AXIOMTEK MPC225-851 Series Manuel utilisateur

MPC225-851 Series

22” TFT Fanless Super Slim Medical

Grade Panel Computer with Intel○R

CoreTM 2 Duo Processor

User’s Manual

Disclaimers

This manual has been carefully checked and believed to contain

accurate information. AXIOMTEK Co., Ltd. assumes no responsibility

for any infringements of patents or any third party’s rights, and any

liability arising from such use.

AXIOMTEK does not warrant or assume any legal liability or

responsibility for the accuracy, completeness or usefulness of any

information in this document. AXIOMTEK does not make any

commitment to update the information in this manual.

AXIOMTEK reserves the right to change or revise this document

and/or product at any time without notice.

No part of this document may be reproduced, stored in a retrieval

system, or transmitted, in any form or by any means, electronic,

mechanical, photocopying, recording, or otherwise, without the prior

written permission of AXIOMTEK Co., Ltd.

January 2010, Version A1

Printed in Taiwan

iii

Safety Approvals

CE Marking

EN60601-1, UL60601-1

FCC Class B

FCC Compliance

This equipment has been tested in compliance with the limits for a

Class A digital device, pursuant to Part 15 of the FCC Rules. These

limits are meant to provide reasonable protection against harmful

interference in a residential installation. If not installed and used in

accordance with proper instructions, this equipment might generate or

radiate radio frequency energy and cause harmful interference to

radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment

does cause harmful interference to radio or television reception, which

can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the

following methods:

1. Reorient or relocate the receiving antenna.

2. Increase the separation between the equipment and receiver.

3. Connect the equipment to another outlet of a circuit that

doesn’t connect with the receiver.

4. Consult the dealer or an experienced radio/TV technician for

help.

Shielded interface cables must be used in order to comply with the

emission limits.

Safety Precautions

Before getting started, read the following important safety precautions.

1. The MPC225-851 Series does not come equipped with an

operating system. An operating system must be loaded first

before installing any software into the computer.

2. Be sure to ground yourself to prevent static charge when

installing the internal components. Use a grounding wrist

strap and place all electronic components in any static-

shielded devices. Most electronic components are sensitive

to static electrical charge.

3. Disconnect the power cord from the MPC225-851 Series

before any installation. Be sure both the system and external

devices are turned OFF. A sudden surge of power could ruin

sensitive components that the MPC225-851 Series must be

properly grounded.

4. Make sure it is the correct voltage of the power source

before connecting the equipment to the power outlet.

5. The brightness of the flat panel display will be getting weaker

as a result of frequent usage. However, the operating period

varies depending on the application environment.

6. Turn OFF the system power before cleaning. Clean the

system using a cloth only. Do not spray any liquid cleaner

directly onto the screen. The MPC225-851 Series may come

with or w/o a touchscreen. Although the touchscreen is

chemical resistant, it is recommended that you spray the

liquid cleaner on a cloth first before wiping the screen. In

case your system comes without the touchscreen, you must

follow the same procedure and not spray any cleaner on the

flat panel directly.

7. Avoid using sharp objects to operate the touchscreen.

Scratches on the touchscreen may cause malfunction or

internal failure to the touchscreen.

8. The flat panel display is not susceptible to shock or vibration.

When assembling the MPC225-851 Series, make sure it is

securely installed.

9. Do not leave this equipment in an uncontrolled environment

where the storage temperature is below -20℃or above 60℃.

It may damage the equipment.

10. External equipment intended for connection to signal

input/out or other connectors shall comply with relevant

UL/IEC standard.

11. Do not open the system’s back cover. If opening the cover

for maintenance is a must, only a trained technician is

allowed to do so. Integrated circuits on computer boards are

sensitive to static electricity. To avoid damaging chips from

electrostatic discharge, observe the following precautions:

zBefore handling a board or integrated circuit, touch an

unpainted portion of the system unit chassis for a few

seconds. This will help to discharge any static

electricity on your body.

zWhen handling boards and components, wear a wrist-

grounding strap, available from most electronic

component stores.

Classification

1. Degree of production against electric shock: not classified

2. Degree of protection against the ingress of water: IPX1

3. Equipment not suitable for use in the presence of a

flammable anesthetic mixture with air or with oxygen or

nitrous oxide.

4. Mode of operation: Continuous

5. Type of protection against electric shock: Class I equipment

General Cleaning Tips

You may need the following precautions before you begin to clean the

computer. When you clean any single part or component for the

computer, please read and understand the details below fully.

1. When you need to clean the device, please rub it with a

piece of dry cloth.

2. Be cautious of the tiny removable components when you

use a vacuum cleaner to absorb the dirt on the floor.

3. Turn the system off before you start to clean up the

component or computer.

4. Never drop the components inside the computer or get

circuit board damp or wet.

5. Be cautious of all kinds of cleaning solvents or chemicals

when you use it for the sake of cleaning. Some individuals

may be allergic to the ingredients.

6. Try not to put any food, drink or cigarette around the

computer.

Cleaning Tools:

Although many companies have created products to help improve the

process of cleaning your computer and peripherals users can also

use household items to clean their computers and peripherals. Below

is a listing of items you may need or want to use while cleaning your

computer or computer peripherals.

Keep in mind that some components in your computer may only be

able to be cleaned using a product designed for cleaning that

component, if this is the case it will be mentioned in the cleaning.

zCloth: A piece of cloth is the best tool to use when rubbing

up a component. Although paper towels or tissues can be

used on most hardware as well, we still recommend you to

rub it with a piece of cloth.

zWater or rubbing alcohol: You may moisten a piece of cloth

a bit with some water or rubbing alcohol and rub it on the

computer. Unknown solvents may be harmful to the plastics

parts.

zVacuum cleaner: Absorb the dust, dirt, hair, cigarette

particles, and other particles out of a computer can be one

of the best methods of cleaning a computer. Over time

these items can restrict the airflow in a computer and cause

circuitry to corrode.

vii

zCotton swabs: Cotton swaps moistened with rubbing alcohol

or water are excellent tools for wiping hard to reach areas in

your keyboard, mouse, and other locations.

zFoam swabs: Whenever possible it is better to use lint free

swabs such as foam swabs.

Note We strongly recommended that you should shut down

the system before you start to clean any single

components.

Please follow the steps below:

1. Close all application programs

2. Close operating software

3. Turn off power switch

4. Remove all device

5. Pull out power cable

viii

Scrap Computer Recycling

If the computer equipments need the maintenance or are beyond

repair, we strongly recommended that you should inform your

Axiomtek distributor as soon as possible for the suitable solution. For

the computers that are no longer useful or no longer work well, please

contact your Axiomtek distributor for recycling and we will make the

proper arrangement.

Trademarks Acknowledgments

AXIOMTEK is a trademark of AXIOMTEK Co., Ltd.

IBM, PC/AT, PS/2, VGA are trademarks of International

Business Machines Corporation.

Intel®and Pentium®are registered trademarks of Intel Corporation.

MS-DOS, Microsoft C and QuickBASIC are trademarks of Microsoft

Corporation.

VIA is a trademark of VIA Technologies, Inc.

SST is a trademark of Silicon Storage Technology, Inc.

UMC is a trademark of United Microelectronics Corporation.

Other brand names and trademarks are the properties and registered

brands of their respective owners.

Table of Contents

Disclaimers..........................................................................ii

Safety Approvals.................................................................iii

Safety Precautions..............................................................iv

Classification ...................................................................... v

General Cleaning Tips........................................................vi

Scrap Computer Recycling...............................................viii

CHAPTER 1 INTRODUCTION .......................................1

1.1 General Description............................................1

1.2 Features..............................................................2

1.3 System Specifications.........................................2

1.4 Dimensions.........................................................5

1.5 I/O Outlets...........................................................6

1.6 Packing List ........................................................8

CHAPTER 2 HARDWARE INSTALLATION..................10

2.1 DRAM Installation.............................................10

2.2 Hard Disk Drive Installation ..............................15

2.3 CF Card Installation..........................................20

2.4 Serial Ports Interface........................................23

2.5 Wireless Module Installation (Optional)............25

2.6 Add-on card Installation (Optional)...................29

2.7 Mount................................................................33

2.6.1 Wall mount................................................................ 33

2.6.2 VESA Mount ............................................................. 34

2.6.3 Desktop Stand (Optional) ......................................... 35

CHAPTER 3 BIOS SETUP UTILITY.............................40

3.1 Starting .............................................................40

3.2 Navigation Keys................................................40

3.3 Main Menu........................................................42

3.4 Advanced Menu................................................43

3.5 Boot Menu ........................................................53

3.6 Security Menu...................................................55

3.7 Chipset Menu....................................................57

3.8 Exit Menu..........................................................60

CHAPTER 4 DRIVER INSTALLATION.........................62

4.1 System..............................................................62

4.2 Touch Screen ...................................................63

4.2.1 Specification.............................................................. 63

4.2.2 Driver Installation...................................................... 64

Table des matières

Autres manuels AXIOMTEK Écran tactile

AXIOMTEK

AXIOMTEK IFO2225-830 Series Manuel utilisateur

AXIOMTEK

AXIOMTEK ITC150WM Manuel utilisateur

AXIOMTEK

AXIOMTEK FDK series Manuel utilisateur

AXIOMTEK

AXIOMTEK GOT3187WL-834-PCT Manuel utilisateur

AXIOMTEK

AXIOMTEK MPC170-831-DC Manuel utilisateur

AXIOMTEK

AXIOMTEK GOT318W-521-PCT Manuel utilisateur

AXIOMTEK

AXIOMTEK P1157E-871 Manuel utilisateur

AXIOMTEK

AXIOMTEK GOT615-801 Manuel utilisateur

AXIOMTEK

AXIOMTEK GOT3126T-834 Manuel utilisateur

AXIOMTEK

AXIOMTEK PANEL5150-675 Manuel utilisateur

AXIOMTEK

AXIOMTEK GOT812W-511 Manuel utilisateur

AXIOMTEK

AXIOMTEK PANEL1127-671 Manuel utilisateur

AXIOMTEK

AXIOMTEK P1177E-871 Manuel utilisateur

AXIOMTEK

AXIOMTEK GOT115-319 Manuel utilisateur

AXIOMTEK

AXIOMTEK GOT5840T-832 Manuel utilisateur

AXIOMTEK

AXIOMTEK GOT3157W-834-PCT Manuel utilisateur

AXIOMTEK

AXIOMTEK GOT-3156TL-830 Manuel utilisateur

AXIOMTEK

AXIOMTEK GOT107W-319 Manuel utilisateur

AXIOMTEK

AXIOMTEK GOT315W-521-PCT Manuel utilisateur

AXIOMTEK

AXIOMTEK OPS883-H Series Manuel utilisateur

AXIOMTEK

AXIOMTEK P1177E-842 Manuel utilisateur

AXIOMTEK

AXIOMTEK GOT3217WL-845-PCT Manuel utilisateur

AXIOMTEK

AXIOMTEK MPC103-845 Manuel utilisateur

AXIOMTEK

AXIOMTEK GOT-3100T Manuel utilisateur

Manuels Écran tactile populaires d'autres marques

FlowLine

FlowLine Data loop Manuel utilisateur

ALPEX

ALPEX AEx-8 P Series Manuel utilisateur

Ltech

Ltech E5S Manuel utilisateur

Harman

Harman AMX MODERO S MSD-701-L2 Manuel utilisateur

Acnodes

Acnodes PC 1150 Manuel utilisateur

AIS

AIS IP10IA99 series Manuel utilisateur

IBASE Technology

IBASE Technology ASTUT-152-RE1S Manuel utilisateur

YASKAWA

YASKAWA TP 610C Manuel utilisateur

B&R

B&R Power Panel C Series Manuel utilisateur

Beijer Electronics

Beijer Electronics X2 control Manuel utilisateur

TRIDONIC.ATCO

TRIDONIC.ATCO x-touchBOX Manuel utilisateur

Qomo

Qomo QIT1386 Manuel utilisateur

DFI

DFI KS104-CD Manuel utilisateur

AMX

AMX AXP-PPC Mode d’emploi

Sartorius

Sartorius X3 PR 5410 Manuel utilisateur

AMX

AMX Modero X Series Manuel utilisateur

Advantech

Advantech TPC-30 Series Manuel utilisateur

B&R Industries

B&R Industries MAPPC900-ENG Manuel utilisateur