Yamaha NS-C55 Manuel utilisateur

PRECAUTIONS

This model is designed to be used as a center speak-

er system.

Read these precautions carefully before using your speak-

er.

●Any time you note distortion, reduce the volume control

on your amplifier to a lower setting. Never allow your

amplifier to be driven into “clipping”. Otherwise the

speaker may be damaged.

●When using an amplifier with a rated output power high-

er than the nominal input power of the speaker, care

should be taken never to exceed the speaker’s maximum

input.

●Do not attempt to clean the speaker with chemical sol-

vents as this might damage the finish.To clean, wipe

with a dry, soft cloth.

●To prevent the enclosure from warping or discoloring, do

not place the speaker where it will be exposed to direct

sunlight or excessive humidity.

●Do not place the speaker where it is liable to be knocked

over or struck by falling objects. Stable placement will

also ensure better sound performance.

●Placing the speaker on the same shelf or rack as the

turntable can result in feedback.

●Secure placement or installation is the owner’s

responsibility.

YAMAHA shall not be liable for any accident caused

by improper placement or installation of the speaker.

Place the speaker on top of the TV or on the floor under

the TV or inside the TV rack so that it is stabilized.

When placing the speaker on top of the TV, to prevent the

speaker from falling down, put the provided velcro strips at

two points on both bottom of the speaker and top of the

TV.

Notes

●Do not place the speaker on top of the TV whose

area is smaller than the bottom area of the speaker.

If placed, the speaker may drop out causing an

injury to you.

●Though this speaker is a magnetic shielding type,

there may be some influence on aTV picture

depending on the type of TV or the placement of the

speaker. In such a case, place the speaker apart

from theTV so that there is no influence on TV pic-

ture.

NS-P60

“NS-P60” is the package number which includes the YAMAHA speaker system NS-C55 and NS-E55.

Thank you for selecting this Yamaha NS-P60 speaker system.

NS-C55 Natural Sound Center Speaker System

PLACING THE SPEAKER

Velcro

strip

TV set

Screen

HOME CINEMA CENTER

& EFFECT SPEAKERS

G R

BEFORE MAKING CONNECTIONS, MAKE SURE THAT

THE AMPLIFIER IS SWITCHED OFF.

■CONNECTIONS

●Connect the screw-type input terminals at the rear of the

speaker to the speaker output terminals of your amplifier

with the provided speaker cords.

●One side of the speaker cord is red and the other side is

black. Connect the (+) terminals on both the amplifier

and the speaker using this red side. Connect the (–) ter-

minals on both components using the black side of the

cord.

●Be careful not to reverse the polarity (+, –). If connected

with reversed polarity, the sound will be unnatural and

lack bass.

Procedures:

➀Loosen the terminal knob.

➁Insert the bare speaker wire end properly into the ter-

minal hole. [Remove approx. 10 mm (3/8”) insulation

from the speaker cord.]

➂Tighten the knob.

➃Test the security of the connection by pulling lightly the

cord at the terminal.

Note

Do not let the bare speaker wires touch each other as

this could damage the speaker or

the amplifier, or both of them.

SPECIFICATIONS

Type..........................2-way 3-speaker acoustic-suspension

speaker system

Magnetic-shielding type

Speaker Unit....................................10 cm cone woofer x 2

2.2 cm dome tweeter

Input Terminal.....................................................Screw-type

Impedance .................................................................6 ohm

Frequency Response..................................70 Hz – 30 kHz

Nominal Input Power.....................................................60W

Maximum Input Power................................................180W

Sensitivity (2.83V, 1m)................................................91 dB

Crossover Frequency..................................................5 kHz

Dimensions (WxHxD).......................465 x 135 x 173.5 mm

(18-5/16” x 5-5/16” x 6-7/8”)

Weight .................................................3.5 kg (7 lbs. 12 oz.)

Accessories......................................Speaker cord (4m) x 1

Velcro strip x 2

* Specifications subject to change without notice due to

product improvements.

* Care should be taken not to exceed the input power val-

ues noted above.

CONNECTION TO YOUR AMPLIFIER

Center speaker

output terminals

of the amplifier

NS-C55

Tighten

Red (+)

Black (–)

Red

Loosen

Amplifier

V415010

PRECAUTIONS

This model is designed to be used as an effect speak-

er system.

Read these precautions carefully before using your speak-

ers.

●Any time you note distortion, reduce the volume control

on your amplifier to a lower setting. Never allow your

amplifier to be driven into “clipping”. Otherwise the

speakers may be damaged.

●When using an amplifier with a rated output power high-

er than the nominal input power of the speakers, care

should be taken never to exceed the speakers’ maximum

input.

●Do not attempt to clean the speakers with chemical sol-

vents as this might damage the finish.To clean, wipe

with a dry, soft cloth.

●To prevent the enclosure from warping or discoloring, do

not place the speakers where they will be exposed to

direct sunlight or excessive humidity.

●Do not place the speakers where they are liable to be

knocked over or struck by falling objects. Stable place-

ment will also ensure better sound performance.

●Placing the speakers on the same shelf or rack as the

turntable can result in feedback.

●As these speakers contain strong magnets, avoid plac-

ing watches, magnetic tapes, etc. near them. Also, plac-

ing the speakers near a TV set may impair picture color.

If this happens, move the TV set away from the speak-

ers.

●Secure placement or installation is the owner’s

responsibility.

YAMAHA shall not be liable for any accident caused

by improper placement or installation of the speak-

ers.

■Mounting the speakers on a wall

The speakers can be mounted on a wall by using the

holes provided on the speakers’ back panels.

Make sure that the screws are caught by a narrow part of

the holes securely.

Put the screws into a wall according to the figure shown

below.

Fasten screws into a firm wall or wall support as shown in

the figure below, and hang the holes on the protruding

screws.

WARNING

●Each speaker weights 2.2 kg (4 lbs. 13 oz.). Do not

mount them on thin plywood or soft wall surface materi-

al, as the screws may come out of the flimsy surface,

causing the speakers to fall down and be damaged, or

result in personal injury.

●Do not fasten the speakers to wall with nails, adhesives,

or other unsound hardware. Long term use and vibra-

tions may cause them to fall down.

●To avoid accidents resulting from tripping over loose

speaker cords, fix them to the wall.

NS-E55 Natural Sound Effect Speaker System

SETTING UP THE SPEAKERS

Pads

Holes

Diam. 4 – 5 mm

40 mm

Min.

12mm

2mm

Tapping screw

(Available at a

hardware store)

Wall or

wall support

BEFORE MAKING CONNECTIONS, MAKE SURE THAT

THE AMPLIFIER IS SWITCHED OFF.

■CONNECTIONS

●Connect the screw-type input terminals at the rear of the

speakers to the speaker output terminals of your amplifi-

er with the provided speaker cords.

●One side of the speaker cord has a gray line. Connect

the (+) terminals on both the amplifier and the speakers

using the side of the cord with the gray line. Connect the

(–) terminals on both components using the side without

a gray line.

●Connect one speaker to the left (marked L) terminals of

your amplifier, and another speaker to the right (marked

R) terminals, making sure not to reverse the polarity (+,

–). If one speaker is connected with reversed polarity,

the sound will be unnatural and lack bass.

Procedures:

➀Loosen the terminal knob.

➁Insert the bare speaker wire end properly into the ter-

minal hole. [Remove approx. 10 mm (3/8”) insulation

from the speaker cord.]

➂Tighten the knob.

➃Test the security of the connection by pulling lightly the

cord at the terminal.

Note

Do not let the bare speaker wires touch each other as

this could damage the speaker or

the amplifier, or both of them.

SPECIFICATIONS

Type..........................2-way 2-speaker acoustic-suspension

speaker system

Speaker Unit..........................................10 cm cone woofer

2.2 cm dome tweeter

Input Terminal.....................................................Screw-type

Impedance .................................................................6 ohm

Frequency Response..................................80 Hz – 30 kHz

Nominal Input Power.....................................................50W

Maximum Input Power................................................150W

Sensitivity (2.83V, 1m)................................................90 dB

Crossover Frequency..................................................5 kHz

Dimensions (WxHxD).......................150 x 265 x 156.3 mm

(5-7/8” x 10-7/16” x 6-3/16”)

Weight .................................................2.2 kg (4 lbs. 13 oz.)

Accessories ..................................Speaker cords (10m) x 2

* Specifications subject to change without notice due to

product improvements.

* Care should be taken not to exceed the input power val-

ues noted above.

CONNECTION TO YOUR AMPLIFIER

Red (+)

Black (–)

Speaker output

terminals of the

amplifier

Loosen Tighten

Gray line

Amplifier

Gray line Gray line

Speaker (R) Speaker (L)

Autres manuels pour NS-C55

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Yamaha Système de haut-parleurs

Yamaha

Yamaha NS-C525 Manuel utilisateur

Yamaha

Yamaha IF2112/64(W) Manuel utilisateur

Yamaha

Yamaha ATS-B300A Manuel utilisateur

Yamaha

Yamaha YHT-16 Instructions de montage

Yamaha

Yamaha NS-P41 Manuel utilisateur

Yamaha

Yamaha ATS-B400 Manuel utilisateur

Yamaha

Yamaha YHT-34 Instructions de montage

Yamaha

Yamaha NS-C9900 Manuel utilisateur

Yamaha

Yamaha MusicCast Bar 40 Manuel utilisateur

Yamaha

Yamaha Installation Series Manuel utilisateur

Yamaha

Yamaha NS-40M Studio Manuel utilisateur

Yamaha

Yamaha NS-AW190 Manuel utilisateur

Yamaha

Yamaha RDX-E700 Manuel utilisateur

Yamaha

Yamaha NS-333 Manuel utilisateur

Yamaha

Yamaha VXS10S Manuel utilisateur

Yamaha

Yamaha NS-5 Manuel utilisateur

Yamaha

Yamaha SR-B40A Manuel utilisateur

Yamaha

Yamaha NS-C120 Manuel utilisateur

Yamaha

Yamaha YSP-2700 Manuel utilisateur

Yamaha

Yamaha IF2205 Instructions de montage

Yamaha

Yamaha NS-C444 - Center CH Speaker Manuel utilisateur

Yamaha

Yamaha YAS-71CU Manuel utilisateur

Yamaha

Yamaha YAS-706 Series Manuel utilisateur

Yamaha

Yamaha YAS-CU706 Manuel utilisateur

Manuels Système de haut-parleurs populaires d'autres marques

JVC

JVC CA-MXK5R Manuel utilisateur

LG NB4532B Manuel utilisateur

JVC

JVC CA-FSH100 Manuel utilisateur

5Core

5Core Pro Series Manuel utilisateur

EAW

EAW MQV1394e Manuel utilisateur

Lynx

Lynx GXR-LA10A Manuel utilisateur

iLive

iLive ITB066B Manuel utilisateur

RDX

RDX QuickStation 4 Manuel utilisateur

Electro-Voice

Electro-Voice S-122 Manuel utilisateur

Sven

Sven SPS-619 GOLD Manuel utilisateur

Pioneer

Pioneer CS-7070 Manuel utilisateur

EAW

EAW UB82e Manuel utilisateur

Sondpex

Sondpex Active Speaker System and Digital Music... Manuel utilisateur

JVC

JVC NX-PN7 Manuel utilisateur

Marshall Amplification

Marshall Amplification AR-DM61-BT Manuel utilisateur

SE Audiotechnik

SE Audiotechnik I-LINE Manuel utilisateur

Gemini

Gemini WRX-843 Series Manuel utilisateur

TCL

TCL 6100 Series Manuel utilisateur