ABB ControlNet FCNA-01 Manuel d'installation

Safety instructions

WARNING! Obey the safety instructions of the drive. If you ignore them, injury or death, or

damage to the equipment can occur.

Mechanical installation

Electrical installation

Layout of the module

1. Pull out the lock.

2. Install the module carefully to an option

module slot of the drive. See the drive

hardware manual.

3. Push in the lock.

4. Tighten the screw to torque 0.8 N·m

using a Torx TX10 screwdriver.

If you need to remove the adapter module

after it has been installed into the drive, use

a suitable tool (e.g. small pliers) to carefully

pull out the lock.

WARNING! Do not use excessive force, or leave the screw too loose. Over-tightening can

damage the screw or module. A loose screw decreases the EMC performance, and can

cause an operation failure.

No. Description

1Lock

2 Mounting and grounding screw

3 Bus connector line [A]

4 Network access port (NAP) for a temporary

connection of configuration tools

5 Bus connector line [B]

6 Diagnostic LEDs

7 Node ID address selection switches

—

OPTIONS FOR ABB DRIVES

FCNA-01 ControlNet adapter module

Quick installation and start-up guide

Connection procedure

Connect the bus cable to the BNC connectors [A] and/or [B] on the module. Use both connectors

in redundant operation, otherwise use either connector [A] or [B].

Start-up

To control the drive with the adapter module, set at least the basic parameters listed in the table

below. For full parameter descriptions, refer to the adapter module’s user manual or to the drive’s

firmware manual.

Basic parameter settings

To take the settings into use, validate and refresh the parameters with parameter 51.27 FBA par

refresh. Set the node address of the device with the rotary switches on the module.

Further information

Index Name Value

20.01 Ext1 commands Fieldbus A

22.11 Speed ref1 source FBA A ref 1

28.11 Frequency ref1 source FBA A ref 1

50.01 FBA A enable Enable (or select the option slot in which the module is installed)

50.02 FBA A comm loss func Fault

51.02 Profile The ODVA AC/DC drive profile is the default value.

See the latest version of FCNA-01 ControlNet adapter module

user's manual (3AUA0000141650 [English]) in ABB library

(www.abb.com/drives/documents).

For more information on ABB fieldbus options and protocols,

see the fieldbus communications web page

(new.abb.com/drives/connectivity/fieldbus-connectivity).

FCNA-01 manual

Fieldbus communications web

page

Specifications subject to change without notice.

3AXD50000158201 Rev B (EN) 2023-04-19

abb.com/drives

Autres manuels ABB Unité de contrôle

ABB

ABB RPBA-01 Manuel utilisateur

ABB

ABB FDNA-01 Manuel d'installation

ABB

ABB MNS-MCC Manuel utilisateur

ABB

ABB FSO-12 Manuel utilisateur

ABB

ABB i-bus EIB Manuel utilisateur

ABB

ABB Relion SAM600 Manuel utilisateur

ABB

ABB RELION 650 SERIES Guide de démarrage rapide

ABB

ABB MTQ22-FBP.0 Manuel utilisateur

ABB

ABB SafeGear Guide de l'utilisateur

ABB

ABB Relion 615 series Fiche technique

ABB

ABB COM600 series Manuel utilisateur

ABB

ABB LD 800HSE Manuel utilisateur

ABB

ABB SCU200 Manuel utilisateur

ABB

ABB REF542plus Mode d’emploi

ABB

ABB REC650 ANSI Guide de démarrage rapide

ABB

ABB RELION Series Manuel utilisateur

ABB

ABB RDCO-04 Manuel utilisateur

ABB

ABB ACH550 series Manuel utilisateur

ABB

ABB Ability 800xA Series Manuel utilisateur

ABB

ABB LEANtouch 6x36/30M-500 Series Manuel utilisateur

ABB

ABB OMD200 Guide de l'utilisateur

ABB

ABB ACQ580-04 Manuel utilisateur

ABB

ABB Busch-ComfortTouch 9 Manuel utilisateur

ABB

ABB ACQ810 Manuel d'utilisation et d'entretien

Manuels Unité de contrôle populaires d'autres marques

Festo

Festo Compact Performance CP-FB6-E Manuel de la liste des pièces

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Manuel utilisateur

JS Automation

JS Automation MPC3034A Manuel utilisateur

JAUDT

JAUDT SW GII 6406 Series Guide rapide

Spektrum

Spektrum Air Module System Manuel utilisateur

BOC Edwards

BOC Edwards Q Series Manuel utilisateur

KHADAS

KHADAS BT Magic Manuel utilisateur

Etherma

Etherma eNEXHO-IL Manuel utilisateur

PMFoundations

PMFoundations Attenuverter Manuel utilisateur

GEA

GEA VARIVENT Manuel utilisateur

Walther Systemtechnik

Walther Systemtechnik VMS-05 Manuel utilisateur

Altronix

Altronix LINQ8PD Instructions de montage

Eaton

Eaton Powerware Series Manuel utilisateur

WAGO

WAGO 750-407/040-000 Manuel utilisateur

Sony

Sony CCU-590 Manuel utilisateur

Graco

Graco 25D614 Manuel utilisateur

Task Force Tips

Task Force Tips YE-RF-900 Manuel de programmation

Shini

Shini SPV-U Series Manuel utilisateur