Wolf E Series Manuel utilisateur

E Series Ovens Installation Guide

E SERIES OVENS

Contents

3E Series Ovens

4Specications

10 Installation

11 Troubleshooting

Features and specications are subject to change at any

time without notice. Visit wolfappliance.com/specs for the

most up-to-date information.

Wolf Customer Care 800.222.7820

Important Note

To ensure this product is installed and operated as safely

and efciently as possible, take note of the following types

of highlighted information throughout this guide:

IMPORTANT NOTE highlights information that is especially

important.

CAUTION indicates a situation where minor injury or product

damage may occur if instructions are not followed.

WARNING states a hazard that may cause serious injury or

death if precautions are not followed.

IMPORTANT NOTE: Throughout this guide, dimensions in

parentheses are millimeters unless otherwise specied.

IMPORTANT NOTE: Save these instructions for the local

electrical inspector.

wolfappliance.com

E SERIES OVENS

Product Information

Important product information including the model and

serial number are listed on the product rating plate. The

rating plate is located below the control panel. The oven

door must be open to view the rating plate. Refer to the

illustration below.

If service is necessary, contact Wolf factory certied service

with the model and serial number. For the name of the

nearest Wolf factory certied service or for questions

regarding the installation, visit the contact & support section

of our website, wolfappliance.com or call Wolf customer

care at 800-222-7820.

Rating plate location.

RATING

PLATE

Wolf Customer Care 800.222.7820

SPECIFICATIONS

COMBINATION INSTALLATIONS

Wolf built-in ovens are designed and agency approved for

installation with Wolf cooktops, microwaves and warming

drawers only. The nominal width of the oven should match

the nominal width of the cooktop. A built-in oven cannot be

installed below a Wolf rangetop.

For typical combination installations, refer to the Wolf

Design Guide.

The single oven may be installed next to another E series

single oven. You must allow for a 11/2"(38) space between

oven openings. A separate inner wall is required for each

oven between openings.

Installation Requirements

The oven can be installed in a standard or ush inset

application. Location of the electrical supply within the oven

opening may require additional cabinet depth. Refer to the

chart below.

Finish the edges of the opening. They may be visible when

the door is open.

For ush inset installations, a minimum 1/4"(6) reveal is

required on all sides. To ensure consistent 1/4"(6) reveals,

each corner of the opening must be exactly 90°.

INSTALLATION REQUIREMENTS

BASE SUPPORT

Single Oven 250 lb (115 kg)

Double Oven 400 lb (181 kg)

CABINET DEPTH

Standard Installation 24" (610) min

Flush Inset Installation 25" (635) min

Flush Inset (contemporary model) 251/4"(641) min

TRIM (STANDARD INSTALLATION)

Top Overlap 5/8"(16)

Bottom Overlap 1/8"(3)

Side Overlap 3/4"(19)

wolfappliance.com

SPECIFICATIONS

Electrical

Installation must be electrically grounded in accordance

with local codes or, in the absence of local codes, with the

National Electrical Code, ANSI/NFPA 70.

Locate the electrical supply ush with the back wall and

within the shaded area shown in the illustration for your

specic installation on the following pages. For ease of

installation, the electrical supply for the oven can be placed

in an adjacent cabinet within reach of the conduit. Use only

the conduit supplied with this appliance.

Performance may be compromised if the electrical supply is

less than 240 volts.

The wiring diagram covering the control circuit is provided

with the oven.

ELECTRICAL REQUIREMENTS

SINGLE OVEN

Electrical Supply grounded, 240/208 VAC, 60 Hz

Service 30 amp dedicated circuit

Total Amps 21

Max Connected Load 5.1 kW

Min Supply Wire L1, L2, ground—10 AWG

DOUBLE OVEN

Electrical Supply grounded, 240/208 VAC, 60 Hz

Service 50 amp dedicated circuit

Total Amps 37

Max Connected Load 8.9 kW

Min Supply Wire L1, L2, ground—10 AWG

WARNING

The complete appliance must be properly grounded at

all times when electrical power is applied.

Grounding through the neutral conductor is prohibited

for new branch-circuit installations (1996 NEC); mobile

homes and recreational vehicles, or where local codes

prohibit grounding through the neutral conductor.

If aluminum house supply wiring is utilized, splice the

appliance copper wire to the aluminum house wiring

using special connectors design and agency certied

for joining copper and aluminum. Follow the connector

manufacturer's recommended procedure carefully.

Improper connection can result in a re hazard.

Rating plate location.

RATING

PLATE

Wolf Customer Care 800.222.7820

SPECIFICATIONS

E Series Single Oven

STANDARD INSTALLATION

FRONT VIEWSIDE VIEW

NOTE: Location of electrical supply within opening may require additional cabinet depth.

Dashed line represents profile of unit.

(127)

(102)

271/4"

(692)

OPENING

HEIGHT

24" (610)

OPENING

DEPTH

281/2" (724)

OPENING WIDTH

43/4"(121)

TYPICAL

TOP VIEW

wolfappliance.com

SPECIFICATIONS

FRONT VIEWSIDE VIEW

NOTE: Location of electrical supply within opening may require additional cabinet depth.

Dashed line represents profile of unit.

493/4"

(1264)

OPENING

HEIGHT

(127)

(102)

24" (610)

OPENING

DEPTH

281/2" (724)

OPENING WIDTH

17" (432)

TYPICAL

TOP VIEW

E Series Double Oven

STANDARD INSTALLATION

Wolf Customer Care 800.222.7820

SPECIFICATIONS

FRONT VIEWSIDE VIEW

*Shaded areas will be visible and should be finished to match cabinetry.

**1" (25) for professional and transitional models and 11/4"(32) for contemporary model.

NOTE: Location of electrical supply within opening may require additional cabinet depth.

Dashed line represents profile of unit.

283/8"

(721)

FLUSH INSET

HEIGHT

3/4"(19)

3/8" (10)

15/16" (24) 5"

(127)

(102)

25" (635)

FLUSH INSET

DEPTH

FINISHED

CLEATS*

303/8" (772)

FLUSH INSET WIDTH

1" (25)

11/4" (32)**

TOP VIEW

E Series Single Oven

FLUSH INSET INSTALLATION

wolfappliance.com

SPECIFICATIONS

E Series Double Oven

FLUSH INSET INSTALLATION

FRONT VIEWSIDE VIEW

*Shaded areas will be visible and should be finished to match cabinetry.

**1" (25) for professional and transitional models and 11/4"(32) for contemporary model.

NOTE: Location of electrical supply within opening may require additional cabinet depth.

Dashed line represents profile of unit.

507/8"

(1292)

FLUSH INSET

HEIGHT

17" (432)

TYPICAL

3/4"(19)

3/8" (10)

15/16" (24) 5"

(127)

(102)

25" (635)

FLUSH INSET

DEPTH

FINISHED

CLEATS*

303/8" (772)

FLUSH INSET WIDTH

1" (25)

11/4" (32)**

TOP VIEW

Wolf Customer Care 800.222.7820

Preparation

Before moving the oven, protect any nished ooring and

secure oven door(s) closed to prevent damage.

Use an appliance dolly to move the unit near the opening.

Remove and recycle packing materials. Do not lift or carry

the oven by the door handle.

CAUTION

Do not lift oven by the door handle. This will damage

the oven door and hinges.

OVEN DOOR REMOVAL

To lighten the load or to t through a door way, the oven

door(s) can be removed. Only remove if necessary. Door

removal should only be done by a certied installer or

service technician.

To remove, open the door completely. Rotate both hinge

latches forward to the open position, then lift door up and

out. Refer to the illustration below.

To reinstall, insert door hinges into frame openings, then

rotate hinge latches to the closed position.

INSTALLATION

Electrical Connection

WARNING

Verify that power is disconnected from the electrical

box before proceeding.

With the oven positioned directly in front of the opening,

feed the conduit through the opening in the cabinet platform

(if applicable). Depending on local codes, connect the oven

to the electrical supply following these steps for a three-wire

or four-wire system:

1Connect the black appliance wire to the black (L1) power

supply wire in the electrical box.

2Connect the red appliance wire to the red (L2) power

supply wire in the electrical box.

3Connect the ground appliance wire to the green/ground

house grounding wire in the electrical box.

4For a four-wire system, leave the white neutral wire in the

house electrical box unconnected. Seal with a wire cap.

CLOSED

OPEN

Oven door removal.

Autres manuels pour e Series

Table des matières

Langues :

Autres manuels Wolf Four

Wolf

Wolf L Series Manuel utilisateur

Wolf

Wolf L Series Manuel utilisateur

Wolf

Wolf DO30F/S L Series Manuel utilisateur

Wolf

Wolf L Series SO30U Instructions d'utilisation

Wolf

Wolf E Series Manuel d'utilisation

Wolf

Wolf L Series Manuel utilisateur

Wolf

Wolf E Series Guide de configuration

Wolf

Wolf 24 E Series Manuel utilisateur

Wolf

Wolf CSO30TM Manuel utilisateur

Wolf

Wolf CSO Series Manuel utilisateur

Wolf

Wolf M Series Mode d’emploi

Wolf

Wolf SO30PE/S/PH Manuel utilisateur

Wolf

Wolf E Series Manuel utilisateur

Wolf

Wolf E Series SO30-2F/S Manuel utilisateur

Wolf

Wolf CSO24 Manuel utilisateur

Wolf

Wolf M Series Manuel utilisateur

Wolf

Wolf MWD24-2U/S Manuel utilisateur

Wolf

Wolf Wall Oven-2 Series Manuel d'utilisation

Wolf

Wolf e Series Manuel utilisateur

Wolf

Wolf ICBCSO30CMS Manuel utilisateur

Wolf

Wolf SO30F/S Manuel utilisateur

Wolf

Wolf E Series Mode d’emploi

Wolf

Wolf e Series Manuel d'installation et d'exploitation

Wolf

Wolf DO30U/P Manuel du propriétaire

Manuels Four populaires d'autres marques

Bosch

Bosch HVA531NS0 Manuel utilisateur

Electrolux

Electrolux EOF6P46X Manuel utilisateur

NEFF

NEFF B44S32 5GB Series Manuel utilisateur

Combi

Combi BLODGETT BC142GDS Manuel utilisateur

AEG

AEG COMPETENCE 311704300 Manuel utilisateur

Falcon

Falcon DOMINATOR PLUS G3106 Series Guide de l'utilisateur

Rational

Rational SCC WE 61G Manuel utilisateur

Smeg

Smeg DOSPA38X Manuel d'installation et d'exploitation

Electrolux

Electrolux air-o-convect 20 GN 2/1 Manuel utilisateur

Miele

Miele HR 1954-2 Manuel utilisateur

KHIND

KHIND OT50 Manuel utilisateur

Henny Penny

Henny Penny Smoker Box Manuel utilisateur

Lang

Lang ECOD-AP Manuel utilisateur

AEG

AEG BEK455310M Manuel utilisateur

Frigidaire

Frigidaire FNGE90JGR Manuel utilisateur

Hotpoint

Hotpoint FE9 S831 JSH IX Manuel utilisateur

GE Advantium SCB2000 Manuel utilisateur

AEG

AEG DE401301DM Manuel utilisateur