UTC RETAIL T6100 Manuel utilisateur
© 2021 UTC RETAIL.
All rights reserved. 11977004 Rev A
T6100 Convertible Tablet POS System
INSTALLATION GUIDE
Thank you for selecting UTC RETAIL’s innovative T6100 Convertible Tablet POS System. Its
unique design provides the flexibility to function as a mobile tablet or a countertop POS system.
This guide is designed to assist you with the installation of your system.
11977004 Rev A 2 © 2021 UTC RETAIL
All rights reserved.
Preparing for Installation
Safety Precautions
DANGER: High Voltage
This unit contains high voltage. There is a risk of electrical shock if the case is opened. If service is required, contact
an authorized service agent or UTC RETAIL (UTC).
WARNING: Access to Internal Components
All access to internal components of the T6100 unit is restricted to Authorized Service Personnel only. Opening the
case or service by anyone else will automatically void the warranty on this product.
WARNING: Electrical Shock
Use caution when connecting cables. To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits
to telephone-network voltage (TNV) circuits. Local Area Network (LAN) ports contain SELV circuits, and telephone
ports contain TNV circuits. Some LAN ports and some telephone ports use RJ-45 connectors.
CAUTION:
Damage to the logic module components may occur if AC power is not removed from the product prior to attaching any
accessories.
This document may not be used for any purpose other than its intended use. This document
must be downloaded in its entirety; it may not be reproduced, stored or transmitted in part
without the prior written permission of UTC RETAIL. All attempts have been made to ensure
that the information presented in this document is correct. No liability, expressed or implied, will
be assumed by UTC RETAIL, its dealers, or affiliates, for damage resulting from the use of this
information.
© 2021 UTC RETAIL
All rights reserved. 3 11977004 Rev A
Installing the T6100 Convertible Tablet POS Workstation
T6100 Components
You will find the following components inside the T6100 Convertible Tablet System box:
•The T6100 Tablet
•The T6000 Base Stand
•A/C power cord
•120W Power Adapter
Depending on the configuration purchased, the optional integrated MSR accessory, scanner or
rear camera may also be installed onto the T6100.
AC Power Cable and Power Adapter
The UTC RETAIL T6100 comes with an AC power cord and power adapter. The AC power
cord should be inserted into the power adapter. The power adapter can then be connected to
the T6100 base stand using the 19V DC IN port shown below (circled in yellow).
WARNING: To avoid accidental power-up during installation, connect the AC Power Cable to
line voltage after installing all the peripheral devices.
Mounting Tablet to the Base Stand
To mount the tablet to the base stand, the base stand must be powered up. If the base stand is
not powered up, the tablet will not be securely attached and could fall off and be damaged.
The image below shows the base stand without the tablet secured. To attach the tablet to the
base stand be sure the tablet is oriented with the power switch on top. Then line up the tablet
attachment recess on the back of the tablet with the top of the base stand. The tablet will be
magnetically aligned and will automatically lock.
11977004 Rev A 4 © 2021 UTC RETAIL
All rights reserved.
The tablet will start charging once attached to the base stand.
To remove the tablet from the base stand, press the lock button located on the front of the base
stand. The base indicator light will turn from blue (tablet locked) to green (tablet unlocked). You
will hear an audible indicator that the tablet has been unlocked form the base stand and can
then be removed. The base indicator light will turn off once the tablet is removed from the base.
Turning the Tablet On
The power button for the tablet is located on top of the unit (circled in yellow).
To power up, hold the power button for 2 seconds and release.
Powering down the tablet should be performed using the operating system.
NOTE: If the tablet is in sleep mode, pressing the power button for ½ second takes it out of
sleep mode.
© 2021 UTC RETAIL
All rights reserved. 5 11977004 Rev A
Battery Indicator
The tablet power indicator light is located on the lower left of the tablet screen.
•A green light indicates battery is fully charged
•An orange light indicates the battery is charging
•A flashing red light indicates the battery is low
•A red light indicates the battery is nearly depleted
The tablet power indicator light will turn off when removed from the base stand.
Base Stand I/O Panel
The I/O panel located at the bottom of the base stand (pictured above) is labeled and contains:
•Locking 19V power input jack
•LAN port
•3 USB 2.0 ports
•2 COM ports
•2 powered USB ports (24V, 12V)
•Cash drawer port
There is one USB 2.0 port located on the front of the base stand.
Projected Capacitive Touch Screen
The T6100 has a durable projected capacitive multi-touch screen that has been factory
calibrated and will not require any additional driver installation when used with most current
operating systems, such as Windows 10.
For additional assistance, please contact your account representative or:
UTC RETAIL
100 Rawson Road
Victor, NY 14564
Phone: 1.800.349. 0546 or (585) 924.9500
www.utcretail.com
Table des matières
Autres manuels UTC RETAIL Terminal tactile
UTC RETAIL
UTC RETAIL ultimatouch 1800 series Manuel utilisateur
UTC RETAIL
UTC RETAIL 3100 Series Manuel utilisateur
UTC RETAIL
UTC RETAIL 3190 Series Manuel utilisateur
UTC RETAIL
UTC RETAIL 5170 Manuel utilisateur
UTC RETAIL
UTC RETAIL 3170 Series Manuel utilisateur
UTC RETAIL
UTC RETAIL 2170 Manuel utilisateur
UTC RETAIL
UTC RETAIL 4100 Manuel utilisateur
UTC RETAIL
UTC RETAIL 3100 Series Mode d’emploi
UTC RETAIL
UTC RETAIL 3100 Series Manuel utilisateur
UTC RETAIL
UTC RETAIL 2250 Manuel utilisateur
Manuels Terminal tactile populaires d'autres marques
Wincor Nixdorf
Wincor Nixdorf iPOS plus Advanced Manuel utilisateur
Ingenico
Ingenico AXIUM EX4000 Manuel utilisateur
Heisei Electronics
Heisei Electronics Q-POS 815 Manuel utilisateur
Amano
Amano MTX-15 Manuel utilisateur
FLOWBIRD
FLOWBIRD CWT Compact Touch Manuel utilisateur
Demco
Demco SP7 Manuel utilisateur
