Advantech MIO-5377 Manuel d'installation et d'exploitation

MIO-5377 Startup Manual 1

Before you begin installing your card, please make sure that

the following items have been shipped:

1. 1 x MIO-5377 SBC

2. 1 x SATA cable 30 cm (p/n: 1700006291)

3. 1 x SATA power cable 35 cm (p/n: 1700031583-01)

4. 1 x USB 2.0 cable 20 cm (p/n: 1700030406-01)

5. 1 x Audio cable 20 cm (p/n: 1700019584-01)

6. 2 x COM RS-232/422/485 Cable 20 cm (p/n:

1700030404-01)

7. 2 x COM RS-232 cable 20 cm (p/n: 1700031582-01)

8. 1 x Cooler (p/n: 1970005512T001) or 1 x heatsink

(1970005548T001))

9. 1 x Startup manual (p/n: 2046537700)

10. 1 x Screw kit (3 x screws for M.2 device & 4 x screws

and stand-o󰀨s for heatsink/cooler)

11. 1 x DeviceOn Package

If any of the above items are missing or damaged, contact

your distributor or sales representative immediately.

Note1: For detailed contents regarding MIO-5377,

please refer to information on the support web-

site: http://support.advantech.com.tw/.

Note2: Adobe Reader is required to view any PDF le.

Adobe Reader can be downloaded at: http://get.

adobe.com/tw/reader/otherversions/. (Adobe is

the trademark of Adobe Systems Incorporated.)

MIO-5377 3.5” MI/O-Compact SBC, 12th Gen.

Intel®Core™ P/U-series (i7/i5/i3/Celeron®)

Startup Manual

• CPU:

- Intel®i7-1270PE (4P+8E Core, 1.80 GHz)

- Intel®i7-1265UE (2P+8ECore, 1.70 GHz)

- Intel®i5-1245UE (2P+8ECore, 1.50 GHz)

- Intel®i3-1215UE (2P+4ECore, 1.20 GHz)

- Intel®7305E (1P+4ECore, 1.00 GHz)

• SystemMemory:Dual Channel DDR5-4800 up to 64GB

• BIOS:AMI EFI 256 Mbit

• Watchdogtimer: 65536 level, 0~65535 sec

• TPM2.0

• iManager3.0:Yes

• Battery: Lithium 3V/210mAH

• Audio:Supports high denition audio (HD), line-in,

lineout, and mic-in

• ExpansionInterface:

- 1 x M.2 E-Key 2230 (PCIe x1, USB 2.0 to support

wireless module)

- 1 x M.2 B-Key 3042/3052 (PCIex1, SATA, USB2.0);

default with 3042 module length

- 1 x M.2 M-Key 2280 (PCIe x4 Gen.4 for PCIe SSD)

Display

• Controller: Intel®SoC integrated Iris®Xe graphics

• Maximumresolution:

- LCD: Dual channel 18/24-bit, up to 1920 x 1200

- HDMI: 1 x HDMI 2.0b, up to 4096 x 2160 @60Hz

- DP: 1 x DP1.4a, up to 4096 x 2304 @60Hz

• Multipledisplay:Four simultaneous displays via LVDS,

HDMI, DP, Type-C Alt.DP

EthernetInterface

• Speed: 10/100/1000/2500 Mbps

• Controller: LAN1: Intel i219LM, LAN2: Intel i226

I/O

• InternalI/O:1 x SATA, 2 x USB 2.0, 2 x RS-232/422/485,

2 x RS-232 (4-wire), 3 x I2C, 8-bit GPIO, Inverter, HD

Audio, LVDS, 2x CAN, 1 x FAN, 1 x USB4

• RearI/O: 2 x RJ-45, 1 x HDMI, 1 x DP, 1 x USB Type-C, 4

x USB3.2, 1 x DC-Jack (optional)

• Powerconnectortype: Default supports 2 x 2-pin ATX

power connector (90D), DC jack is supported by request

• Optional: DC-IN Jack

MechanicalandEnvironmental

• Dimensions(LxW): 146 x 102 mm (5.7” x 4”)

• Powersupplytype: ACPI supports for ATX only

• Powerrequirement:Vin: 12V-24V +/- 10%

• Operatingtemperature:Standard: 0 ~ 60°C (32 ~

140°F)

• NetWeight:0.67 kg/1.47 lb (reference weight of total

package)

GeneralPackingList

For more information about this and other Advantech

products, visit our website at

http://www.advantech.com

http://www.advantech.com/eplatform

For technical support and customer service, visit our

support website at

http://support.advantech.com

This manual is for the MIO-5377 Series.

Part No. 2046537700

Printed in China

Edition 1

February 2023

2 MIO-5377 Startup Manual

The board has a number of jumpers that allow you to con-

gure your system to suit your application. The table below

lists the function of each of the jumpers and connectors.

Jumpers

Label

Function

VDD1 LVDS Panel Voltage Selection

Jumper

J1 AT mode /Load BIOS default

JumperSetting

VDD1 PanelVoltageSelectionJumper

Setting Function

JumperShort PanelVoltage

1-3

+3.3V (Default)

3-5

+5V

3-4

+12V

J1 ATmode/LoadBIOSdefault

Setting Function

JumperShort PanelFunctional

1-2

1-2 open: ATX mode

1-2 short: AT mode(default)

3-4

Normal_BIOS (default)

5-6

5-6 open: Normal (default)

5-6 short: Load BIOS default

To load factory defaults, follow this:

1. Power o󰀨

2. Remove the Jumper (3-4) and add to (5-6), then power

on.

BIOS will load factory defaults (does not clear time or

clear CMOS), a message will remind the user to shut

down system and restore Jumper (3-4).

3. Power on again.

If you want to Clear CMOS, remove battery (battery 1).

System will pop up a message, then wait for 3 seconds.

RTC time will clear but keep the BIOS settings

Caution: The computer is provided with a battery-power

real-time clock circuit. There is a danger of explo-

sion if battery is incorrectly replaced.

Replace only with same or equivalent type

recommended by the manufacturer. Discard

used batteries according to manufacturer’s

instructions.

JumpersandConnectors JumpersandConnectors(Cont.)

MIO-5377 Startup Manual 3





Connectors

Locations

Figure 1: MIO-5377 Connector Locations (Top Side)

Figure 2: MIO-5377 Connector Locations (Bottom Side)

4 MIO-5377 Startup Manual

Connectors

Label

Function

CN10 DC Power Input Connector (90D)

CN10_1 DC Power Input Connector (180D)

CN11 DC Jack

D33 Power & SATA LED

LAN1 I219 RJ45 LAN Ports

LAN2 i226 RJ45 LAN Ports

TYPEC1 TypeC Port (USB3.2/DP)

DP1 Display Port Connector

HDMI1 HDMI Connector

USB1 USB3.2 Connector

USB2 USB3.2 Connector

CN3 CAN Bus Port 1

CN2 CAN Bus Port 0

CN8 SOC_I2C Port1

CN7 SOC_I2C Port0

CN6 EC_I2C Port

BL1 Panel Inverter Connector

FAN Smart FAN

J1 AT mode /Load BIOS default





Connectors

Locations(Cont.)

VDD1 Panel Voltage Selection Jumper

LVDS1 LVDS Connector

USB3 USB2.0 Internal Connector

AUDIO1 Audio Internal Connector

SATA1 SATA Connector

SATAP1 SATA Power Connector

TYPEC2 TypeC Port (TBT4)

COM1 COM Port Internal Connector 1

CN4 Front Panel Internal Connector

COM2 COM Port Internal Connector 2

CN5 GPIO Internal Connector

U14 DDR5 SO-DIMM slot #1

U15 DDR5 SO-DIMM slot #2

M2_1 M.2 Key-E Connector

COM4 COM Port Internal Connector 4

COM3 COM Port Internal Connector 3

BAT1 RTC Battery Connector

M2_2 M.2 Key-M Connector

M2_B1 M.2 Key-B Connector

SIM1 NANO SIM





QuickInstallationGuide

Retrieve the heatsink from the accessory box. Remove the release paper from the thermal pads.





Connectors

Locations(Cont.)

Autres manuels pour MIO-5377

Autres manuels Advantech Matériel informatique

Advantech

Advantech AdvLinuxTU Manuel utilisateur

Advantech

Advantech ACP-7000 Manuel utilisateur

Advantech

Advantech PCA-6742 Series Manuel d'installation et d'exploitation

Advantech

Advantech MIC-7 Series Manuel d'installation et d'exploitation

Advantech

Advantech POC-615 Series Manuel utilisateur

Advantech

Advantech PCA-6751 Series Manuel utilisateur

Advantech

Advantech PCE-7132 Manuel d'installation et d'exploitation

Advantech

Advantech PCE-7B17-00A1E Manuel d'installation et d'exploitation

Advantech

Advantech PCA-6006 Manuel utilisateur

Advantech

Advantech PCA-6010 Manuel utilisateur

Advantech

Advantech ROM-5420 Manuel utilisateur

Advantech

Advantech ITA-2230 Series Manuel d'installation et d'exploitation

Advantech

Advantech AiMC-2000 Manuel utilisateur

Advantech

Advantech PCA-6144S Manuel utilisateur

Advantech

Advantech SKY-MXM-T1000 Manuel utilisateur

Advantech

Advantech MIO-2375 Manuel utilisateur

Advantech

Advantech AIMB-723 Manuel utilisateur

Advantech

Advantech PCLD-8751 Manuel utilisateur

Advantech

Advantech FWA-3270A Manuel d'installation et d'exploitation

Advantech

Advantech PCE-3B06-02 Manuel d'installation et d'exploitation

Advantech

Advantech ASMB-830 Series Manuel utilisateur

Advantech

Advantech PCE-5133 Manuel d'installation et d'exploitation

Advantech

Advantech MIC-710AIL Manuel utilisateur

Advantech

Advantech SOM-4450 ETX Manuel utilisateur

Manuels Matériel informatique populaires d'autres marques

EMC2

EMC2 VNX Series Manuel du propriétaire

Panasonic

Panasonic DV0PM20105 Manuel utilisateur

Mitsubishi Electric

Mitsubishi Electric Q81BD-J61BT11 Manuel utilisateur

Gigabyte

Gigabyte B660M DS3H AX DDR4 Manuel utilisateur

Raidon

Raidon iT2300 Manuel utilisateur

National Instruments

National Instruments PXI-8186 Manuel utilisateur

Hauppauge

Hauppauge WinTV-HVR-2250 Manuel utilisateur

Kontron

Kontron CP6002 Manuel utilisateur

Manhattan

Manhattan 702843 Manuel utilisateur

Aphex

Aphex 230 Manuel utilisateur

AMD

AMD Phenom II Manuel d'exploitation

Intel

Intel NUC 12 Pro Manuel utilisateur

dbx

dbx Zone Pro 1260 Manuel utilisateur

Galaxy

Galaxy GHDX2-2430S-24F4D Manuel utilisateur

Intel

Intel AXXRMFBU4 Manuel utilisateur

Kontron

Kontron DIMM-PC/MD Manuel utilisateur

ST X-NUCLEO-SAFEA1B Mode d'emploi

STEINWAY LYNGDORF

STEINWAY LYNGDORF SP-1 Manuel utilisateur