1.1 Warranty GENERAL
6.080.98.5.10.03
Contact us or your local after--sales service, if
any information is not properly understood.
SEquipment should only be transported and
stored in its original packing.
SEquipment should not be started up before
the requirements of the Bizerba operating
conditions are met.
SThe supporting area must be horizontal,
level, stable and non--slippery. Equipment
must be arranged in such a way as to
facilitate operation, working procedures
and service.
SInstallation, commissioning, initial
introduction, cleaning, maintenance and
servicing should only be carried out by the
relevant BIZERBA after--sales service or
by companies or personnel authorized by
BIZERBA.
SThe use of hardware and software which
may be necessary for a data dialog
between BIZERBA and non--BIZERBA
equipment is subject to written approval
from BIZERBA.
SEquipment should not be set into operation
before supervisory and operating
personnel have thoroughly read and
understood these operating instructions.
SThis machine is a technical work resource
which is only suitable for application at
work.
SOnly trained personnel over 14 years
should operate the equipment. Training
should be repeated.
SBIZERBA does not accept liability for
damage arising as a result of installation by
anyone other than
BIZERBA--incorporated or designated
representatives, faulty electrical
connection by the user, improper
operation, inappropriate use, modification
of equipment in any way from its original
form, removal of guards, the use of spare
parts and accessories other than genuine
BIZERBA parts or accessories.
SThe user will be responsible for any
damage or injury arising as a result of
failure to observe the BIZERBA
instructions.
STherefore, it is strongly recommended to
use only genuine BIZERBA spare parts
and accessories.
SNormal wear and tear is not covered by the
guarantee.
To provide operational
assurance and to protect
personnel from possible
injuries, the requirements of
these instructions must be met
before the machine is set into
operation and during operation.
These instructions are subject to revision as
further product development, experience and
investigation may show is necessary or
desirable. Graphics appearing in these
instructions may differ slightly from the model
supplied due to country--specific regulations.
This does not affect the contents of these
operating instructions.
4
