ABB SREA-01 Guide de dépannage

ABB Drives

Quick Start-up Guide

SREA-01 Ethernet Adapter Module

3AUA0000042902 Rev A

Effective: 01.10.2008

Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: [email protected]

SREA-01 Quick Start-up Guide

1. Connecting power and network

Connect 9–28 V AC/DC to Vin+ and Vin-.

Connect a cross-over Ethernet cable directly to the unit for start-

up. You can use a network after you have configured the unit.

2. Connecting to SREA-01 over Ethernet

The default Ethernet configuration is:

IP address: 10.200.1.1

Subnet mask: 255.255.255.0

Username: admin

Password: admin

Connection method 1:

Configure your PC to the same subnet (e.g. IP address 10.200.1.2

and subnet mask 255.255.255.0).

Use Internet Explorer or Mozilla Firefox and go to location

http://10.200.1.1.

Connection method 2:

Install the ABB IP Configuration Tool from the attached CD. When

you start the program, it will search for connected SREA-01

modules. You can change the network settings of the module by

double clicking it.

Use Internet Explorer or Mozilla Firefox and go to location

http://<ip of the SREA-01 module>, e.g. http://10.200.1.1.

Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: [email protected]

SREA-01 Quick Start-up Guide

3. Connecting drive(s)

If you have a single ACS350, ACH550 or ACS550, it is easiest to

use the supplied RJ45 cable to connect to the panel port.

If you have multiple drives or an ACS800, use the RS-485

connection. Connect the A- channels of the SREA-01 unit and the

drives together, the B+ channels together and the COM connector

to the data ground connectors of the drives. Use 120 ohm

terminating resistors in the network.

4. Basic drive settings

Check the communication settings of the drive (either group 52 or

53 in most drives, depending on the connection type).

Station id/number has to be unique for each drive! The baud rate

selection and parity have to be same on all drives and

SREA-01. You can use for example 9600 bit/s, no parity, 1 stop bit.

5. Basic SREA-01 settings

You can change the Ethernet settings under Setup – Ethernet.

Select the correct drive connection settings under Setup –

Modbus.

• Select Physical Interface.

• Usually most other settings are suitable by default (RTU,

9600 bps, no parity, 1 stop bit).

SREA-01

X1 pin Wire

Panel port

RJ45 pin

RX (RS-232) white-orange 1

TX (RS-232) white-blue 3

COM orange and blue 2 and 6

X1 RS-232: Select EIA-232

X1 RS-485: Select EIA-485

X2: Select EIA-232 D-sub

Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: [email protected]

SREA-01 Quick Start-up Guide

To search for connected drives, go to page Configuration –

Devices and select autodetect.

6. More information

For more detailed information, please refer to the SREA-01 User’s

Manual located on the attached CD-ROM.

Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: [email protected]

Autres manuels pour SREA-01

Table des matières

Autres manuels ABB Unité de contrôle

ABB

ABB NCSA-01 CS 31 Manuel d'installation

ABB

ABB NMBP-01 Manuel d'installation

ABB

ABB COM600 series Manuel utilisateur

ABB

ABB i-bus KNX Manuel utilisateur

ABB

ABB ACS880-04 drive modules Manuel utilisateur

ABB

ABB ACQ580-34 Manuel utilisateur

ABB

ABB Relion 615 series Manuel d'installation et d'exploitation

ABB

ABB FENA-01 Manuel d'installation

ABB

ABB 616019-T1 Manuel d'utilisation et d'entretien

ABB

ABB ACQ580-34 Manuel utilisateur

ABB

ABB ACSM1 Series Manuel d'utilisation et d'entretien

ABB

ABB ACS880-04F Manuel utilisateur

ABB

ABB ACS880 Series Manuel du propriétaire

ABB

ABB 616016-T2 Manuel d'utilisation et d'entretien

ABB

ABB Relion SAM600 Manuel utilisateur

ABB

ABB NCAN-02 Manuel d'installation

ABB

ABB ACS880-304 +A003 Series Manuel utilisateur

ABB

ABB IEC 61850 Edition 2 Manuel utilisateur

ABB

ABB SmissLine TP ZLS 260 Guide de l'utilisateur

ABB

ABB ACS580-04 Manuel utilisateur

ABB

ABB MRP31.0 Manuel utilisateur

ABB

ABB M10 Series Manuel utilisateur

ABB

ABB TCC300 Manuel utilisateur

ABB

ABB ret650 Guide de démarrage rapide

Manuels Unité de contrôle populaires d'autres marques

Festo

Festo Compact Performance CP-FB6-E Manuel de la liste des pièces

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Manuel utilisateur

JS Automation

JS Automation MPC3034A Manuel utilisateur

JAUDT

JAUDT SW GII 6406 Series Guide rapide

Spektrum

Spektrum Air Module System Manuel utilisateur

BOC Edwards

BOC Edwards Q Series Manuel utilisateur

KHADAS

KHADAS BT Magic Manuel utilisateur

Etherma

Etherma eNEXHO-IL Manuel utilisateur

PMFoundations

PMFoundations Attenuverter Manuel utilisateur

GEA

GEA VARIVENT Manuel utilisateur

Walther Systemtechnik

Walther Systemtechnik VMS-05 Manuel utilisateur

Altronix

Altronix LINQ8PD Instructions de montage

Eaton

Eaton Powerware Series Manuel utilisateur

WAGO

WAGO 750-407/040-000 Manuel utilisateur

Sony

Sony CCU-590 Manuel utilisateur

Graco

Graco 25D614 Manuel utilisateur

Task Force Tips

Task Force Tips YE-RF-900 Manuel de programmation

Shini

Shini SPV-U Series Manuel utilisateur