VAF instruments EVT-20 Manuel utilisateur
EVT-20 EVT-30
Interface board with DONGLE Interface board with MICRO SD-CARD
Operating instruction EVT-20 – DONGLE
An EVT-20 dongle is used for making the correct Interface board settings when an EVT-20
sensor is replaced.
Please make sure that serial number on both the dongle and the new EVT-20 sensor are
identical.
For replacing the sensor we refer to our TIB-767-AL.
Please note that the power supply must be connected to the interface board, when using the
dongle.
Please take necessary precautions to avoid personal injury.
STEP 1
Open EPC50 cabinet
STEP 2
Insert dongle in interface-box
STEP 3
Switch on dongle.
The red LED is burning.
STEP 4
Wait until green LED starts blinking and
switch off dongle.
If green light does not start blinking, please
repeat
steps 2-4
STEP 5
Close EPC50 and the system is ready for
use.
The dongle can be disposed according to
local rules after use.
EVT-20 EVT-30
Interface board with DONGLE Interface board with MICRO SD-CARD
Operating instruction EVT-30 – MICRO SD-CARD
An EVT-30 micro sd-card is used for making the correct Interface board settings when an
EVT-30 sensor is replaced. Please make sure that serial number on both the micro sd-card
and the new EVT-30 sensor are identical.
For replacing the sensor we refer to our TIB-781-AL.
Please note that the power supply should NOT be connected to the interface board, when
changing the micro sd-card.
Please take necessary precautions to avoid personal injury.
STEP 1
Open EPC60 cabinet. Make sure the
power of the interface board is switched
off.
STEP 2
Open the interface board, by removing
topplate.
To do so, remove screws as on picture.
STEP 3
Remove the micro sd-card out of its slot.
A Slide the metal cover down over the
PCB- board, just a little, in the arrow
direction.
BAfter a small click, the cover will be
ejected upwards.
CLift the cover straight up.
DSlide the micro sd-card out of the
cover.
Pay attention not to mix the old
and new micro sd-cards.
Please note that data is saved on the
micro sd-card which may be used for
future analyses.
STEP 4
Place the new micro sd-card in the
interface box in reverse direction when
removing it.
Follow step 2D – 2C – 2B – 2A
STEP 5
Close the interface board in reverse
direction when removing it in step 2.
STEP 6
Switch on the power of the interface
board.
The new settings will be automatically
loaded.
STEP 7
Close EPC60 cabinet and the system is
ready for use.
Revision 0515:
Operating instruction EVT-30 – Micro sd card added
Publ. No. SIG-905-AL-GB-0515
Supersedes SIG-905-AL-GB-0711
Ce manuel convient aux modèles suivants
1
Table des matières
Autres manuels VAF instruments Matériel informatique
Manuels Matériel informatique populaires d'autres marques
EMC2
EMC2 VNX Series Manuel du propriétaire
Panasonic
Panasonic DV0PM20105 Manuel utilisateur
Mitsubishi Electric
Mitsubishi Electric Q81BD-J61BT11 Manuel utilisateur
Gigabyte
Gigabyte B660M DS3H AX DDR4 Manuel utilisateur
Raidon
Raidon iT2300 Manuel utilisateur
National Instruments
National Instruments PXI-8186 Manuel utilisateur
