Viper AS6690T Guide de l'utilisateur

Use and maintenance

Operating guidelines AS6690T / AS7190TO series

December 2019

Turn on the key and verify there is enough

battery power to complete the work.

Charge batteries if required.

Install the squeegee using the thumb nuts.

Attach squeegee hose.

Remove the red cover and ll the tank

with water, max temperature 40C/104F.

Add appropriate low foaming detergent.

Maximum tank capacity 85L/22Gall.

Check level with red ball on the side of the

machine.

Disc version: place the brush/pad holder under the scrub deck then press the OneTouchTM scrub

button to enable scrubbing, the deck will lower automatically. The vacuum will start. Push on one

of the two switches ½ second to install the brush.

Boost version: attach a pad to the xed pad holder, press the OneTouchTM scrub button and the

deck will lower automatically.

Place the machine in working mode and

press any of the two red safety switches to

activate the machine.

Pressing either of the red safety switches

and the black reverse button together will

put the machine into reverse.

On disc version, the brush/pad holder can

be removed automatically by raising the

deck and then press the click off button.

Press the + or – buttons to increase /

decrease the water ow rate or brush

pressure.

Use the rabbit /turtle knob to control the

speed of the machine.

Use the handle to lower or raise the

squeegee to the oor. Adjust the squeegee

angle with the knob to adjust suction

performance if needed.

Floor Preparation Button (orbital) for

stripping: pad pressure will be set up to

maximum, solution ow will be set to

minimum, machine speed will be held at

1 km/h 0.6miles/hour

Maintenance

Operating guidelines AS6690T / AS7190TO series

December 2019

When scrubbing is complete, turn off the

key to perform the following maintenance.

Daily: Empty the clean water tank using

the solution tank drain knob under the

machine.

Daily: Empty the recovery tank using the

recovery empty hose. Bend the soft part

before removing the cap to control the

ow.

Daily: Inspect and rinse the oat ball cage.

Inspect, check and clean the debris tray and

clean the lid gasket if required.

Local Viper dealer:

Phone number:

SN:

Daily: Remove the squeegee, and clean.

Inspect the blades and ip them or replace

them if required.

Daily: to charge the battery, connect

the charger connector to the machines

outer charging connection, and connect

the charger to the wall socket. Check the

charger indication light so the charging

have started. If the machine is supplied with

On-board charger, tip the recovery tank and

connect the on-board charger in the same

way.

Weekly: Inspect the solution lter and

clean if required.

Daily: if the battery indicator is low, put the

machine on charge. Battery should be on

charge if empty, not in use or if not being

used for coming 8-10 hours.

Daily: Leave the recovery tank lid open

after it’s been cleaned to avoid bad odor.

Autres manuels pour AS6690T

Ce manuel convient aux modèles suivants

Autres manuels Viper Machine de plancher

Viper

Viper SCRUBBER FANG 18C Manuel utilisateur

Viper

Viper TP1500 Manuel utilisateur

Viper

Viper DR1500H-EU Manuel utilisateur

Viper

Viper AS380/15 Guide de l'utilisateur

Viper

Viper VE 17P-EU Manuel utilisateur

Viper

Viper VN1500 Manuel utilisateur

Viper

Viper VR-ACF Manuel utilisateur

Viper

Viper AS6690T Manuel utilisateur

Viper

Viper VN20DS Manuel utilisateur

Viper

Viper AS380/15B-EU Manuel utilisateur

Viper

Viper Fang15B Manuel utilisateur

Viper

Viper VF1517 Manuel utilisateur

Viper

Viper Dragon DR2000DC Dust Control Manuel utilisateur

Viper

Viper AS380/15B-EU Manuel utilisateur

Viper

Viper AS530R Guide de l'utilisateur

Viper

Viper CEX410 Manuel utilisateur

Viper

Viper AS710R Manuel utilisateur

Viper

Viper AS4325B Guide de l'utilisateur

Viper

Viper VN1715 Manuel utilisateur

Viper

Viper DR1500H-EU Manuel utilisateur

Viper

Viper SCRUBBER FANG 18C Manuel utilisateur

Viper

Viper CEX410 Guide de l'utilisateur

Viper

Viper AS380/15B-EU Manuel utilisateur

Viper

Viper Fang 20HD Manuel utilisateur

Manuels Machine de plancher populaires d'autres marques

Nilfisk-Advance

Nilfisk-Advance Advance SC370 17B Manuel utilisateur

Numatic

Numatic ET 4045 Manuel utilisateur

HAWK ENTERPRISES

HAWK ENTERPRISES HP1513-180BRUTE Manuel utilisateur

Mytee

Mytee 8070 Mytee-Lite Manuel utilisateur

Kärcher

Kärcher B 140 R Manuel utilisateur

Triple S

Triple S Ace 26T1 Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance SW 750 Manuel utilisateur

Tornado

Tornado Marathon 2000 98190 Manuel

Windsor

Windsor ADMIRAL Admiral 8 Manuel utilisateur

Numatic

Numatic TTB 1117/100 Manuel utilisateur

Tennant

Tennant 8210D Manuel utilisateur

Nobles

Nobles Frontier Manuel du produit

lavina

lavina 21-X Manuel utilisateur

KENT

KENT Edge 28B Manuel utilisateur

Tennant

Tennant 215 Manuel du produit

Windsor

Windsor BDP 51/2000C Manuel utilisateur

CleanFreak

CleanFreak DURA-18HD Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance Warrior 34RST Guide de l'administrateur