Turboair TOM-40 Mode d'emploi

Turbo air Speeds UP the Pace of Innovation

OPEN DISPLAY MERCHANDISER

Installation and Operation Manual

Please read this manual completely before attempting

to install or operate this equipment!

CONTENTS

INTRODUCTION 1

DESCRIPTION 3

INSTALLATION INSTRUCTIONS 3~4

Inspection for damage

Location of Display

Leveling of Display

OPERATING INSTRUCTIONS 5

Controls

Light Switch

Temperature Control

Thermometer

How to place product

MAINTENANCE & CLEANING 6~7

Condenser coil

TROUBLE SHOOTING 8

Display not working

Display case warm

TOM-40

Lights not working

TOM-50 WARRANTY STATEMENT 9~13

INTRODUCTION

This owner’s manual has important information. Please read the entire

manual before installing your new Turbo Air Open Display Merchandiser.

After reading manual if you have any question, please feel free to call:

CUSTOMER SERVICE DEPARTMENT

TURBO AIR

1250 VICTORIA ST.

CARSON, CA 90746

1-800-381-7770

Please write down model and serial number for making any reference to this

unit.

MODEL NUMBER

SERIAL NUMBER

WARNING!

Failure to read this manual completely can result in personal

injury or damage to the unit.

Keep manual in a safe place to refer to in the future.

WARNING!

Display should be on dedicated outlet for

proper operation.

Thank you for purchasing Turbo Air!

DESCRIPTION

Model

Dimension (W×D×H)

TOM – 40(B)

26.83×38.99×77.98 in TOM – 50(B)

26.83×50.39×77.98 in

Electricity 120V/1Ph/60Hz

Total Ampere 16A 16A

Compressor CAJ9513Z

Refrigerant R-404a

Lighting 30W×5 32W×5

Type of Control Micro process

Type of Defrosting Timed off defrost

Weight of Case 507 lbs 573 lbs

INSTALLATION INSTRUCTIONS

INSPECTION FOR DAMAGE

Customer is responsible for checking for damage. First inspect crate as

soon as it arrives. Prior to signing if crate is damaged make sure you note

that on bill of lading.

If after uncrating there is concealed damage and crate was in good condition

you must call Customer Service at Turbo Air. Concealed damage must be

reported within 24 hours of receiving unit. Bill of lading will be requested

faxed to claim department. Pictures may be requested of unit and crating.

LOCATION OF OPEN DISPLAY

MERCHANDISER

Display is designed to be in an ambient 75 degrees Fahrenheit (dry

bulb) or colder and 55 percent relative humidity. If unit is installed

in a warm ambient, Display will not cool effectively. Move the

display to the final location before removing shipping skid. Allow 3

inches from back of Display to wall. Condenser is in front of Display.

Do not block inlet.

There are four bolts at bottom of display that secure it to shipping

skid, remove all four.

LEVELING OF OPEN DISPLAY

MERCHANDISER

Four leveling legs are provided for leveling Display. If you do not

wish to use levelers they can be turned inwards.

Bottom frame of unit will be on floor. Use a leveler to make sure

unit is leveled on all four corners.

If unit is not leveled drainage of water will not drain properly.

Leveling legs can be adjusted accordingly.

OPERATING INSTRUCTIONS

After installing unit and plugging in unit to correct voltage, Display is ready

to start up.

CONTROLS

LIGHT SWITCH: It is located on top right hand side by display.

TEMPERATURE CONTROL : Temperature is preset from factory at

45℉. To reset temperature for another setting, push button that has a bell

for one second and release.

Then press the buttons next to it to raise or lower temperature. Up is for

warmer and down is for colder. After setting temperature, button with bell

needs to be pushed again to set temperature.

THERMOMETER: Display shows temperature on start up. As it gets

colder it will go lower till it reaches temperature that was set.

NOTE:

Before placing product to display, wait for unit to reach desired temperature.

Do not place hot product in unit.

HOW TO PLACE PRODUCT: Do not overload product on shelves. Do

not place product against back wall, due to air flow will be blocked and

cause unit not to cool properly.

MAINTENANCE & CLEANING

!!! Always before cleaning Display, unit should be turned off at

power switch and lights

should be turned off. Remove product and allow display to reach

room temperature

!!! Do not wet electrical components.

DISPLAY CASE SHOULD BE CLEANED

THOROUGHLY BEFORE FIRST USE.

a.Do not clean with harsh detergents. Use a mild soap

b.Remove all products.

c. Remove shelves and bottom trays.

d. Clean interior with warm water and mild detergent.

e. Wipe with damp cloth. Do not leave residue of soap.

CONDENSER COIL

Condenser coil is located at bottom behind panel.

1.Unplug the power cord.

2.Press pushlocks,located 10mm inside

from each end of the front cover

simultaneously.

3.Hold both ends of front cover and lift

it up slightly.then the front cover will

be disassembled.

4.Brush off all dirt, from the finned

condenser coil.

5.After cleaning, place, reassemble in reverse order of disassembly.

(no3->no.1)

6. Plug in the power cord.

7.Condenser must be cleaned every month.if not,it can be a cause of trouble

or defect.

TROUBLE SHOOTING

For any problems with Display please refer to the following check

list. If still having a problem or need to ask a question please call

Customer service at 1-800-381-7770.

LETTERS DF ON DISPLAY

This is normal. On display a green light comes on. Defrost is for

20 minutes. The letters on the display disappear and then there

is a five minute pause. Light blinks then compressor comes on.

When compressor comes on light stops blinking and stays on

DISPLAY NOT WORKING

a. Check power going to unit.

b. Check power switch is on.

DISPLAY CASE WARM

a.Check condenser to see if clean

b.Check that air flow inside of unit is not blocked with product.

LIGHTS NOT WORKING

a.Check that light switch is on.

b.Check that light is in lamp holder correctly.

WARRANTY STATEMENT

Warranty claims

All claims for labor or parts must be made directly through Turbo Air. If unit

was manufactured more than one year, proof of purchase must be faxed in

or sent with claim. All claims should include: model number of the unit, the

serial number of the cabinet, and all pertinent information supporting the

existence of the alleged defect. If compressor is replaced under warranty,

Turbo Air either requests the compressor or compressor tag be returned.

Compressor or tag must be returned with all information related to the unit.

Any action or breach of these warranty provisions must be commenced

within six months after said cause of action has occurred.

One Year Parts & Labor Warranty

Turbo Air warrants to the original purchaser of every new Turbo Air

refrigerated unit, the cabinet and all parts thereof, to be free from defects in

material or workmanship, under normal and proper use and maintenance

service as specified by Turbo Air and upon proper installation and startup in

accordance with the instruction packet supplied with each Turbo Air unit.

Turbo Air’s obligation under this warranty is limited to a period of one (1)

year from the date of original installation or 15 months after shipment date

from Turbo Air, whichever occurs first. Any parts, covered under this

warranty, that are determined by Turbo Air to have been defective within

one(1) year of original installation or fifteen(15) months after.

Shipment date from manufacture, whichever occurs first, is limits

to the repair or replacement, including labor charges, of defective

parts or assemblies. The labor Warranty shall include standard

straight time labor charges only and reasonable travel time, as

determined by Turbo Air

Additional Four Year compressor Warranty

In addition to the one (1)year warranty stated above, Turbo Air

warrants its hermetically sealed compressor to be free from

defects in both material and workmanship under normal and

proper use and maintenance service for a period of four(4)

additional years from the date of original installation, but not to

exceed five(5) years and three(3) months after shipment from the

manufacturer. Compressor determined by Turbo Air to have been

defective within this extended period will, at Turbo Air’s option,

be either repaired or replaced with a compressor or compressor

parts of similar design and capacity.The four(4) year extended

compressor warranty applies only to hermetically sealed parts of

the compressor and does not apply to any other parts or

components, including, but not limited to, cabinet, paint finish,

temperature control, refrigerant, metering device, driers, motor

starting equipment, fan assembly or and other electrical

component, etcetera.

404a Compressor warranty

The four-year compressor warranty detailed above will be voided if the

following Procedure is not carefully adhered to:

1.This system contains R404A refrigerant and polyolester lubricant The

polyol ester lubricant has rapid moisture adsorbing

qualities

2.Drier replacement is very important and must be changed when a system

is opened for servicing. A 032 drier or better is highly recommended.

3.Micron level vacuums must be achieved to insure low moisture levels in

the system. 500 microns or lower must be obtained.

4.When compressor is grounded, suction filter drier and 620 drier or better

must be replaced.

5.Compressor must be obtained through Turbo Air inc. unless otherwise

specified in writing, through Turbo Air’s warranty department.

What is not covered by this warranty

Turbo Air’s sole obligation under this warranty is limited to either repair or

replacement of parts, subject to the additional limitations below. This

warranty neither assumes nor authorizes any person to assume obligations

other than those expressly covered by this warranty.

No consequential damages

Turbo Air is not responsible for economic loss; profit loss or special,

indirect, or consequential damages, including without limitation,

losses or damages arising from food or product spoilage claims

whether or not on account of refrigeration failure.

Warranty is not transferable This warranty is not assignable

and appliers only in favor of the original purchaser/ user to whom

delivered. Any such assignment or transfer shall void the warranties

herein made and shall void all warranties, express or implied,

including any warranty of merchantability or fitness for a particular

purpose.

Improper usage Turbo Air assumes no liability for parts or labor

coverage for component failure or other damages resulting from

improper usage or installation or failure to clean and/ or maintain

product as set forth in the warranty packet provided with the unit.

Alteration, neglect, Abuse, Misuse, Accident, Damage

During Transit or Installation, Fire, Flood, Acts of god.

Turbo Air is not responsible for the repair or replacement of any

parts that TurboAir determines have been subjected after the date of

manufacture to alteration, neglect, abuse, misuse, accident, damage

during transit or installation, fire, flood or act of God.

Improper electrical Connections :

Turbo Air is not responsible for the repair or replacement of failed or

damaged components resulting from electrical power failure, the use of

extension cords, low voltage, or voltage drops to the unit.

No Implied Warranty of Merchantability or fitness for a

Particular purpose :

There are warranties, express, implied or statutory, except the one (1) year

warranty and the additional four (4) year compressor warranty no other as

described above. These warranties are exclusive and in lieu of all other

warranties, including implied warranty and merchantability or fitness for a

particular purpose. There are no warranties which extend beyond the

description on the face hereof.

Outside U.S and Canada :

This warranty does not apply to, and Turbo Air is not responsible for, any

warranty claims made on products sold or used outside the United States

and Canada.

1250 Victoria Street

CARSON, CA 90746

TEL: 310-900-1000

FAX: 310-900-1077

Toll Free: 1-800-627-0032

(U.S.A and Canada)

http://www.turboairinc.com

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Turboair marchandiseur

Turboair

Turboair TCGB-36-2 Manuel utilisateur

Turboair

Turboair TGM-69R Manuel utilisateur

Turboair

Turboair Jumbo TJMR-30SD N Series Manuel utilisateur

Turboair

Turboair TCB-5R Manuel utilisateur

Turboair

Turboair TOM-30L Manuel utilisateur

Turboair

Turboair TOM-36L-UF-S-N Series Manuel utilisateur

Turboair

Turboair Super Deluxe Series Manuel utilisateur

Turboair

Turboair TGM-5R-N Series Manuel utilisateur

Turboair

Turboair TCB-5R Manuel utilisateur

Turboair

Turboair TB-4 Manuel utilisateur

Turboair

Turboair TGIM-23* Manuel utilisateur

Turboair

Turboair TD-5R Manuel utilisateur

Turboair

Turboair TGM-22RV Manuel utilisateur

Turboair

Turboair TOM-30S Manuel utilisateur

Turboair

Turboair TGM-14RV Manuel utilisateur

Turboair

Turboair TOM-36DX Manuel utilisateur

Turboair

Turboair TGM-22RVB Manuel utilisateur

Turboair

Turboair TGM-50RS Manuel utilisateur

Turboair

Turboair TOM-40M Series Manuel utilisateur

Turboair

Turboair TOM-36UC-N Series Manuel utilisateur

Turboair

Turboair TGM-11RV Manuel utilisateur

Manuels marchandiseur populaires d'autres marques

FRIGOGLASS

FRIGOGLASS Flex 20 HC Manuel utilisateur

Hussmann

Hussmann ENTYCE TY3 Manuel utilisateur

EPTA

EPTA COSTAN RHINO MULTI Manuel utilisateur

Hussmann

Hussmann CRFD Mode d'emploi

CASCO

CASCO Nano Cube Manuel utilisateur

Hussmann

Hussmann WDCHI Manuel utilisateur

True

True GDIM-26 Manuel utilisateur

Structural Concepts

Structural Concepts Oasis Mobile Series Instructions d'installation

Hussmann

Hussmann Q2-SS Instructions d'utilisation d'origine

Haussmann

Haussmann RL Manuel utilisateur

Howard McCray

Howard McCray R-CDS32E-4 Manuel utilisateur

Hussmann

Hussmann microSC SHM-A Series Manuel utilisateur

Hussmann

Hussmann APT0500 Manuel utilisateur

EPTA

EPTA iarp Cool Emotions Delight Lite Manuel utilisateur

VALERA

VALERA BC 85 Manuel utilisateur

HL Display

HL Display 3eBin Manuel utilisateur

Hussmann

Hussmann Q1-SS Mode d’emploi

Hussmann

Hussmann impact Excel C2X-XLEP Mode d’emploi