USX-MOUNT WML018-01 Manuel utilisateur

42-100" Full Motion TV Wall Mount

Model: WML018-01

PRODUCT GUIDE

①

Congratulations on your latest purchase.Follow these simple instructions and

you'll have your TV mounted in no time.

?If you have any questions along the way, just give us a call

1-800-460-0956 or mail to customerservice@x-mount.com.

We’re ready to help!

DIMENSIONS:

TV INTERFACE: SIDE VIEW-RETRACTED:

TOP VIEW: SIDE VIEW-EXTENED:

+45°/-45°

72.5mm

+5°

-15°

≈260mm

360mm

MAX:600mm

MIN:200mm

662mm

672.6mm

299.3mm

MAX:

400mm

MIN:

100mm

430mm

472mm

Supports most 42 in - 100 in (106.68 cm - 254.00 cm) TVs

Maximum Weight Capacity: 150 lbs(68 kg)

Supports VESA Sizes up to 600mmx400mm

SAFETY WARNING:

1.Never let children climb on product or play with product.

2.Do not sit or stand on product.

3.Do not fasten a TV that is heavier than the recommended load rating to the mount.

4.Using suitable concrete wall or wood stud wall.

5.Improper installation may cause property damage and/or personal injury, so the

installation must be done by two qualified contractors. The manufacture is not liable for

damage or injury caused by incorrect mounting, assembly or use.

6.Improper handling can result in cuts or lacerations.

CAUTION : This mount is intended for use with TV weights not exceeding "

maximum weight capacity 150 lbs." The wall itself has to be capable of supporting 4

times standard weight. Please don't over tighten screws in order to avoid any injury.

Use with products heavier than the maximum weights indicated may result in collapse

of the mount and its accessories causing possible injury.

Parts list:

②

ASSEMBLY TIPS:

1.Become familiar with the instructions and all parts.

2.Make sure that all parts are in the box and in good condition.

3.Assemble the product on the open flat carton or a rug to protect the product and your

floor.

4.Some heavy products need a second person to assist in the assembly. Do not install

on sloping surface.

A--Wall plate

1pc

B--Bracket

2pcs

Hanging template

1pc

HANGING TEMPLATE

③

Step 1: Install wall plate on the wall.

For concrete wall: Hold hanging template against wall at desired position on

concrete wall, then using a pencil mark 4 hole locations. Then drill holes

according pencil marks using 3/8" size drill bit to a depth of 2.5". Please remove

the hanging template on the surface of concrete wall when assembling mount on the

concrete wall. Then you will need to use wall anchors (D). Insert wall anchors (D)

into holes, you may need to use hammer to lightly tap wall anchors into wall.

Then fix wall plate unit (A) to the wall with lag bolts (C). (Figure 1)

CAUTION: The concrete wall minimum thickness no less than 8 inches, and

surface covering can't more than 3/8 inches.

CAUTION: Don't use anchor on the concrete block.

Figure 1 (keep the wall plate level)

TV mounting hardware:

Wall mounting and TV bracket assembly hardware:

E--Allen key

1pc

F--Bubble Level

1pc

C--Lag bolt

4pcs

D--Anchor

4pcs

a--M4x12 screw

4 pcs

d--M4x30 screw

4 pcs

b--M6x12 screw

4 pcs

e--M6x35 screw

4 pcs

c--M8x25 screw

4 pcs

f--M8X45 screw

4pcs

k--M4 washer

4pcs

l--M6 washer

4pcs

h--10mm spacer

4pcs

i--2.5mm spacer

8pcs

g--M8 spacer

4pcs

j--M6 spacer

4pcs

3/8"

Hanging template

Concrete wall

a/b/c

k/l

d/e/f

k/l

g/h/i/j

Stud

finder

7/32"

For wood studs: If you mount TV mount into wood studs, hold mounting

template at desired position of wood stud, pre-drill the mark 4 holes using

7/32" drill bit to a depth of 2.5", fix wall plate unit (A) to the wall with lag

bolts (C) . (Figure 2)

CAUTION: The wood stud min size is 2x4 inches, and surface covering can't be

more than 5/8 inches. Drill hole on the wood stud middle line.

NEVER USE ANCHOR (D) FOR WOOD STUDS ASSEMBLY

④

Wood Studs

Figure 2 (keep the wall plate level)

Step 2: Attach bracket (B) to the back of TV, choose corresponding screw, washer,

spacers to fix the holes of TV rear. (Figure 3)

CAUTION: Using incorrect spacers may damage your TV.

Figure 3

Choose suitable

screws, washers

and spacers.

Choose suitable

screws and washers.

⑤

Figure 4

1 2

CAUTION: This step must require 2 or more people to finish.

Pull

down

Step 3: Hang the pre-assembled TV unit onto the horizontal bars of the wall plate unit.

Pull down straps to lock the brackets in the bar (Figure 4).

Step 4: Move the fixed block close to brackets, then fasten the screws with

screwdriver to ensure the brackets unmovable. (Figure 5)

Figure 5

Step 6: You may need loosen the handle to tilt TV to your desired angle,

please remember to fasten the handle tightly after adjustment. (Figure 7)

Figure 6

Bolts

-15°

+5°

±45°

Tighten

Loosen

Step 5: Make sure the TV unit is horizontal, you can adjust the TV plate a little bit

(+3/-3 degrees) to level the TV, then fasten TV plate by bolts with Allen key (E).

(Figure 6)

±3°

Figure 7 ⑥

PAY EXTRA CARE AND ATTENTION WHEN YOU FASTEN TWO TV BRACKETS

TO THE BACK PANEL OF TV IN STEP 2 . MAKE SURE THE APPROPRIATE

MOUNT HARDWARE IS BEING USED PROPERLY .

1. Select correct Mounting Hardware according to the screw hole size of your TV,

discard any remaining screws or spacers.

2. Carefully lay your TV on its face on a non-abrasivesurface, making sure to lay

padding underneath it so as not to damage the screen .

3. Place left TV bracket and right TV bracket in the appropriate position, making sure

CENTERED on the back of the TV and LEVEL with on another .

4. This product only install on the perpendicular wall,not install on the ceiling.

Step 7: Manage TV cables orderly and guide them through the velcros. (Figure 8)

Figure 8

⑦

Table des matières

Autres manuels USX-MOUNT Support TV

USX-MOUNT

USX-MOUNT XML018-03 Manuel utilisateur

USX-MOUNT

USX-MOUNT XMS008-1 Manuel utilisateur

USX-MOUNT

USX-MOUNT XMS008-03 Manuel utilisateur

USX-MOUNT

USX-MOUNT XML008-K-1 Manuel utilisateur

USX-MOUNT

USX-MOUNT XML006-24K-1 Manuel utilisateur

USX-MOUNT

USX-MOUNT XML018-09 Manuel utilisateur

USX-MOUNT

USX-MOUNT SMM015-01 Manuel utilisateur

USX-MOUNT

USX-MOUNT XML012-01 Manuel utilisateur

USX-MOUNT

USX-MOUNT XML006-K1 Manuel utilisateur

USX-MOUNT

USX-MOUNT XAS005-01 Manuel utilisateur

USX-MOUNT

USX-MOUNT XML019-01 Manuel utilisateur

USX-MOUNT

USX-MOUNT XML006-K Manuel utilisateur

USX-MOUNT

USX-MOUNT XML020-24K-15 Manuel utilisateur

USX-MOUNT

USX-MOUNT XTL090-15 Manuel utilisateur

USX-MOUNT

USX-MOUNT XAS005 Manuel utilisateur

USX-MOUNT

USX-MOUNT XMS010-L-09 Manuel utilisateur

USX-MOUNT

USX-MOUNT XML019-1 Manuel utilisateur

USX-MOUNT

USX-MOUNT XTM006-1 Manuel utilisateur

USX-MOUNT

USX-MOUNT XML025-09 Manuel utilisateur

USX-MOUNT

USX-MOUNT XTM090-15 Manuel utilisateur

USX-MOUNT

USX-MOUNT STM012-01 Manuel utilisateur

USX-MOUNT

USX-MOUNT WFL009-01 Manuel utilisateur

USX-MOUNT

USX-MOUNT XML025-03 Manuel utilisateur

USX-MOUNT

USX-MOUNT WML016-01 Manuel utilisateur

Manuels Support TV populaires d'autres marques

Ergotron

Ergotron Neo Flex Cantilever UHD Manuel utilisateur

StarTech.com

StarTech.com FPCEILBTB Manuel utilisateur

VonHaus

VonHaus 05/038 Manuel utilisateur

Techlink

Techlink ECHO TV Manuel utilisateur

Sandstrom

Sandstrom SSTVMC12X Manuel utilisateur

Sony

Sony SU-WL700 Mode d’emploi

ICW

ICW SCACC18 Manuel utilisateur

LG WM-L640V Manuel utilisateur

Gembird

Gembird WM-65ST-01 Manuel utilisateur

ERARD

ERARD FiTUP XXL 035320 Manuel utilisateur

PEERLESS

PEERLESS PLCK-1 Mode d’emploi

Kanto

Kanto RCF180 Manuel utilisateur

GEM

GEM GEM GP001 Manuel utilisateur

Gladiator Joe

Gladiator Joe GJ0A0053 Manuel utilisateur

Vivotek

Vivotek AM-105 Manuel utilisateur

Vivo

Vivo VESA STAND-VAD1B Manuel utilisateur

AmazonBasics

AmazonBasics B07QG3LMG4 Manuel utilisateur

Secura

Secura QLF210 Manuel utilisateur