ABB FSCA-01 Manuel d'installation

Options for ABB drives, converters and inverters

Quick installation and start-up guide

FSCA-01 RS-485 adapter module

Safety instructions

WARNING! Obey the safety instructions. If you ignore them, injury or death, or damage to the

equipment can occur. See the user’s manual.

Mechanical installation

Electrical installation

Layout of the module

1. Pull out the lock.

2. Install the module carefully to an option

module slot of the drive. See the drive

hardware manual.

3. Push in the lock.

4. Tighten the screw to torque 0.8 N·m using

a Torx TX10 screwdriver.

WARNING! Do not use excessive force,

or leave the screw too loose. Over-

tightening can damage the screw or

module. A loose screw decreases the EMC

performance, and can even cause an operation

failure.







No. Description

1Lock

2 Mounting and grounding screw

3 Bus connector [X1]

4 Termination jumper [J2]

5 Diagnostic LEDs

Start-up

When the module is connected to the drive, the drive control program sets the applicable parameters.

See the appropriate drive manual.

Basic parameter settings

To take the settings into use, validate and refresh the parameters with parameter 51.27 FBA par refresh.

Further information

Index Name Value

20.01 Ext1 commands Fieldbus A

22.11 Speed ref1 source FBAA ref 1

28.11 Frequency ref1 source FBAA ref 1

50.01 FBAA enable Enable (or select the option slot in which the module is installed)

50.02 FBAA comm loss func Fault

51.02 Profile The ABB Drives - Classic communication profile is the default value.

51.03 Station ID Set the address of the device.

51.04 Baud rate Set the baud rate of the link.

51.05 Parity Set the use of parity and stop bit(s) and the data length.

(4)00001 ABB Drives Profile Control Word

(4)00002 Reference 1

(4)00003 Reference 2

(4)00004 ABB Drives Profile Status Word

(4)00005 Actual 1

(4)00006 Actual 2

(4)00101…(4)09999 Drive ParameterAccess (16-bit); RegisterAddress = (4)00000 + 100 × Group + Index

(4)20000…(4)29999 Drive ParameterAccess (32-bit); RegisterAddress = (4)20000 + 200 × Group + 2 × Index

See the latest version of FSCA-01 RS-485 adapter module

user's manual (3AUA0000109533 [English]) inABB library

(www.abb.com/drives/documents).

For more information on fieldbus options and protocols

provided by ABB Drives, see the fieldbus

communications web page

(new.abb.com/drives/connectivity/fieldbus-connectivity).

Pin allocation for [X1] Bus termination with [J2]

Pin Description

1 SHDL Bus cable shield

2 DATA_A Data positive

3 DATA_B Data negative

4 GND_B Isolated signal ground

Termination activated Termination deactivated

3AXD50000158546 Rev A (EN) 2017-11-23

FSCA-01 manual

Fieldbus communications web page

Autres manuels pour FSCA-01

Table des matières

Autres manuels ABB Unité de contrôle

ABB

ABB FECA-01 EtherCAT Manuel utilisateur

ABB

ABB LEANtouch 6x36/30M-500 Series Manuel utilisateur

ABB

ABB CDPI-01 Manuel utilisateur

ABB

ABB ACS850 series Manuel utilisateur

ABB

ABB ACSM1-204 Manuel d'installation

ABB

ABB IEC 60870-5-103 Manuel utilisateur

ABB

ABB LD 800HSE Manuel utilisateur

ABB

ABB REF 542plus Manuel utilisateur

ABB

ABB NMBP-01 Manuel d'installation

ABB

ABB RELION 650 SERIES Manuel utilisateur

ABB

ABB FEPL-02 Ethernet POWERLINK Manuel d'installation

ABB

ABB IEC 61850 Edition 2 Manuel utilisateur

ABB

ABB CMS-700 Manuel utilisateur

ABB

ABB REF542plus Mode d’emploi

ABB

ABB Relion 615 series Manuel utilisateur

ABB

ABB OMD100 Manuel utilisateur

ABB

ABB M10 Series Manuel utilisateur

ABB

ABB ACQ580-04 Manuel utilisateur

ABB

ABB FSPS-21 Manuel utilisateur

ABB

ABB NCSA-01 CS 31 Manuel d'installation

ABB

ABB FDNA-01 Manuel d'installation

ABB

ABB RMBA-01 Manuel utilisateur

ABB

ABB Relion 615 series Manuel d'installation et d'exploitation

ABB

ABB ACS850 series Manuel utilisateur

Manuels Unité de contrôle populaires d'autres marques

Festo

Festo Compact Performance CP-FB6-E Manuel de la liste des pièces

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Manuel utilisateur

JS Automation

JS Automation MPC3034A Manuel utilisateur

JAUDT

JAUDT SW GII 6406 Series Guide rapide

Spektrum

Spektrum Air Module System Manuel utilisateur

BOC Edwards

BOC Edwards Q Series Manuel utilisateur

KHADAS

KHADAS BT Magic Manuel utilisateur

Etherma

Etherma eNEXHO-IL Manuel utilisateur

PMFoundations

PMFoundations Attenuverter Manuel utilisateur

GEA

GEA VARIVENT Manuel utilisateur

Walther Systemtechnik

Walther Systemtechnik VMS-05 Manuel utilisateur

Altronix

Altronix LINQ8PD Instructions de montage

Eaton

Eaton Powerware Series Manuel utilisateur

WAGO

WAGO 750-407/040-000 Manuel utilisateur

Sony

Sony CCU-590 Manuel utilisateur

Graco

Graco 25D614 Manuel utilisateur

Task Force Tips

Task Force Tips YE-RF-900 Manuel de programmation

Shini

Shini SPV-U Series Manuel utilisateur