Audio Technica ATW-600 Manuel d'utilisation

AUDIO TECHNICA MODEL ATW-600

UHF WIRELESS MICROPHONE SYSTEM

USER INFORMATION.

INTRODUCTION

Thank you for purchasing the ATW-600 series wireless microphone system. It is our hope that the

system will bring you years of trouble free pleasure and performance. Please follow the information

contained in this manual closely as it will assist you in using your equipment effectively.

PART1. REGULATORY REQUIREMENTS.

FCC PART 15 COMPLIANCE STATEMENT

CANADARSS-210 COMPLIANCE STATEMENT

“This device complies with Part 15 of the FCC rules. Operation is subject to the condition that this

device does not cause harmful interference”

“This device complies with INDUSTRY CANADA R.S.S. 210, en confomite avec IC: RSS-210/CNR210.

Operation is subject to the followingconditions: (1) This device may not cause harmful interference and

(2) This device must accept any interference received, including interference which may cause

undesired operation.”

Please note that your ATW-600 system operates in a frequency band in a way, which may make its use

subject to certain FCC and other regulatory agency restrictions and licensing requirements. For further

information, Please contact your local office of the FCC as applicable.

PART 2. USING THE ATW-T601 BELT PACK TRANSMITTER

The belt pack transmitter operates on one 9V batteries. Please make sure that your batteries are fresh.

We recommend that you use Alkaline batteries and that you avoid using NiCad if possible.

Remove the battery cover, insert the battery into the battery compartment.

Locate channels selector switch inside of the battery cover, set the channels to the corresponding

channel as set on receiver.

Connect your microphone or guitar cable to the connector on the topside of the transmitter.

Turn the transmitter switch to the on position. Confirm that the receiver is receiving RF and the audio is

passing through the receiver.

You are now set to use the system.

PART 3. USING THE ATW-T602 HANDHELD TRANSMITTER

The handheld transmitter operates on one 9V battery. Please make sure that your batteries are fresh.

We recommend that you use Alkaline batteries and that you avoid using NiCad if possible.

Remove the battery cover by unscrew and pull the cover off and insert the battery into the battery

compartment and screw the battery compartment back into place.

To change the cannel of operation, unscrew the battery cover and pull the cover off

Locate the cannel selector rotary switches. Set the channel to the corresponding channel as set on

receiver. Replace cover over the rotary switches.

Turn the transmitter switch to the on position. Confirm that the receiver is receiving RF. Speak directory

into the microphone and confirm audio is passing through the receiver

You are now set to use the system.

PART4. USING THE ATW-R600 RECEIVER

The ATW-R600 receiver operates with AC adapter supplied . Connect AC adapter DC output plug to

receiver DC in jack and AC cable to adapter AC plug. Plug the other end of AC cable into an AC outlet.

Confirm that the LED comes on. Check the cannel setting to confirm that they correspond to the

settings of the transmitter

Connect the unbalanced audio output to your mixer or PA system. Adjust the receiver and mixer of PA

system volume setting to the desired level. Speak into the microphoneand listen to the audio out at the

speaker. If satisfied with the audio quality, you can use the system.

Table des matières

Autres manuels Audio Technica Système de microphone

Audio Technica

Audio Technica Pro Series 3 Manuel du propriétaire

Audio Technica

Audio Technica ATW-901a/L Manuel utilisateur

Audio Technica

Audio Technica ATW-U101 Manuel du propriétaire

Audio Technica

Audio Technica AT2020USB-X Manuel utilisateur

Audio Technica

Audio Technica UniPak ATW-1661 Manuel du propriétaire

Audio Technica

Audio Technica ATW-DA49b Manuel utilisateur

Audio Technica

Audio Technica ATW-1101 Manuel du propriétaire

Audio Technica

Audio Technica Professional 2000 Series Manuel utilisateur

Audio Technica

Audio Technica ATW-3110A Manuel utilisateur

Audio Technica

Audio Technica ATW-0951 Manuel du propriétaire

Audio Technica

Audio Technica ATW-A49 Manuel du propriétaire

Audio Technica

Audio Technica Pro Series 5 Manuel du propriétaire

Audio Technica

Audio Technica AT-ATW-2110Bl Manuel utilisateur

Audio Technica

Audio Technica Freeway ATW-251 Manuel du propriétaire

Audio Technica

Audio Technica ATCS-60 Manuel utilisateur

Audio Technica

Audio Technica ATW-DA600 Manuel du propriétaire

Audio Technica

Audio Technica p51857_1800 Guide de configuration

Audio Technica

Audio Technica ATW-3110C Manuel

Audio Technica

Audio Technica GENUINE AT8688 Manuel utilisateur

Audio Technica

Audio Technica 2000 Series Manuel du propriétaire

Audio Technica

Audio Technica 3000 Series Manuel utilisateur

Audio Technica

Audio Technica AEW-4100 Series Manuel d'utilisation

Audio Technica

Audio Technica ATW-A10 Manuel du propriétaire

Audio Technica

Audio Technica ATW-1235 Manuel du propriétaire

Manuels Système de microphone populaires d'autres marques

Paso

Paso R824 Manuel utilisateur

Naxa

Naxa NAM-982 Manuel utilisateur

Motorola

Motorola PMNN4461 Manuel utilisateur

Xvive

Xvive U3 Manuel utilisateur

Tekon

Tekon DUOS Manuel utilisateur

Heyuan Intelligence

Heyuan Intelligence IOT-G2S-01 Manuel utilisateur

Devine

Devine WMD-IE Manuel utilisateur

LG LF-D7150 Manuel utilisateur

GE S768DAV Manuel utilisateur

LD U305 HBH 2 Manuel utilisateur

Chainway

Chainway URA8 Manuel utilisateur

ORATOR

ORATOR D860TD Manuel utilisateur

Sennheiser

Sennheiser Evolution Wireless Digital EW-DX EM 2 Manuel utilisateur

Alpha Technologies

Alpha Technologies RBMS Manuel utilisateur

SWIT Electronics Co.,LTD.

SWIT Electronics Co.,LTD. CW-S150 Manuel utilisateur

Shure

Shure UA844 Manuel utilisateur

Panasonic

Panasonic SHFX70 - DVD HOME THEATER WIRELESS SYSTEM Manuel utilisateur

Pyle

Pyle PDWM5000 Manuel utilisateur