Zte MC888 Manuel utilisateur

MC888

Quick Start Guide 1

Hurtigstartsguide 29

Pikakäynnistysopas 58

Trumpasis vadovas 87

Hurtigstartveiledning 116

Snabbstartguide 145

1

MC888

Let’s go

Getting started with your device

2

1. Prepare

yA valid nano-SIM card.

yView the label on your device to get the default information.

3

2. Insert the nano-SIM Card

Open the slot cover at the bottom of the device and insert the nano-SIM

card.

4

3. Power on Your Device

Connect the power adapter to your device and then your device will be

powered on and connect to the Internet automatically.

5

4. Access the Internet

yWi-Fi: Get the default SSID and password on the label and connect

to the Wi-Fi network with your mobile device, and then access the

Internet.

6

yNetwork cable(RJ45): Connect with the computer via LAN ports

and then access the Internet.

7

5. Change Your Device Settings

You can change the device settings by logging in to the 5G CPE

management web page.

1. View the label on your device to get the default Device Manager

Website IP address and Password.

2. Launch the Internet browser and enter the Device Manager

Website IP address in the address bar.

3. Input the password and then click Login.

4. After the 5G CPE management web page is opened, you can

change the Wi-Fi SSID, password or other settings.

8

Dual-network Modes

Your device supports the dual-network modes (Automatic Mode and

Hybrid Mode). You can use the nano-SIM card and broadband service

network port (WAN) to access the Internet.

1. Insert the nano-SIM card and connect the broadband service

network port to the LAN port1.

2. Log in to the 5G CPE management web page.

3. Change the operation mode to Automatic or Hybrid Mode. The

device will be restarted automatically.

fAutomatic: The wired network is used as the default network.

If the wired network is disconnected, you can use the nano-

SIM card to access the Internet.

fHybrid Mode: You can use two types of networks to access

the Internet at the same time to increase the network speed. If

one is disconnected, the other still works properly.

NOTE:

Please disconnect from the Internet rst and then you can change the

mode.

4. Set the wired network parameters given by your service provider.

5. Use your clients to access the Internet.

Autres manuels pour MC888

1

Table des matières

Langues :

Manuels Routeur réseau populaires d'autres marques

Allnet

Allnet ALL0333AU Manuel utilisateur

HomeSeer

HomeSeer HT-SEL Manuel utilisateur

Sercomm

Sercomm Genesis OC3505D Manuel utilisateur

Billion

Billion BIPAC 5102 Series Manuel utilisateur

TP-Link

TP-Link TD-8817 Manuel utilisateur

Motorola

Motorola MR1900 Manuel utilisateur

Digi

Digi IX14 Manuel utilisateur

Cisco

Cisco NCS 540 Manuel

XAVi

XAVi X8821e Manuel utilisateur

BEC

BEC 6200WZL Manuel utilisateur

MikroTik

MikroTik hAP ac3 Series Manuel utilisateur

Korenix

Korenix JetNet 5428G Series Manuel utilisateur

NETGEAR

NETGEAR FS526T - Switch Manuel utilisateur

Korenix

Korenix JetNet 5710G Series Manuel utilisateur

Automated Logic

Automated Logic ZN551 Manuel du propriétaire

Cisco

Cisco ASR 1000 Series Manuel de l'opérateur

EnGenius

EnGenius ESR-9710 Manuel utilisateur

Cisco

Cisco 805 Series Instructions d'utilisation et de sécurité