1. To avoid damaging The VP2 only uses the components and accessories that are meant to be used
with it: The 801, RN4072 cartridges and Atomizer, AA 14500 Battery, and Charger.
2. The Charger works under normal conditions with the voltage at AC100V, 50/60HZ.
3. The VP2 should not be dropped or allowed to hit anything hard.
4. If there appears to be a malfunctioning VP2 component, do not attempt to take it apart. Please contact
where you purchased.
Cautions and Warnings
Cautions and Warnings
CAUTION: The Allen set screw opposite the switch, is to keep switch in location.
Tampering with it will make the unit fail, and void the warranty
ADAPTERS: Always put atomizer on adapter first, then screw adapter onto VP
unit just enough to be snug. This allows you to get the designed air flow from the
atomizer.
1. Keep the VP2 away from high temperatures when using or storing it.
2. Keep all parts of The VP2 out of children’s reach.
3. The Vp2 is prohibited for use by anyone other than an adult (over 18), non-pregnant, non-nursing
smoker.
4. For users that may tend to a sore throat or may have an adverse or sensitivity reaction to nicotine or
the food additive propylene glycol, stop using The E CIG immediately and consult a physician.
5. Keep the Batteries away from loose metallic items in your purse, pockets, bags, or any other place of
storage. Foreign metallic items could potentially short circuit the battery causing it to heat up and
possibly cause permanent damage.
7. For best results try to smoke The VP2 at the same times and durations that you would normally
smoke your traditional cigarette.
8. If using The E CIG while driving, use extreme caution and pay attention to the road.
9. Before attempting to clean the outside of the Charger or any of the plugs or cords you must first
unplug them from the wall outlet, cigarette lighter outlet, or computer. Never use any chargers or plugs
in damp or wet conditions. Use extreme caution if using the charger outdoors.
Product Description
1. Components of the VP2 HOUSING BODY.
The body of The VP2 is composed of the cavity for (1) one AA 14500 lithium battery. The switch and
LED light ring and an 801 e cig battery fitting.
Please Note: To install or replace the battery, unscrew the end, turn counterclockwise to remove, turn
clockwise to tighten until snug. Do not over tighten. Keep threads and end cap clean, because you will
lose some power if the end cap gets built up with dirt.
The Atomizers are standard pen style 801. To fill push fiber down into the white cap with a paper clip
or similar device. Fill to top, then lift fiber up to rim of white cap housing. Cap off and install in
atomizer.
