no circumstances should any external covers be

removed for servicing or maintenance except by suitably

qualiﬁed personnel.

Appliance information:

Please enter the details on the appliance rating plate below for

reference, to assist CDA Customer Care in the event of a fault

with your appliance and to register your appliance for guarantee

purposes.

Appliance Model

Serial Number

EU Declarations of Conformity:

This appliance has been manufactured to the strictest standards and

complies with all applicable legislation, including Gas safety, Electrical

safety (LVD) and Electromagnetic interference compatibility (EMC).

IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE

PRODUCT IN ACCORDANCE WITH EC DIRECTIVE 2012/19/EU.

At the end of its working life, the product must be taken to a special

local authority waste collection centre or to a dealer providing appliance

recycling services. Disposing of a household appliance separately

avoids possible negative consequences for the environment and

health. It also enables the constituent materials to be recovered, saving

both energy and resources. As a reminder of the need to dispose of

household appliances separately, the product is marked with a crossed-

out wheeled dustbin.

Please note:

•Under no circumstances should the extractor be

connected to any gas ventilation system, ﬂue system or

hot air ducting system.

•Do not vent the extractor into an attic or loft space.

•Only house the extractor in rooms with adequate

ventilation. Remember that the extractor is powerful and

whatever air is extracted needs to be replaced.

•Do not tile the extractor in. It should be removable for

service or maintenance.

•Do not use silicone sealant to secure the hood to the

wall.

•You must be able to isolate the extractor from the mains

electrical supply after installation.

•Steam cleaners must not be used when cleaning this

appliance.

•The performance of your extractor will vary depending

on a number of factors. These include: type of extraction,

length of ducting, room volume, ventilation available and

cleanliness of the ﬁlters.

Using your extractor

For best performance, you should switch on the extractor

15 minutes before starting to cook and leave it to run for

approximately 15 minutes after the end of cooking.

Control Panel

A - Power o button

B - Speed level buttons

C - Light button

To switch the extractor light on or o

• Press button “C”.

To switch on the extractor or to change the speed at any time

when the extractor is running

• Press the relevant “B” button for the ﬁrst, second or third speed

level as required.

To switch the extractor o

• Press the “A” button.

Important: The lighting is intended to be used for the duration of

cooking only. The lighting should not be used for ambient lighting

purposes.

Fig. 1 A B C

Care and maintenance

IMPORTANT: DO NOT PERFORM

MAINTENANCE OR CLEANING OF

THE EXTRACTOR WITHOUT FIRST

SWITCHING OFF THE ELECTRICITY

SUPPLY.

Cleaning

You should use a nonabrasive cleaner.

Any abrasive cleaner (including Cif) will

scratch the surface and could erase the control panel markings.

You can clean your extractor eectively by simply using a dilute

solution of water and mild detergent and drying to a shine with a clean

cloth.

Cleaning the grease ﬁlter

The grease ﬁlter should be kept clean to minimise the risk of ﬁre.

At least once a month, you should remove and clean the grease

ﬁlter with hot soapy water. You can also wash the grease ﬁlter in

a dishwasher (see note on page 8), ensuring that you place it in

an upright position to prevent damage from other items in the

dishwasher. After rinsing and drying, replace the ﬁlter.

To remove the grease ﬁlter

1. Pull open the handle on the grease ﬁlter as shown in ﬁg. 2. It will

release at the handle side.

2. Lower the grease ﬁlter to remove it completely.

Fig. 2

To replace the grease ﬁlter

Repeat the steps on page 7 in reverse order.

Please note: Cleaning the grease ﬁlter in a dishwasher may lead to

discolouration. This is normal and does not constitute a fault with the

appliance.

Changing the charcoal ﬁlter (re-circulating only)

We recommend protecting any areas below and near the hob before

and during this process to make sure nothing falls and causes

damage.

To attach a new charcoal ﬁlter, ﬁrst remove the grease ﬁlter as

described on page 7. Remove any old charcoal ﬁlter and then oer

up the magnetic side of the new charcoal ﬁlter to the metal extractor

housing/opening (the same that holds the grease ﬁlter) so that it

secures into place. Leave the tab on the ﬁlter accessible for when you

need to remove it. Then, replace the grease ﬁlter.

Charcoal ﬁlters are available as an optional accessory from CDA

Customer Care under code CHA12.

Changing the light

IMPORTANT: THE LIGHT BULBS SHOULD ONLY BE CHANGED BY

CDA AUTHORISED SERVICE AGENTS. IF ONE OR MORE OF YOUR

BULBS FAIL, CONTACT CDA CUSTOMER CARE TO ARRANGE A

SERVICE VISIT.

DO NOT TOUCH THE LIGHT BULBS IMMEDIATELY AFTER USE AS

THE BULB MAY BE WARM/HOT.

Do not touch bulbs or adjacent areas during or straight after pro-

longed use of the lights.

The light is designed for use during cooking and not for general room

illumination. Extended use of the light can reduce the life span of the

bulb.

DOUBLE POLE SWITCHED

FUSED SPUR OUTLET

USE A 3 AMP FUSE

Mains electricity

connection

THIS APPLIANCE MUST BE

CONNECTED TO THE MAINS SUPPLY

BY A COMPETENT PERSON, USING

FIXED WIRING VIA A DOUBLE POLE

SWITCHED FUSED SPUR OUTLET

AND PROTECTED BY A 3A FUSE.

The appliance must be connected by a

qualiﬁed electrician, who is a member

of the N.I.C.E.I.C. and who will comply with the I.E.T.

and local regulations.

The wires in the mains lead of this appliance are coloured in

accordance with the following code:

BLUE = NEUTRAL, BROWN = LIVE, GREEN+YELLOW = EARTH

As the colours of the wires in the mains lead for the appliance may

not correspond with the coloured markings identifying the terminals

connecting to the fused spur, proceed as follows:

•The wire which is coloured blue must be connected to the terminal

marked N (Neutral), or coloured black.

•The wire which is coloured brown must be connected to the

terminal marked L (Live), or coloured red.

•The wire which is coloured green and yellow must be connected

to the terminal marked E (Earth) or coloured green or green and

yellow.

Table des matières

Autres manuels CDA hotte de ventilation

Manuels hotte de ventilation populaires d'autres marques

emmeti

emmeti RECUPA MED A-140 Mode d’emploi

Nibe

Nibe F135 Manuel utilisateur

Kuppersberg

Kuppersberg INTRO 60 Instructions d'installation et d'entretien

Zephyr

Zephyr Spruce AK9834BS Guide d'installation

Hisense

Hisense MH6INBG Manuel utilisateur

Miele

Miele DA 1255 Manuel utilisateur

Broan

Broan 46000 Manuel utilisateur

GE Profile PV977 Instructions originales

FALMEC

FALMEC FFRIA24W5FS Manuel utilisateur

Whirlpool

Whirlpool RH2600XL-1 SERIES Manuel utilisateur

Küppersbusch

Küppersbusch DX ISLA Manuel utilisateur

ETNA

ETNA AV360RVS Manuel utilisateur

JUNO

JUNO JDF603E6 Manuel utilisateur

Miele

Miele DA 6708 D Manuel utilisateur

Tricity Bendix

Tricity Bendix LE 150 Manuel

AEG

AEG X68163BV1 Manuel utilisateur

AEG

AEG 125 D Manuel utilisateur

Smeg

Smeg KSEV97X Manuel utilisateur