CDA CTE9 Guide de démarrage rapide

www.cda.eu

CTE9

Extractor

Installation, use and maintenance

Contents:

3 Important

5 Important information

6 Using your extractor

7 Care and maintenance

9 Troubleshooting

10 - 13 Installation

10 Installation - height

11 Installation - preparation and ducting

12 Installation - mounting the extractor

14 Non-return ﬂaps

15 Mains electrical connection

Important

The CDA Group Ltd cannot be held responsible for injuries or losses

caused by incorrect use or installation of this product. Please note

that CDA reserve the right to invalidate the guarantee supplied with

this product following incorrect installation or misuse of the appliance

or use in a commercial environment.

This appliance is not designed to be used by people (including

children) with reduced physical, sensorial or mental capacity, or

who lack experience or knowledge about it, unless they have had

supervision or instructions on how to use the appliance by someone

who is responsible for their safety.

Under no circumstances should any external covers be removed for

servicing or maintenance except by suitably qualiﬁed personnel.

Appliance information:

Please enter the details on the appliance rating plate below for

reference, to assist CDA Customer Care in the event of a fault with

your appliance and to register your appliance for guarantee purposes.

Appliance Model

Serial Number

EU Declarations of Conformity:

This appliance has been manufactured to the strictest standards and

complies with all applicable legislation, including Gas safety, Electrical

safety (LVD) and Electromagnetic interference compatibility (EMC).

IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE

PRODUCT IN ACCORDANCE WITH EU DIRECTIVE 2012/19/EU.

At the end of its working life, the product must be taken to a special

local authority waste collection centre or to a dealer providing

appliance recycling services.

Disposing of a household appliance separately avoids possible

negative consequences for the environment and health. It also

enables the constituent materials to be recovered, saving both energy

and resources. As a reminder of the need to dispose of household

appliances separately, the product is marked with a crossed-out

wheeled dustbin.

Please note:

•Under no circumstances should the extractor be

connected to any gas ventilation system, ﬂue system or

hot air ducting system.

• Do not vent the extractor into an attic or loft space.

•Only house the extractor in rooms with adequate

ventilation. Remember that the extractor is powerful and

whatever air is extracted needs to be replaced.

•Do not tile the extractor in. It should be removable for

service or maintenance.

•Do not use silicone sealant to secure the hood to the wall.

•You must be able to isolate the extractor from the mains

electrical supply after installation.

•This appliance has been designed to be used in a room

with a volume of less than 36m³.

•Steam cleaners must not be used when cleaning this

appliance.

•The performance of your extractor will vary depending

on a number of factors. These include: type of extraction,

length of ducting, room volume, ventilation available and

cleanliness of the ﬁlters.

Using your extractor

For best performance, you should switch on the extractor 15 minutes

before starting to cook and leave it to run for approximately 15 minutes

after the end of cooking.

Controls

A- Lamp switch B- Left speed switch C- Right speed switch

To switch the extractor on and adjust speed

Slide open the canopy and activate either switch B or switch C (Fig. 1).

Switch B, the left speed switch, has three positions; speed 1, speed 2

and o. Switch C, the right speed switch, has two positions; speed 3

and o.

To switch the extractor o

Simply close the sliding canopy (the extractor will resume when the

canopy is re-opened). However, if leaving the appliance o for a long

time, ensure that the left speed switch is in the o (centre) position and

the right speed switch is in the o position.

Fig. 1

AB C

To switch the lights on

Slide open the canopy and activate the lamp switch (A). Fig. 1 shows the

switch in the o position.

To switch the lights o

Simply close the sliding canopy. The lights will come back on when the

canopy is re-opened. However, if leaving the appliance o for a long

time, ensure that the lamp switch is in the o position.

Care and maintenance

IMPORTANT: DO NOT PERFORM MAINTENANCE OR CLEANING

OF THE EXTRACTOR WITHOUT FIRST SWITCHING OFF THE

ELECTRICITY SUPPLY.

Cleaning

You should use a nonabrasive cleaner. Any abrasive cleaner

(including Cif) will scratch the surface and could erase the control

panel markings.

You can clean your extractor eectively by simply using a dilute

solution of water and mild detergent and drying to a shine with a clean

cloth, for example a micro-ﬁbre Cloth.

Cleaning the grease ﬁlters

The grease ﬁlters should be kept clean to minimise the risk of ﬁre.

At least once a month you should remove and clean the grease

ﬁlters with hot soapy water. You can also wash the grease ﬁlters in

a dishwasher, ensuring that you place them in an upright position to

prevent damage from other items in the dishwasher.

To remove the grease ﬁlters, push in the button on the handle and

then pull down on the ﬁlter at the front. When you have released it at

the front, then you can pull the ﬁlter out completely.

After rinsing and drying, reassemble the grease ﬁlters to the hood by

reversing the removal process.

Please note:

Cleaning the grease ﬁlters in the dishwasher may lead to

discolouration. This is normal and does not constitute a fault with the

appliance.

Changing the charcoal ﬁlter (re-circulating mode only)

To ensure best performance of your extractor, you should replace

the charcoal ﬁlters every four to six months, depending on use. The

charcoal ﬁlters are an optional accessory. These are available from

the CDA Sales team on 01949 862010 under code CHA35.

To attach the charcoal ﬁlters:

• Remove the grease ﬁlters as

described above.

•Align the slots on the charcoal

ﬁlter with the notches on the

underside of the motor. Place

the ﬁlter onto the motor and

turn clockwise slightly. The ﬁlter should hold ﬁrmly in place. Repeat

with the other side.

•Finally, replace the grease ﬁlters.

Fig. 2

Troubleshooting

Please note:

Your extractor is equipped with a motor protection device that will

switch o the motor to prevent damage from overheating. This may

happen during cooking when most or all of a hob’s zones/burners are

being used simultaneously, or if your extractor is installed incorrectly

(e.g. lower than the recommended height).

This is normal, and the extractor will work again once the motor has

cooled suciently.

If your extractor is not working:

1. Check that the mains supply has not been switched o.

2. Check that the fuse in the spur has not blown.

3. Check that a speed switch is active and the canopy is open.

If your lights are not working:

1. Check that the mains supply has not been switched o.

2. Check that the fuse in the spur has not blown.

3. Check that the lamp switch is on and the canopy is open.

4. If the extractor still extracts, then it’s possible both bulbs have gone.

The bulbs are 3W E14 (SES) LEDs.

Contact CDA Customer Care

A: Customer Care Department, The CDA Group Ltd, Harby Road,

Langar, Nottinghamshire, NG13 9HY

T: 01949 862 012 F: 01949 862 003 E: customer[email protected]

W: www.cda.eu

Installation - height

When the extractor is to be

installed above a CDA electric

hob, the minimum distance

between the hob and extractor

must exceed 650mm.

When the extractor is to be

installed above a CDA gas hob,

the minimum distance between

the hob and extractor must

exceed 750mm.

If the instructions provided with your gas hob state that the required

distance between the hob and extractor must be greater than 750mm,

then that is the distance that should be observed; this is a legal

requirement and may lead to your hob being disconnected from the

gas supply and the installation being reported under RIDDOR.

Note: The height should be measured from the top of the hob’s

burners to the grease ﬁlter.

•IN THE ABSENCE OF ANY INSTRUCTIONS SUPPLIED WITH

THE GAS HOB, THE MINIMUM DISTANCE BETWEEN THE HOB

AND EXTRACTOR MUST BE AT LEAST 760mm.

•The width of any hob must not be greater than the width of the

extractor installed above it.

•Always bear servicing in mind. The extractor should always be

easily accessible or removeable after installation.

CDA Electric

hob - 65cm

CDA Gas

hob - 75cm

Fig. 3

Table des matières

Autres manuels CDA hotte de ventilation

CDA

CDA EVC4 Manuel utilisateur

CDA

CDA 3C9 Extractor Manuel de référence

CDA

CDA ECP Series Guide de démarrage rapide

CDA

CDA CCA5/7 Manuel de référence

CDA

CDA 3S10BL Guide de démarrage rapide

CDA

CDA EDD62 Guide de démarrage rapide

CDA

CDA EVC4 Manuel

CDA

CDA EVX90SS Guide de l'utilisateur

CDA

CDA CHX10 Manuel utilisateur

CDA

CDA EVP6 Manuel utilisateur

CDA

CDA ECA Guide de démarrage rapide

CDA

CDA EXG60BL Guide de l'utilisateur

CDA

CDA A1 Manuel utilisateur

CDA

CDA ECNK91 Manuel de service

CDA

CDA CST62 Instructions d'installation et d'utilisation

CDA

CDA EVPC9 Manuel de référence

CDA

CDA EVG Series Manuel de référence

CDA

CDA EVC41SS Manuel utilisateur

CDA

CDA 3L9 Manuel de référence

CDA

CDA ECA SERIES Guide de démarrage rapide

CDA

CDA ECR90CM Instructions d'installation et d'utilisation

CDA

CDA EVCK4 Manuel

CDA

CDA CCA5 Manuel utilisateur

CDA

CDA CTE Series Manuel de référence

Manuels hotte de ventilation populaires d'autres marques

emmeti

emmeti RECUPA MED A-140 Mode d’emploi

Nibe

Nibe F135 Manuel utilisateur

Kuppersberg

Kuppersberg INTRO 60 Instructions d'installation et d'entretien

Zephyr

Zephyr Spruce AK9834BS Guide d'installation

Hisense

Hisense MH6INBG Manuel utilisateur

Miele

Miele DA 1255 Manuel utilisateur

Broan

Broan 46000 Manuel utilisateur

GE Profile PV977 Instructions originales

FALMEC

FALMEC FFRIA24W5FS Manuel utilisateur

Whirlpool

Whirlpool RH2600XL-1 SERIES Manuel utilisateur

Küppersbusch

Küppersbusch DX ISLA Manuel utilisateur

ETNA

ETNA AV360RVS Manuel utilisateur

JUNO

JUNO JDF603E6 Manuel utilisateur

Miele

Miele DA 6708 D Manuel utilisateur

Tricity Bendix

Tricity Bendix LE 150 Manuel

AEG

AEG X68163BV1 Manuel utilisateur

AEG

AEG 125 D Manuel utilisateur

Smeg

Smeg KSEV97X Manuel utilisateur