CBC PT118XT-HD Manuel utilisateur

T-

-H

Outdoor Vandal Proof 18X IP HD PTZ Dome

UUser Manual

NY: 55 Mall Drive • Commack, NY 11725 (800) 422-6707

&$6:HVWHUQ$YH • Torrance, CA 9050 (877) 407-9555

www.computarganz.com

2/37

Megapixel Speed Dome Camera Instruction Manual

This symbol (lightning flash with arrowhead) is intended to alert the user to

the presence of un-insulated "dangerous voltage" within the product's

enclosure that may be of sufficient magnitude to constitute a risk of electric

shock to persons.

This symbol (exclamation point) is intended to alert the user about the

presence of important operating and maintenance (servicing) instructions in

the literature accompanying the appliance.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRICAL SHOCK, DO NOT OPEN THE COVERS.

THERE ARE NO USER SERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED SERVICE PERSONAL

3/37

Megapixel Speed Dome Camera Instruction Manual

Important Safety Guide

1. Read, heed and follow all the Instructions

Read all the safety and operating instructions before using the product.

2. Keep this manual

Keep this manual for future reference.

3. Attachments / Accessories

Use only the attachments or accessories specified by the manufacturer.

4. Installation

Do not install near any heat resources such as radiators, heat registers, stoves, or other apparatus including

amplifiers that product heat. Improperly installed product may fall, cause serious injury to a child or adult

and damage the product. Do not block any ventilation holes or openings. Install in accordance with the

manufacturer‟s instructions. Use only with the cart, stand, tripod, bracket, mounting devices, or table

specified by the manufacturer. Installation should be done only by qualified personnel and conform to all

the instructions by the manufacturer. Refer all servicing to qualified service personnel.

5. Power source

This product should be operated with the same type power source as indicated on the marking label

Caution

1. Operating

1. Before using, make sure that the power supply and associated parts are properly installed.

2. While operating, if any abnormal condition or malfunction is observed, stop using the product immediately and

then contact your local dealer.

2. Handling

1. Do not disassemble or tamper with the parts inside the product.

2. Do not drop or subject the product to shock and vibration as this can damage the product.

3. Care must be taken when you clean the clear dome cover. Especially, scratches or dust on the cover

will ruin the quality of the product.

3. Installation and Storage

1. Do not install the product in areas of extreme temperature, which exceed the allowable range.

2. Avoid installing in high humid or dusty environments.

3. Avoid installing in places where radiation is present.

4. Avoid installing in places where there are strong magnetic fields and electric signals.

5. Avoid installing in places where the product would be subject to strong vibrations.

NOTICE

4/37

Megapixel Speed Dome Camera Instruction Manual

①Introduction

Features

Package Components

Main Part Description

DIP Switch Setup

②Installation

Installation using Wall Mount Bracket

Wiring and Cabling

③Configuration

Web-View Main Screen

Video & Audio Configuration

Codec

____

Video

Audio

Privacy zone

PTZ Configuration

1. Basic configuration

2. RS 485 configuration

3. Preset & Preset Sequence

4. Swing

5.Pattern

6.Group Tour

CONTENTS

5/37

Megapixel Speed Dome Camera Instruction Manual

Event Configuration

1. Sensor and Relay

2. Emergency Alarm

Network Configuration

1.IP Setup

2.Dynamic DNS

3. Live Protocol

4. IP Filtering

System Configuration

1.Upgrade

2.Time & Date

3. Event Mail

4. User Management

④Specifications

Specifications

Dimension

CONTENTS

6/37

Megapixel Speed Dome Camera Instruction Manual

This „IP-server‟ supports remote images, sound, setup and control of camera functions though

IP Networks such as LAN, ADSL/VDSL, and Wireless LAN

Camera Specifications

Image Sensor :

1/3" Megapixel solid State Progressive Scan CCD.

Zoom :

18 Optical Zoom

WDR function (Wide Dynamic Range)

SNR(Super Noise Reduction) function

You can adjust focus to PTZ camera with 'Semi-Auto Focus function' included Auto-Focus, Manual Focus.

Video

Supports H.264, MPEG4,MJPEG (H.264 is the latest high efficiency compression format)

Various Resolutions : 1280720 ~ 256144

Supports a wide range of bandwidth control : 50kbps ~ 8Mbps

Supports HD-SDI(HDCCTV) video output

Audio

Supports various transmission modes :

Simplex (IP-server →Client PC / Decoder, Client PC / Decoder →IP server) and full-duplex

Network

Supports static IP, dynamic IP (DHCP), and PPPoE

Supports 1:1 and 1:N connection

Supports Multicast transmission

Supports various network protocol: TCP/IP, UDP, Multicast, DHCP, SMTP, HTTP, SNMP, RTP, RTSP

Powerful Pan/Tilt function

MAX. 360/sec High Speed Pan/Tilt movement.

With the Vector Drive Technology, Pan/Tilt motions are accomplished along the shortest path. As a

result, the time to view a target is remarkably short and the video output displayed feels very natural

for monitoring.

With the Micro-Stepping Control Technology, video movements still look very smooth at high zoom

magnification. During operation via a controller the camera can be moved by as little as 0.05/sec.

Hence it is very easy to make the camera focus on desired target even at high zoom magnification.

Additionally it is easy to make the camera focus on desired positions with zoom-proportional pan/tilt

movement.

Feature

INTRODUCTION

7/37

Megapixel Speed Dome Camera Instruction Manual

Preset, Swing, Group

You can set up to 99 preset positions, and assign camera image setting to each preset. Additional it is

possible to also assign a label/name to each preset position.

A maximum of 8 Swing sets are programmable. This function allows the user to set the camera to

move repetitively between two preset positions at a programmed speed.

A maximum of 4 Patterns are programmable. This function allows the user to set the camera to

memorize a path (mostly curve path) by the joystick of the controller and record the trajectory

operated by the joystick as closely as possible.

A maximum of 8 Group sets are programmable. This function is that the camera memorizes the

combination of Presets, Pattern and/or Swings sequentially and runs these Presets, Pattern and/or

Swings repetitively. A Group can be any combination of up to 20 Preset/Pattern/Swing functions.

PTZ control

Using RS-485 communication connection, a maximum of 255 cameras can be connected to a single

controller.

Alarm in/ output (Supported only on appropriate models)

3 alarm sensor inputs and 1 alarm relay output are available.

The alarm sensor inputs are decoupled with photo-couplers to avoid external electric noise and

shock protection.

Both N.O.(Normal Open) sensors and N.C.(Normal Close) sensors can be used and the signal range

of the Alarm output can be from DC 5.0V to 12.0V depending on the various applications.

The camera can be set to move to a Preset position or to run functions such as Pattern, Swing and

Group when there are external sensor activations. Also “Post Alarm” function is possible, which is

supposed to activate after a user-defined time period and sequentially in succession to the action by

external sensor activations

Designed for various

Outdoor Environments and Easy Installation

The fans and heaters are built-in to the camera for cold and hot temperature environments. Also

idealistic case design protects the camera from wet and dusty environments. (IP67)

The camera is designed for easy to installation and maintenance.

INTRODUCTION

8/37

Megapixel Speed Dome Camera Instruction Manual

Package Component

Product & Accessories

MainBody&ClearDomeCover

DefaultAccessories

[MainCable,Wrench]

Audio Cable

BNC (2ea)

LAN Crossover Cable

CD Manual

Brackets

WallMountBracket

[Screws:MachineM515,HexLag#1450]

INTRODUCTION

9/37

Megapixel Speed Dome Camera Instruction Manual

Main Part Description

Dome Cover

Do not remove the protection vinyl from the dome cover before finishing

all the installation processes. This is to protect the dome cover from

scratches or dust.

DIP Switch

Drop Prevention Spring

Used to set up the camera IDs and protocols.

Used to protect the product from being dropped by connecting safety

wire of bracket to hook of main body when being installed.

Mount Screw Hole

Used to assemble the main body with a bracket using screws.

MainConnector

Used for the power wire, the video cable and the RS-485 communication

cable connection.

LAN Connector

Audio Port

Video (BNC)

IP Module Reset Switch

Used for Ethernet cable connection. (Only supported on IP models)

Used for Audio In/Out connection

Used for HD-SDI cable connection.

Used for system rebooting

INTRODUCTION

10/37

Megapixel Speed Dome Camera Instruction Manual

DIP Switch Setup

Before installing the camera, set up the DIP switches to configure the camera ID and the

communication protocol.

Camera ID Setup

1 2 3 4 5 6 7 8

128

off

Off

off

Off

off

The ID number of camera is set using a binary number. Examples

shown below.

The range of ID is 1~255. UDo not use 0 as camera IDU. Factory

default of Camera ID is 1.

If you want to control a certain camera, you must match the camera ID

with Cam ID setting of DVR or Controller.

INTRODUCTION

Table des matières

Autres manuels CBC Caméra de sécurité

CBC

CBC GANZ ZC-NH406PE Manuel utilisateur

CBC

CBC CX Series Manuel utilisateur

CBC

CBC Ganz ZC-NH406P Manuel utilisateur

CBC

CBC ZN-B2MTP Manuel d'instructions

CBC

CBC PT127N Manuel utilisateur

CBC

CBC ZN-D MTP Series Manuel d'instructions

CBC

CBC ZC-PT212 Manuel utilisateur

CBC

CBC PT112N Manuel utilisateur

CBC

CBC AFZC-22X Manuel utilisateur

CBC

CBC ZN-DT Series Manuel d'instructions

CBC

CBC PT127N-XT Manuel utilisateur

CBC

CBC ZC-F11C4 Manuel utilisateur

CBC

CBC ZC-D4000 Series Manuel utilisateur

CBC

CBC CMC Series Manuel utilisateur

CBC

CBC Megapixel Camera Manuel utilisateur

CBC

CBC ZC-F10C1 Manuel utilisateur

CBC

CBC PT127N-XT Manuel utilisateur

CBC

CBC ZN-MDI2 M-IR Series Manuel d'instructions

CBC

CBC ZC-D3024PHA Manuel utilisateur

CBC

CBC GANZ Z8-VD2V-2 Manuel utilisateur

CBC

CBC ZN-BxMTP Series Manuel d'instructions

CBC

CBC LC703 Manuel utilisateur

CBC

CBC PT110N Manuel utilisateur

CBC

CBC ZN-MB2 Series Manuel d'instructions

Manuels Caméra de sécurité populaires d'autres marques

Okina USA

Okina USA SIR36-870VF650LP Manuel utilisateur

Divio

Divio NDR155PA Manuel utilisateur

Canon

Canon VB-C500D Manuel utilisateur

Easy Access

Easy Access EasyGuard Manuel utilisateur

Vivotek

Vivotek FD9389-EHV-v2 Manuel utilisateur

TUYA

TUYA COSMO W2 Manuel utilisateur

Eusso

Eusso UNC7500-IR Guide de configuration

urmet domus

urmet domus 1096/204 Manuel utilisateur

VC VC20 series Manuel utilisateur

Axis

Axis Q1614 Manuel utilisateur

ieGeek

ieGeek DD201 Manuel utilisateur

VADDIO

VADDIO ClearVIEW HD-USB PTZ 999-6990-000 Manuel utilisateur

Vicon

Vicon V662-D-1 Mode d'emploi

Grundig

Grundig GCH-K0274P Manuel utilisateur

Lorex

Lorex VANTAGE LBC7032 Manuel utilisateur

4xem

4xem WPT Manuel utilisateur

Samsung

Samsung SCV-3082 Manuel utilisateur

Vitek

Vitek VTC-C544 Manuel utilisateur