10 | page
1.5. Installation of the antenna and location of the equipment for voice service
Before you select a localization to place VW400, you should read the section for their Security in the first part of this
manual. You can place it in a plane area just as the floor, the walls or the desk or table.
1. It connects the antenna at the VW400 (previously it should couple the antenna in their support, make sure of
making the one it couples in a complete way, verify that the antenna mo is slack) and locate her it more far possible
of the terminal. If the antenna is located near the VW400 noise she/he will take place during the communication,
avoid it!
* Notices: make sure of pressing the antenna completely to their connector in the terminal.
2. Using the marked port as “Phone “connects the VW400 to the DECT Phone, or to similar telephone. If their
Terminal is model VW400 and you will use similar fax, connect the fax machine to the port “Fax ".
3. Connect the adapter to the Terminal. Use the connector "DC Input."
4. Connect the adapter DC in an appropriate energy plug.
5. Turn on the terminal. Use the switch “On/Off ".
6. Checks the power of the signal EV-DO Network, verify the state of the led “Signal“(check the section 2.1). To
improve the signal reception, move the antenna and verify the state of the led “Signal".
Avoids leaving the antenna in a location in which the led illuminates red or be shut down
7. The terminal is ready to be used.
