ARIESAUTOMOTIVE.COM • NEED ASSISTANCE? • 800.798.0813 • 2500201-INS-RF • PAGE 2
Step 1
To install the rear fender flares, remove
all push-in retainers. Take care not to
damage the plastic inner fender flare.
Using a 10mm socket, remove all hex
bolts. Remove the stock fender flare.
Step 2
Hold the ARIES rear fender against the
body to check alignment with factory
holes and mark the mounting locations.
Step 3
If one of mounting points do not line up
with a factory hole, mark a new mounting
location. Drill a new hole at the marked
location using a 25/64" or 10mm drill bit.
Check to make sure that the threaded
metal insert will fit.
Do not make the holes larger than
required or the rivnuts my fail to install.
Step 4
If a plier-style thread-set will be used
to install the rivnuts proceed to the
installation locations in step 5.
Screw the left handed nut completely
onto the thread-set tool. Slide the metal
spacer onto the larger thread until it rests
against the M8 left hand nut.
Place an M6 flat washer on the
small thread followed by an M6 rivnut.
Thread the rivnut onto the small end
of the tool until it seats the washer
against the shoulder between the
M6 and M8 threads.
