BenQ X3100i Manuel utilisateur

Digital Projector

User Manual

Console Gaming Projector I X3100i V 1.00

2 Warranty and Copyright information

Warranty and Copyright information

Limited warranty

BenQ warrants this product against any defects in material and workmanship, under normal

usage and storage.

Proof of purchase date will be required with any warranty claim. In the event this product is

found to be defective within the warranty period, BenQ's only obligation and your exclusive

remedy shall be replacement of any defective parts (labor included). To obtain warranty

service, immediately notify the dealer from which you purchased the product of any defects.

Important: The above warranty shall be void if the customer fails to operate the product in

accordance with BenQ's written instructions, especially the ambient humidity must be

in-between 10% and 90%, temperature in-between 0°C and 35°C, altitude lower than 4920 feet,

and avoiding to operate the projector in a dusty environment. This warranty gives you specific

legal rights, and you may have other rights which vary from country to country.

For other information, please visit www.BenQ.com.

reproduced, transmitted, transcribed, stored in a retrieval system or translated into any

language or computer language, in any form or by any means, electronic, mechanical,

magnetic, optical, chemical, manual or otherwise, without the prior written permission of BenQ

Corporation.

Disclaimer

BenQ Corporation makes no representations or warranties, either expressed or implied, with

respect to the contents hereof and specifically disclaims any warranties, merchantability or

fitness for any particular purpose. Further, BenQ Corporation reserves the right to revise this

publication and to make changes from time to time in the contents hereof without obligation to

notify any person of such revision or changes.

*DLP, Digital Micromirror Device and DMD are trademarks of Texas Instruments. Others are

copyrights of their respective companies or organizations.

The terms HDMI, HDMI High-Definition Multimedia Interface, HDMI Trade dress and the HDMI

Logos are trademarks or registered trademarks of HDMI Licensing Administrator, Inc.

3Table of Contents

Table of Contents

Warranty and Copyright information ...............................................................................2

Important safety instructions .........................................................................................4

Introduction ....................................................................................................................7

Shipping contents ............................................................................................................. 7

Installing the QS02 HDMI Media Streaming .................................................................... 8

Projector exterior view...................................................................................................... 9

Terminals......................................................................................................................... 10

Controls and functions ................................................................................................... 11

Positioning your projector ............................................................................................14

Choosing a location ........................................................................................................14

Obtaining a preferred projected image size.................................................................. 15

Mounting the projector ................................................................................................... 17

Adjusting the projector position..................................................................................... 18

Adjusting the projected image....................................................................................... 19

Connection ...................................................................................................................21

Operation .....................................................................................................................22

Starting up the projector .................................................................................................22

Setting up the QS02 HDMI Media Streaming................................................................ 25

Using the menus ............................................................................................................. 27

Securing the projector .................................................................................................... 28

Switching input signal .....................................................................................................30

Presenting from a Media Reader ................................................................................... 31

Shutting down the projector........................................................................................... 32

Menu operation ............................................................................................................33

Basic menu ......................................................................................................................33

Advanced menu .............................................................................................................. 34

Maintenance ................................................................................................................52

Care of the projector ....................................................................................................... 52

Light source information ................................................................................................ 53

Troubleshooting ...........................................................................................................55

Specifications ..............................................................................................................56

Projector specifications .................................................................................................56

Dimensions...................................................................................................................... 57

Timing chart .................................................................................................................... 58

RS232 command ............................................................................................................ 60

4 Important safety instructions

Important safety instructions

Your projector is designed and tested to meet the latest standards for safety of information

technology equipment. However, to ensure safe use of this product, it is important that you

follow the instructions mentioned in this manual and marked on the product.

1. Please read this manual before you

operate your projector. Save it for future

reference.

5. In some countries, the line voltage is

NOT stable. This projector is designed to

operate safely within a mains voltage

between 100 to 240 volts AC, but could

fail if power cuts or surges of ±10 volts

occur. In areas where the mains voltage

may fluctuate or cut out, it is

recommended that you connect your

projector through a power stabilizer,

surge protector or uninterruptible power

supply (UPS).

6. Do not block the projection lens with any

objects when the projector is under

operation as this could cause the

objects to become heated and deformed

or even cause a fire. To temporarily turn

off the light source, press the Eco Blank

button.

2. Do not look straight at the projector lens

during operation. The intense light beam

may damage your eyes.

3. Refer servicing to qualified service

personnel.

4. The light source becomes extremely hot

during operation.

5Important safety instructions

7. Do not operate light sources beyond the

rated light source life.

8. Do not place this product on an

unstable cart, stand, or table. The

product may fall, sustaining serious

damage.

9. Do not attempt to disassemble this

projector. There are dangerous high

voltages inside which may cause death

if you should come into contact with

live parts.

Under no circumstances should you

ever undo or remove any other covers.

Refer servicing only to suitably qualified

professional service personnel.

10. Do not block the ventilation holes.

- Do not place this projector on a blanket,

bedding or any other soft surface.

- Do not cover this projector with a cloth or

any other item.

- Do not place inflammables near the

projector.

If the ventilation holes are seriously

obstructed, overheating inside the

projector may result in a fire.

11. Always place the projector on a level,

horizontal surface during operation.

12. Do not stand the projector on end

vertically. Doing so may cause the

projector to fall over, causing injury or

resulting in damage to the projector.

6 Important safety instructions

13. Do not step on the projector or place any

objects upon it. Besides probable

physical damage to the projector, doing

so may result in accidents and possible

injury.

14. Do not place liquids near or on the

projector. Liquids spilled into the

projector may cause it to fail. If the

projector does become wet, disconnect

it from the power supply's power outlet

and call BenQ to have the projector

serviced.

15. This product is capable of displaying

inverted images for ceiling mount

installation.

16. This apparatus must be earthed.

17. When the projector is under operation,

you may sense some heated air and

odor from its ventilation grill. It is a

normal phenomenon and not a product

defect.

18. Do not place this projector in any of the

following environments.

- Space that is poorly ventilated or confined.

Allow at least 50 cm clearance from walls

and free flow of air around the projector.

- Locations where temperatures may

become excessively high, such as the

inside of a car with all windows rolled up.

- Locations where excessive humidity, dust,

or cigarette smoke may contaminate

optical components, shorten the

projector's life span and darken the image.

- Locations near fire alarms

- Locations with an ambient temperature

above 40°C / 104°F

- Locations where the altitudes are higher

than 3000 m (10000 feet).

Risk Group 2

1. According to the classification of

photobiological safety of light source

and light source systems, this product is

Risk Group 2, IEC 62471-5:2015.

2. Possibly hazardous optical radiation

emitted from this product.

3. Do not stare at operating light source.

May be harmful to the eyes.

4. As with any bright source, do not stare

into the direct beam.

To avoid damaging the DLP chips, never aim a

high-power laser beam into the projection lens.

7Introduction

Introduction

Shipping contents

Carefully unpack and verify that you have all of the items shown below. If any of these items are

missing, please contact your place of purchase.

Standard accessories

Replacing the remote control batteries

1. Press and slide off the battery cover, as

illustrated.

2. Remove the old batteries (if applicable) and

install two AAA batteries. Make sure that

the positive and negative ends are

positioned correctly, as illustrated.

3. Slide the battery cover in until it clicks into

place.

Projector Remote control with

batteries Power cord Adjustment feet kit

Quick start guide Regulatory

statements

QS02 HDMI Media

Streaming Warranty card*

• The supplied accessories will be suitable for your region, and may differ from those illustrated.

• *The warranty card is only supplied in some specific regions. Please consult your dealer for detailed

information.

8 Introduction

Installing the QS02 HDMI Media Streaming

The supplied QS02 HDMI Media Streaming is an Android TV (ATV) dongle to be used with the

projector. See the instructions below to install the dongle. With a successful installation, you

can enjoy more entertainment programs through this projector.

• Avoid leaving the remote control and batteries in an excessive heat or humid environment like the

kitchen, bathroom, sauna, sunroom or in a closed car.

• Replace only with the same or equivalent type recommended by the battery manufacturer.

• Dispose of the used batteries according to the manufacturer's instructions and local environment

regulations for your region.

• Never throw the batteries into a fire. There may be danger of an explosion.

• If the batteries are dead or if you will not be using the remote control for an extended period of time,

remove the batteries to avoid damage to the remote control from possible battery leakage.

1. Make sure the projector is turned off and

the power cord is disconnected. 3. Plug the USB Micro B cable to the dongle .

Plug the dongle to the HDMI* port on the

projector .

*This HDMI port is for connecting QS02 HDMI Media

Streaming only.

2. Loosen the screws that secure the top of

projector cover . Slide to remove the

cover .

4. Replace the projector cover, and tighten the

screws.

5. Connect the power cord to the projector and

turn it on. Press to select Android TV.

*This is used to hold the USB plug when shipped.

Do not route the cable here.

9Introduction

Projector exterior view

1. Lens shift adjustment knob

Adjusts the vertical position of the

projected image.

2. External control panel

See Controls and functions on page 11.

3. Zoom ring/Focus ring

4. Vent (air inlet)

5. LIGHT/TEMP/POWER status indicator

See Indicators on page 54.

6. Projection lens

7. IR remote sensor

8. Adjuster feet

9. Connector panel

See Terminals on page 10.

10. Speaker grill

11. AC power jack

12. Kensington anti-theft lock slot

13. Vent (air exhaust)

14. Ceiling mount holes

15. Anti-theft security bar

10 Introduction

Terminals

1. HDMI input port (Version 2.0b)

2. HDMI input port (Version 2.0b)

3. 12V DC output terminal

Triggers external devices such as an

electric screen or light control, etc.

4. USB 2.0 Type-A port (Firmware upgrade,

Media Reader)

5. SPDIF audio output port

6. RS-232 control port

7. Audio output jack

12 3 4 567

Table des matières

Autres manuels BenQ Projecteur

BenQ

BenQ W1110s Manuel utilisateur

BenQ

BenQ MX723 Manuel utilisateur

BenQ

BenQ LU960UST Manuel utilisateur

BenQ

BenQ LU9715 Manuel utilisateur

BenQ

BenQ LW500 Manuel utilisateur

BenQ

BenQ MX768 Manuel utilisateur

BenQ

BenQ LX770 Manuel d'exploitation et d'entretien

BenQ

BenQ DX832UST Manuel utilisateur

BenQ

BenQ EH620 Manuel utilisateur

BenQ

BenQ MX716 Manuel utilisateur

BenQ

BenQ PE8700 Manuel utilisateur

BenQ

BenQ SP891 Manuel utilisateur

BenQ

BenQ MX661 Manuel utilisateur

BenQ

BenQ W703D Instructions d'utilisation

BenQ

BenQ MP780 ST Manuel utilisateur

BenQ

BenQ W1000 Manuel utilisateur

BenQ

BenQ L720 Series Manuel utilisateur

BenQ

BenQ MX722 Manuel utilisateur

BenQ

BenQ MX766 Manuel utilisateur

BenQ

BenQ MX815ST Manuel utilisateur

BenQ

BenQ M73 Series Manuel utilisateur

BenQ

BenQ W750 Manuel utilisateur

BenQ

BenQ W1600UST Manuel utilisateur

BenQ

BenQ MP730 - WXGA DLP Projector Manuel utilisateur

Manuels Projecteur populaires d'autres marques

iEmmet

iEmmet MP-312 Manuel utilisateur

Epson

Epson VS400 Manuel utilisateur

Sony

Sony VPL-HS10 Marketing Specifications & Features Manuel utilisateur

Sony

Sony VPL-HW65ES Manuel de service

Toshiba

Toshiba TLP-791U Manuel utilisateur

Philips

Philips LC1341 Guide de référence

Panasonic

Panasonic PTL735NTU - LCD PROJECTOR-NETWORK IB Manuel utilisateur

NEC

NEC NP600S EDU Manuel utilisateur

Eiki

Eiki EK-623U series Manuel utilisateur

Epson

Epson PowerLite Pro Cinema 6020UB Manuel utilisateur

Epson

Epson PowerLite Home Cinema 705HD Manuel utilisateur

Christie

Christie LHD700 Manuel utilisateur

Navitar

Navitar FX Manuel utilisateur

InFocus

InFocus LitePro 560 Manuel utilisateur

Sony

Sony SRX-R815P Manuel utilisateur

Vivitar

Vivitar DP1500 X Manuel utilisateur

Acer

Acer C20 Series Manuel utilisateur

Asus

Asus ZenBeam Latte Manuel utilisateur

BenQ x3100i Manuel utilisateur

Manuels Projecteur populaires d'autres marques