Troxler 3411-B Mode d’emploi
Troxler gauges are protected by U.S. and foreign patents.
Copyright ©2005, 2006
Troxler Electronic Laboratories, Inc.
All Rights Reserved
No part of this manual may be reproduced or transmitted in any
form or by any means, electronic or mechanical, including
photocopying, recording, or information storage and retrieval
systems, for any purpose without the express written permission of
Troxler Electronic Laboratories, Inc.
PN 110247
February 2006
Edition 2.1
ii
Model 3411-B Advanced Control Unit iii
TROXLER SERVICE CENTERS
Troxler Corporate Headquarters
3008 Cornwallis Road
P.O. Box 12057
Research Triangle Park, NC 27709
Phone: 1.877.TROXLER (1.877.876.9537)
Outside the U.S.A.: +1.919.549.8661
Fax: +1.919.549.0761
Web: www.troxlerlabs.com
Technical Support
Phone: 1.877.TROXLER (1.877.876.9537)
Midwestern Branch Office
1430 Brook Drive
Downers Grove, IL 60515
Fax: 630.261.9341
Western Regional Branch Office
11300 Sanders Drive, Suite 7
Rancho Cordova, CA 95742
Fax: 916.631.0541
Southwestern Branch Office
2016 East Randol Mill Road
Suite 406
Arlington, TX 76011
Fax: 817.275.8562
Florida Service Center
2376 Forsyth Road
Orlando, FL 32807
Fax: 407.681.3188
Canadian Branch Office
7125 Pacific Circle, Unit 13
Mississauga, Ontario L5T-2A5
Canada
Fax: 905.564.7092
Troxler European Subsidiary
Troxler Electronics GmbH
Gilchinger Strasse 33
D.82239 Alling nr. Munich, Germany
Phone: ++49.8141.71063
Fax: ++49.8141.80731
HOW TO USE THIS MANUAL
Congratulations on the purchase of the Troxler Model 3411-B
Advanced Control Unit (ACU). The ACU enables the owner of a
Troxler Model 3411-B Surface Moisture-Density Gauge to enjoy all
the features and functions of our Model 3430 gauge for less than the
cost of a new gauge.
The Model 3411-B Advanced Control Unit Manual of Operation
and Instruction contains information on installing the ACU, and on
safely using the Model 3411-B gauge after the ACU has been
installed. Also included in this manual are safety warnings, gauge
setup, troubleshooting, and general maintenance information.
iv
Model 3411-B Advanced Control Unit v
CONVENTIONS USED IN THIS MANUAL
Throughout this manual, symbols and special formatting are used to
reveal the purpose of the text as follows:
WARNING
Indicates conditions or procedures that, if not followed
correctly, may cause personal injury.
CAUTION
Indicates conditions or procedures that, if not followed
correctly, may cause equipment damage.
NOTE
Indicates important information that must be read to
ensure proper operation.
〈Key〉Angle brackets and a different typestyle indicate a
key or character (number or letter) to press on the
ACU keypad. For example, “Press 〈STD〉” means
to press the key labeled STD.
Display A different typestyle is used in text to indicate
information or messages displayed on the ACU.
DISPLAY- Shading
& typestyle used
to simulate ACU
display.*
♦ Diamonds indicate a list of things needed (such as
equipment) or things to know.
Check marks indicate the performance of an action.
With lists of check marks, follow the instructions in
the order of the check marks.
Triangles indicate that more than one option is
available. Carefully select the option that applies.
* The ACU is equipped with a two-line backlit display.
NOTES
vi
Model 3411-B Advanced Control Unit vii
TABLE OF CONTENTS
CHAPTER 1. INTRODUCTION AND INSTALLATION
Introduction................................................................................... 1–2
Installing the ACU........................................................................ 1–3
Entering the Calibration Constants............................................... 1–4
CHAPTER 2. OPERATING THE GAUGE
The Keypad................................................................................... 2–2
Turning the Gauge On .................................................................. 2–4
Gauge Parameter Setup................................................................. 2–5
Taking the Standard Count........................................................... 2–8
Site Preparation/Gauge Positioning............................................ 2–10
Taking a Measurement – Soil Mode........................................... 2–13
TakingaMeasurement– AsphaltMode.......................................... 2–16
CHAPTER 3. ADVANCED GAUGE OPERATION
Offsets........................................................................................... 3–2
Special Calibrations...................................................................... 3–8
Thin Layer Measurements.......................................................... 3–12
CHAPTER 4. SPECIAL FUNCTIONS
Recall............................................................................................ 4–2
Offset ............................................................................................ 4–2
Stat Test........................................................................................ 4–2
Drift Test....................................................................................... 4–5
Special Calibration........................................................................ 4–7
Specific Gravity............................................................................ 4–7
Voidless Density........................................................................... 4–8
Set Units........................................................................................ 4–8
Calibration Constants.................................................................... 4–9
Memory Reset............................................................................... 4–9
Test Reading................................................................................. 4–9
15-Second Inhibit........................................................................ 4–10
TABLE OF CONTENTS (Continued)
APPENDIX A. 3411-B ELECTRICAL SPECIFICATIONS
Electrical Specifications...............................................................A–2
APPENDIX B. PERIODIC MAINTENANCE AND SERVICE
Troubleshooting............................................................................B–2
Battery Charging ..........................................................................B–7
Replacement Parts........................................................................B–8
Returning the Gauge for Service................................................B–10
Troxler Service Centers..............................................................B–11
INDEX
WARRANTY
viii
Model 3411-B Advanced Control Unit ix
LIST OF FIGURES
Figure Title Page
2–1 Model 3411-B ACU Keypad.....................................2–2
2–2 Drill Rod Positioning ..............................................2–11
2–3 Marking the Test Area ............................................2–11
2–4 Voids Illustration.....................................................2–15
B–1 Model 3411-B ACU Assembly.................................B–9
LIST OF TABLES
Table Title Page
2–1 Model 3411-B ACU Keypad Functions....................2–3
3–1 K Values for Thin Lift Overlays............................. 3–14
NOTES
x
Table des matières
Manuels Unité de contrôle populaires d'autres marques
Festo
Festo Compact Performance CP-FB6-E Manuel de la liste des pièces
Elo TouchSystems
Elo TouchSystems DMS-SA19P-EXTME Manuel utilisateur
JS Automation
JS Automation MPC3034A Manuel utilisateur
JAUDT
JAUDT SW GII 6406 Series Guide rapide
Spektrum
Spektrum Air Module System Manuel utilisateur
BOC Edwards
BOC Edwards Q Series Manuel utilisateur
