Yamaha AEROX NS50 Manuel utilisateur

NS-50

Natural Sound 3-way, 4-speaker Bass Reflex Speaker System

Read these precautions carefully before using your speaker.

●Any time you note distortion, reduce the volume control on

your amplifier to a lower setting. Never allow your amplifier to

be driven into “clipping”. Otherwise the speaker may be

damaged.

●When using an amplifier with a rated output power higher than

the nominal input power of the speaker, care should be taken

never to exceed the speaker’s maximum input.

●Do not attempt to clean the speaker with chemical solvents as

this might damage the finish. To clean, wipe with a dry, soft

cloth.

●To prevent the enclosure from warping or discoloring, do not

place the speaker where it will be exposed to direct sunlight or

excessive humidity.

●Do not place the speaker where it is liable to be knocked over

or struck by falling objects. Stable placement will also ensure

better sound performance.

●Placing the speaker on the same shelf or rack as the turntable

can result in feedback.

●Secure placement or installation is the owner’s

responsibility.

YAMAHA shall not be liable for any accident caused by

improper placement or installation of the speaker.

BEFORE MAKING CONNECTIONS, MAKE SURE THAT THE

AMPLIFIER IS SWITCHED OFF.

■CONNECTIONS

●Connect the push-type input terminals at the rear of the

speakers to the speaker output terminals of your amplifier with

the provided speaker cables.

●One side of the speaker cable is red and the other side is

black. Connect the (+) terminals on both the amplifier and the

speakers using this red side. Connect the (–) terminals on both

components using the black side of the cable.

●Connect one speaker to the left (marked L) terminals of your

amplifier, and another speaker to the right (marked R)

terminals, making sure not to reverse the polarity (+, –). If one

speaker is connected with reversed polarity, the sound will be

unnatural and lack bass.

Procedures:

➀Press the tab on the terminal down, as shown in the figure.

➁Insert the bare speaker wire end properly into the terminal

hole. [Remove approx. 5 mm (1/4”) insulation from the

speaker cable.]

➂Remove your finger from the tab to allow it to lock snugly on

the cable’s wire end.

➃Test the security of the connection by tugging lightly on the

cable at the terminal.

Note

Do not let the bare speaker wires touch each other as this

could damage the speaker and/or the amplifier.

Press tab

Red line

Speaker (R)

Red line

Speaker (L)

Speaker output

terminals of the

amplifier

Thank you for selecting this Yamaha NS-50 speaker system.

PRECAUTIONS

CONNECTION TO YOUR AMPLIFIER

Black line

PLACING THE SPEAKER

●Place the speakers on a sturdy, vibration-free surface. If you

cannot obtain good bass quality when the speakers are placed

directly on the floor, insert a block etc. between the speakers

and the floor.

●Better stereo images will be obtained when the speakers are

slightly angled in towards the listeners.

Note

Bacause this speaker is not a magnetic shielding type,

there may be some influence on a TV picture depending on

the type of TV or the placement of the speaker. In such a

case, place the speaker apart from the TV so that there is no

influence on TV picture.

REMOVING THE FRONT COVER

The front cover is fastened to the enclosure at four points, and

can be removed if desired. To remove the cover, hold on to both

sides and slowly pull straight away from the speaker. To

reattach, line up the four pegs on the inside surface of the cover

with the four corresponding holes on the speaker and push

gently.

Note

When the cover is removed, take care not to touch the

speaker units with your hands or to exert excessive force

with tools.

VU 89840

SPECIFICATIONS

Type .......................3-way 4-speaker bass reflex speaker system

Speaker Unit..............................................20 cm cone woofer x 2

10 cm cone midrange

5 cm cone tweeter

Input Terminal ...............................................................Push-type

Nominal Impedance...........................................................6 ohms

Frequency Response............................................40 Hz – 20 kHz

Nominal Input Power..............................................................70W

Music Input Power................................................................250W

Sensitivity .....................................................................90 dB/w/m

Crossover Frequency..............................................700 Hz, 4 kHz

Dimensions (WxHxD)....................................280 x 900 x 285 mm

............................................................(11” x 35-7/16” x 11-1/4”)

Weight.........................................................13.7 kg (30 lbs. 4 oz.)

Accessories..............................................Speaker cable (4m) x 2

* Specifications subject to change without notice due to product

improvements.

* Care should be taken not to exceed the input power values

noted above.

Autres manuels pour AEROX NS50

Table des matières

Autres manuels Yamaha Système de haut-parleurs

Yamaha

Yamaha IF2108 Instructions de montage

Yamaha

Yamaha NS-AM200 Manuel utilisateur

Yamaha

Yamaha S112V Manuel utilisateur

Yamaha

Yamaha YSP-5600 Manuel d'utilisation et d'entretien

Yamaha

Yamaha IF2108(W) Manuel utilisateur

Yamaha

Yamaha SR-C20ABL Manuel utilisateur

Yamaha

Yamaha NS-70 Manuel utilisateur

Yamaha

Yamaha NS-333 Manuel utilisateur

Yamaha

Yamaha PDX-B11 Manuel utilisateur

Yamaha

Yamaha NX-A01 - Speaker Sys Manuel utilisateur

Yamaha

Yamaha IF2108 Manuel utilisateur

Yamaha

Yamaha ATS-B200 Manuel utilisateur

Yamaha

Yamaha SR-B30A Manuel utilisateur

Yamaha

Yamaha ATS-B400 Manuel utilisateur

Yamaha

Yamaha NX-B150 Manuel utilisateur

Yamaha

Yamaha NX-E150 Manuel utilisateur

Yamaha

Yamaha YAS-103 Manuel utilisateur

Yamaha

Yamaha NS-P320 Manuel utilisateur

Yamaha

Yamaha DHR Series Manuel utilisateur

Yamaha

Yamaha NS-1000MM Manuel utilisateur

Yamaha

Yamaha S0112T Manuel utilisateur

Yamaha

Yamaha IF2112/AS(W) Manuel utilisateur

Yamaha

Yamaha NS-C225 - Center CH Speaker Manuel utilisateur

Yamaha

Yamaha Installation Series Manuel utilisateur

Manuels Système de haut-parleurs populaires d'autres marques

JVC

JVC CA-MXK5R Manuel utilisateur

LG NB4532B Manuel utilisateur

JVC

JVC CA-FSH100 Manuel utilisateur

5Core

5Core Pro Series Manuel utilisateur

EAW

EAW MQV1394e Manuel utilisateur

Lynx

Lynx GXR-LA10A Manuel utilisateur

iLive

iLive ITB066B Manuel utilisateur

RDX

RDX QuickStation 4 Manuel utilisateur

Electro-Voice

Electro-Voice S-122 Manuel utilisateur

Sven

Sven SPS-619 GOLD Manuel utilisateur

Pioneer

Pioneer CS-7070 Manuel utilisateur

EAW

EAW UB82e Manuel utilisateur

Sondpex

Sondpex Active Speaker System and Digital Music... Manuel utilisateur

JVC

JVC NX-PN7 Manuel utilisateur

Marshall Amplification

Marshall Amplification AR-DM61-BT Manuel utilisateur

SE Audiotechnik

SE Audiotechnik I-LINE Manuel utilisateur

Gemini

Gemini WRX-843 Series Manuel utilisateur

TCL

TCL 6100 Series Manuel utilisateur