XTC X Series Manuel utilisateur
X-Series S90 – v4 – Single Chin-Up
Parts:
(2) US-01001-V2 – Lateral Base Tube
(2) US-01001-V2A – Crossbeam
(1) US-12 with Single Chin-Up
(4) US-002-V2 – Triangle Plate
(2) XS-S90-01001-V2 – X-Series 90” Upright
(2) J-Hooks (1 Left/ 1 Right)
Hardware:
(4) 2x3” Plastic Caps
(4) 4.5” Bolts
(12) 5” Bolts
(32) Washers
(16) Lock Washers
(16) Nuts
INSTRUCTIONS:
Step 1.
Place Lateral Base in position where you wish to assemble rack with the 3” face
down. Place Crossbeam Tube at the furthest most set of holes.
Step 2.
Using the 4.5” bolts connect crossbeam to the lateral bases. Fasten Completely.
Step 3.
Position Triangle Plates along the inside and outside of the Lateral Base. Position
the Triangles in the Centre of the the lateral bases. Using two 5” bolts attach
triangles to the Lateral Tube. DO NOT TIGHTEN COMPLETELY.
Step 4.
Place the Upright Tube between two Triangles. Use two 5” bolts to secure the
Upright.
Step 5.
Repeat step 3 and 4 for the opposite side.
Step 6.
Place Crossbeam and Single Chin-Bar at the top of the rack (or desired height) and
fasten with 5” bolts.
Step 7.
Fasten ALL hardware completely.
Step 8.
Install 2x3” plastic end caps into the lateral base tube.
Ce manuel convient aux modèles suivants
1
Table des matières
Autres manuels XTC Équipement de fitness
