TCB-1100
English10
Transceiver Controls and Functions
channel, just turn the channel knob to select a new one. You may select
the emergency channel. To stop this function, press momentarily again
this button.
If you press the PTT button whilst receiving a signal in dual watch mode
the transceiver will transmit on the currently displayed channel.
will transmit on the currently displayed channel. If you press the PTT
button when no signal is present the transceiver will transmit on the
primary channel.
Scan : Press this button momentarily to start scan-
ning upward to catch any channels that are occu-
pied by others.
10) Scan & Scan Memory Button
Scan / Scan Memory
VOX : Press and hold this button, and this will allow you to use vox func-
tion. “VOX” is displayed. The Vox level is pre-selected and memorized
in the MENU mode.
To activate/deactivate the channel scan, press the Scan button briefly.
The Scan icon will appear when the channel scan is active. Scanning
will only stop when you deactivate the scan function.
Turn the channel selector counter-clockwise during scanning in order to
change the scanning direction.
The transceiver will scan through the whole transceiver channels. If
your transceiver detects a valid signal the scan will pause for the period
that has been set by the menu mode setting (continuously receiving or
1-99 seconds for scan receive time and immediate response or 1-99
seconds for scan delay time).
If you press the PTT button when your transceiver detects a signal, the
radio will transmit on the same channel. Scanning will resume after the
scan receive time and/or the scan delay time. Use the channel selector
to resume scanning immediately.
Scan Memory : It is possible to memorize or erase any channel(s) in
the scan memory list. When a channel or channels are contained in
the scan memory list, the channels are scanned by the scan activation
For user convenience, all the channels are memorized in the list upon
shipment from the factory, and “M” is displayed with the memorized
channels. To erase the displayed channels from the scan memory list,
press and hold the button.
