Yamaha SV10 Manuel utilisateur

SPEAKER SYSTEMS

SV10/SV12/SV15

SV12M

Owner’s Manual

Mode d’emploi

Bedienungsanleitung

Manual de instrucciónes

Thank you for purchasing a YAMAHA product. To obtain

maximum performance from your YAMAHA speaker system

and ensure many years of trouble-free operation, we recommend

that you read this Owner’s Manual thoroughly before use.

Contents

Precautions ...................................................................... 2

Connecting the Speakers ................................................ 4

Specifications ................................................................... 5

Precautions

To protect your speakers

When choosing a power amplifier to use with your speakers, make sure that its power output matches the speakers’power

capacity (refer to the Specifications on page 5). Even if the amplifier’s power output is lower than the speakers’PGM

(program) power capacity, the speakers may be damaged when clipping of a high input signal occurs.

The following may cause damage to speakers:

•Feedback caused when using a microphone.

•Continuous high sound pressure level produced by electronic instruments.

•Continuous high-power output distorted signals.

•Popping noises caused by turning on equipment, or by connecting or disconnecting system components while the amplifier

is turned on.

−2−

AVOID EXCESSIVE HEAT, HUMIDITY, DUST AND VI-

BRATION

When choosing a location for your speakers, avoid the fol-

lowing:

•Direct sunlight, high temperatures (such as near heat-

ers), or excessively low temperatures.

•High humidity.

•Areas subject to excessive dust accumulation and vibra-

tion.

•Non-level or unstable surfaces.

HOW TO POWER UP YOUR SOUND SYSTEM

To avoid damage to your speakers and other parts of your

system, when you turn on your system, ALWAYS turn the

power amp on last! This will avoid loud, damaging pops

that will annoy your audience, and blow your speakers.

When you power down, the amplifier should ALWAYS be

turned off first to avoid the same problems.

MAKE SURE THE POWER IS OFF BEFORE MAKING

OR REMOVING CONNECTIONS

Always turn the power switches of system components

OFF prior to connecting or disconnecting cables. Failure to

do so may result in damage to speakers as well as to con-

nected equipment.

DISCONNECT CABLES BEFORE MOVING THE SYS-

TEM

To prevent short circuits or breakage of cables, always dis-

connect cables prior to moving system equipment.

MATCH CONNECTOR POLARITY

When using two or more speaker systems, be sure match

the polarity (+/–) of the speaker system connectors to those

at the amplifier. If the polarities do not match, the sounds

produced by the speakers will interfere with each other,

making it impossible to achieve a well-balanced sound

field.

KEEP THIS OWNER’S MANUAL IN A SAFE PLACE

FOR FUTURE REFERENCE

CAUTION!

Recommended for use with Ultimate Support Systems,

Inc. Model TS-30 or TS-33 speaker stands only.

•Use only ONE speaker per stand.

•The loudspeakers and stands must always rest upon a

solid, level surface.

•Improper installation or usage could result in the loud-

speaker falling and causing injury.

•The top tube of the TS-30 and TS-33 speaker stands has

a diameter of 1-1/2", but is tapered to 1-3/8" at the top to

fit in the mounting holes on these models. If you should

remove the top tube from a stand, be sure to insert it with

the narrow end up when reassembling.

−3−

This product, when used in combination

with amplification and/or additional

loudspeakers, may be capable of produc-

ing sound levels that could cause perma-

nent hearing loss.

DO NOT operate at high volume levels

or at a level that is uncomfortable. If you

experience any discomfort or ringing in

the ears, or suspect an hearing loss, you

should consult an audiologist.

Connecting the Speakers

CONNECTION EXAMPLE

The illustration below shows audio connections for a standard setup using two speaker systems.

MIXING

CONSOLE

GRAPHIC

EQUALIZER

SPEAKER

SYSTEMS

SPEAKER

SYSTEMS

DAISY-CHAINED

POWER

AMPLIFIER

DAISY-CHAINING SPEAKERS

Since the speaker systems in this series are equipped with two input terminals that are internally connected in parallel, it is

possible “daisy-chain”speakers by connecting the output from the power amplifier to one phone jack, and a second speaker

system to the other.

All speaker models in this series have a nominal impedance of 8Ω. Since most power amplifiers are designed to provide stable

performance at a load impedance of 4 or 8Ω, Yamaha recommends that no more than two 8Ωspeaker systems be daisy-chained

together. This will allow the amplifier to operate properly and avoid overheating.

−4−

−5−

120˚

30˚

75˚105˚

SV10,SV12,SV15 SV12M

Model SV10 SV12/SV12M SV15

Enclosure Bass reflex type

Speaker Unit LF 10" cone 12" cone 15" cone

HF Piezo horn

Frequency Response 70 Hz to 20 kHz 60 Hz to 20 kHz 50 Hz to 20 kHz

Power Capacity NOISE 75 W 100 W

PGM 150 W 200 W

MAX 300 W 400 W

Nominal Impedance 8Ω

Sensitivity 95 dB SPL (1W, 1m) 97 dB SPL (1W, 1m) 98 dB SPL (1W, 1m)

Input Connectors 1/4" phone jack x 2 (parallel input)

Dimensions (W x H x D) 400 x 517 x 328 mm SV12: 445 x 525 x 372 mm 510 x 628 x 455 mm

SV12M: 525 x 445 x 315 mm

Weight 13.3 kg SV12: 14.8 kg 22 kg

SV12M: 13.5 kg

Specifications

Unit: mm

Specifications subject to change without notice

CJY0324R01AP24

97062000APPrintedinJapan P.O. Box 1, Hamamatsu, Japan

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Yamaha Système de haut-parleurs

Yamaha

Yamaha NS-C225 - Center CH Speaker Manuel utilisateur

Yamaha

Yamaha SR-C20ABL Manuel utilisateur

Yamaha

Yamaha Soavo-2 Manuel utilisateur

Yamaha

Yamaha ATS-B400 Manuel utilisateur

Yamaha

Yamaha S10e Manuel utilisateur

Yamaha

Yamaha ESB-1090 Manuel utilisateur

Yamaha

Yamaha S0112T Manuel utilisateur

Yamaha

Yamaha NS-E103 Manuel utilisateur

Yamaha

Yamaha NS-10MMF Manuel utilisateur

Yamaha

Yamaha ATS-1080 Manuel utilisateur

Yamaha

Yamaha NS-P285 Manuel utilisateur

Yamaha

Yamaha NS-40M Studio Manuel utilisateur

Yamaha

Yamaha NS-10M Instructions de montage

Yamaha

Yamaha NX-A01 - Speaker Sys Manuel utilisateur

Yamaha

Yamaha NS-333 Manuel utilisateur

Yamaha

Yamaha NS-U50 Manuel utilisateur

Yamaha

Yamaha Digital Sound Projector YSP-900 Manuel utilisateur

Yamaha

Yamaha Digital Sound Projector YSP-3000 Manuel utilisateur

Yamaha

Yamaha NS-PA40 Manuel utilisateur

Yamaha

Yamaha YAS-203 Manuel utilisateur

Yamaha

Yamaha YAS-152 Manuel utilisateur

Yamaha

Yamaha IF2112/AS(W) Manuel utilisateur

Yamaha

Yamaha ATS-B200 Manuel utilisateur

Yamaha

Yamaha NS-P7900 Manuel utilisateur

Manuels Système de haut-parleurs populaires d'autres marques

JVC

JVC CA-MXK5R Manuel utilisateur

LG NB4532B Manuel utilisateur

JVC

JVC CA-FSH100 Manuel utilisateur

5Core

5Core Pro Series Manuel utilisateur

EAW

EAW MQV1394e Manuel utilisateur

Lynx

Lynx GXR-LA10A Manuel utilisateur

iLive

iLive ITB066B Manuel utilisateur

RDX

RDX QuickStation 4 Manuel utilisateur

Electro-Voice

Electro-Voice S-122 Manuel utilisateur

Sven

Sven SPS-619 GOLD Manuel utilisateur

Pioneer

Pioneer CS-7070 Manuel utilisateur

EAW

EAW UB82e Manuel utilisateur

Sondpex

Sondpex Active Speaker System and Digital Music... Manuel utilisateur

JVC

JVC NX-PN7 Manuel utilisateur

Marshall Amplification

Marshall Amplification AR-DM61-BT Manuel utilisateur

SE Audiotechnik

SE Audiotechnik I-LINE Manuel utilisateur

Gemini

Gemini WRX-843 Series Manuel utilisateur

TCL

TCL 6100 Series Manuel utilisateur