Adaptec AFM-600 Manuel utilisateur

Installation Instructions

Adaptec Flash Backup Module AFM-600 for Adaptec Unified Serial™RAID Controllers

some jurisdictions.

Part Number: MAN-00260-01-A Rev B

Using the appropriate static protection, remove the controller from your computer.

1Insert screws through the bottom of the controller board, as shown in Figure 1.

Then, insert spacers on the screws.

2Attach the AFM-600DB (daughterboard) to the controller by mating the two black

connectors. Affix a hex nut to the end of each of the screws, as shown in Figure 2.

Caution: The torque should be less than 0.06Nm to avoid deformation. Do not use a

tool to hold the nut in place to avoid damaging the semi-conductor components on the

daughterboard near the screw holes. Be sure that the controller is not bent after

attaching the daughterboard to the controller card.

3Attach the AFM-600CC supercapacitor module to the controller by inserting the

connector into the socket on the AFM-600DB, as shown in Figure 3. The connector

attaches to the socket in only one direction.

4Choose a location on the chassis or in the system to fix the tethered supercapacitor

module using the included cable-ties such that (i) the cable (18.5") reaches the

mating location on the controller when it is installed in the expansion slot;

(ii) wiring is routed and secured so that it does not contact any moving parts (fans,

for instance); and (iii) the supercapacitor module is protected from heat.

5Thread the cable-ties through the slots on the supercapacitor module and fix to the

selected location on the computer chassis. The cable-ties should completely encircle the supercapacitor module to ensure that it is held

in place securely, as shown in Figure 4. Be careful not to restrict air-flow in your system.

6Reinstall the controller, and restart your computer.

7The supercapacitor starts charging automatically. It should reach full charge in 3-4 minutes.

Warning: (i) Do NOT remove or insert a fully charged supercapacitor module. Always discharge the unit first to avoid damage to the controller or

flash backup module. The factory ships with discharged units, so they are safe to install when you receive them. To ensure that an installed unit

is discharged, switch the system OFF, then wait 5 minutes. After a dirty shutdown, wait 3 minutes after backup is complete, then remove the

unit. (ii) There is a risk of explosion if the supercapacitor module is replaced by an incorrect type.

Figure 1 Figure 2

Spacers

Figure 3 Figure 4

Supercapacitor module

Table des matières

Autres manuels Adaptec Matériel informatique

Adaptec

Adaptec ACB-5500 Manuel utilisateur

Adaptec

Adaptec RAID 5405 Manuel utilisateur

Adaptec

Adaptec ACB-2320 Manuel utilisateur

Adaptec

Adaptec Serial Attached SCSI (SAS) Expander Card Manuel utilisateur

Adaptec

Adaptec AAR-1220SA Mode d’emploi

Adaptec

Adaptec 2045 Manuel utilisateur

Adaptec

Adaptec RAID 6405E Manuel utilisateur

Adaptec

Adaptec GDT6111RP Manuel utilisateur

Adaptec

Adaptec Ultra Wireless AWN-8030 Manuel utilisateur

Adaptec

Adaptec CDP-00277-01-A Manuel utilisateur

Adaptec

Adaptec SATA RAID FOR ADAPTEC Manuel utilisateur

Adaptec

Adaptec 2940U2W - Storage Controller U2W SCSI 80... Manuel utilisateur

Adaptec

Adaptec Series 6 Guide de référence

Adaptec

Adaptec 2010S - SCSI RAID Storage Controller Guide de sécurité

Adaptec

Adaptec PM3754U2 Manuel utilisateur

Adaptec

Adaptec 6405 Manuel utilisateur

Adaptec

Adaptec ACB-2370 Manuel utilisateur

Adaptec

Adaptec 1220SA - RAID Controller Manuel utilisateur

Adaptec

Adaptec AHA-2940 - SCSI Card Manuel utilisateur

Adaptec

Adaptec AAR-1220SA Mode d’emploi

Adaptec

Adaptec RAID 5405Z Manuel utilisateur

Adaptec

Adaptec AHA-1520 Manuel utilisateur

Adaptec

Adaptec ACB-2370 Manuel utilisateur

Adaptec

Adaptec 9110G Manuel utilisateur

Manuels Matériel informatique populaires d'autres marques

EMC2

EMC2 VNX Series Manuel du propriétaire

Panasonic

Panasonic DV0PM20105 Manuel utilisateur

Mitsubishi Electric

Mitsubishi Electric Q81BD-J61BT11 Manuel utilisateur

Gigabyte

Gigabyte B660M DS3H AX DDR4 Manuel utilisateur

Raidon

Raidon iT2300 Manuel utilisateur

National Instruments

National Instruments PXI-8186 Manuel utilisateur

Hauppauge

Hauppauge WinTV-HVR-2250 Manuel utilisateur

Kontron

Kontron CP6002 Manuel utilisateur

Manhattan

Manhattan 702843 Manuel utilisateur

Aphex

Aphex 230 Manuel utilisateur

AMD

AMD Phenom II Manuel d'exploitation

Intel

Intel NUC 12 Pro Manuel utilisateur

dbx

dbx Zone Pro 1260 Manuel utilisateur

Galaxy

Galaxy GHDX2-2430S-24F4D Manuel utilisateur

Intel

Intel AXXRMFBU4 Manuel utilisateur

Kontron

Kontron DIMM-PC/MD Manuel utilisateur

ST X-NUCLEO-SAFEA1B Mode d'emploi

STEINWAY LYNGDORF

STEINWAY LYNGDORF SP-1 Manuel utilisateur