VENTRA VLCD-WK4 Manuel utilisateur
VLCD-WK4 Wireless Camera & Monitor Kit
Specification:
Parts included:
•4.3” Wireless Monitor x 1
•Wireless IR Camera x 1
•12V Monitor Power Ca le x 1
Ventra Technology Inc. Covina, CA. USA www.ventrainc.com info@ventrainc.com Tel: 888 4183833
Model VLCD-WK4
Camera / Monitor 1 to 1
Camera 1/3.7” CMOS
Camera Lens / Resolution 2.5mm / 648 x 488
Camera Angle 120 degrees (D) / 90 degrees (H)
Camera Rating IP68 Outdoor Rated
IR LED / Distance 5 LED / Up to 15ft
LCD Screen Size 4.3” TFT LCD
Resolution 420 TVL
Transmission 2.4GHz
Brightness / Contrast 500cd/m2 / 500:1
OSD Control Contrast, Sharpness, Brightness
Viewing Mode Normal, Mirror, Flip
Latency 120ms Max
TV System NTSC / PAL
Max. Frame Rate 30 FPS Max
Monitor Power DC5V ~ 32V 180mA
Camera Power DC10V ~ 32V 220mA
PowerConsumption 12V (210~250mA)
Temperature Range –Operating 14F ~ 150F
Temperature Range -Storage -22F ~ 165F
Installation Guide
1. Determine the location of the camera mounting position. Camera may e mounted directly over / ehind the license plate or other
locations
2. Test the viewing angle y powering oth the camera and monitor first efore permanently securing the camera
3. Once location is determined, securely affix mounting racket of the camera to the vehicle via screws. (Not included)
4. Connect the 2 wires on the camera (Red = 12V Positive, Black = Ground) to a power source (i.e. tail light, reverse light or vehicle fuse)
5. Determine location to install the monitor, clean surface with damp towel. Monitor may e mounted on dash, ceiling or any flat
surface
6. Remove the adhesive on the ottom of mount and firmly affix all wedges of mount to surface y applying pressure
7. Connect the provided 12V USB power ca le into the monitor, then connect it to the vehicle AUX power outlet
Warning:
Install product only when vehicle is safely parked, leveled and power is Off
View and access the monitor only when safe to do so
Review surrounding efore operating / moving vehicle
O serve all electrical safety guideline and polarity to avoid injury
Operation
1. Monitor and Camera will automatically sync when powered on. If camera were switched, press PAIR utton on camera for 3
secs and Sync Button on Monitor)
2. To Adjust settings, press Menu utton to access Menu
3. To navigate menu options, select Up or Down arrow
4. Change Color, Brightness and Saturation
5. Change etween Normal and Mirror Viewing
6. Ena le / Disa le Distance Line y selecting the Distance Line utton
7. Turn On / Off Monitor y pressing the Power Button (12V Aux power ca le has On / Off utton as well)
VLCD-WK4 Wireless Camera & Monitor Kit
Ventra Technology Inc. Covina, CA. USA www.ventrainc.com info@ventrainc.com Tel: 888 4183833
Sync Camera
Change etween Normal / Mirror View Adjust Image
Menu
Autres manuels VENTRA Appareil photo numérique
