Tripp Lite Power Accessory Module PAM-3 Manuel utilisateur

1111 W. 35th Street

Chicago, IL 60609 USA

Customer Support: (773) 869-1234

www.tripplite.com

Instruction Sheet

PAM-3

Power Accessory Module

The PAM-3 Power Accessory Module provides a wide variety of electrical outlets for the output of a

Tripp Lite UPS system. The PAM-3 may be hardwired to the output of a Unison SmartOnLine®

SU6K or SU10K.

Safety:

• The PAM-3 features both 120V and 208/240V outlets. Make sure to connect equipment to

receptacles of the correct voltage.

• A total load of 30 amps can be drawn from the PAM-3. When connecting equipment,

take care not to exceed this current rating.

Connecting a PAM-3 to the Output of a SmartPro

DataCenter or PAM-1

• Simply plug your PAM-3's NEMA L14-30P plug into the NEMA L14-30R output

receptacle on the rear of your SmartPro DataCenter unit or on the front of your PAM-1.

Unison SmartOnLine®and SmartPro DataCenter®are registered trademarks of Tripp Lite.

Connecting a PAM-3 to the Output of a Unison SU6K

or SU10K

WARNING: Before connection, make sure that your Unison system is OFF, that both input

and output breakers are switched OFF and that the system is not connected to AC power.

(See Unison Owner's Manual.)

• Remove the PAM-3's input plug by loosening its strain relief, unscrewing and removing

the plug's housing, detaching the power cord's four internal colored wires from their

terminals and sliding off the plug.

• Strip an additional 1" to 2" of the outer (black) casing of the power cord away from the

internal colored wires. Neatly shape the exposed metal ends of the four colored wires

to eliminate loose strands.

• Slip the strain relief provided over the exposed end of the power cord, then thread the

exposed end of the power cord through the knockout nearest the right of the Unison's

terminal block.

• Connect the colored wires to the Unison's terminal block as shown below. The black

cord can be connected for either 240V output or 208V output. Note: the desired output

voltage MUST match the Unison's input voltage. (See Unison Owner's Manual.)

• Tighten the strain relief and affix it to the knockout.

(Note: This diagram shows the terminal block of a SU6kVA model. SU10kVA models have double connectors, but the wires are

attached to the same terminals on both models.)

Black

208 V

Black

240 V

Green

White

Red

93-1844 (200006177) 7/00

Table des matières

Autres manuels Tripp Lite Unité de contrôle

Tripp Lite

Tripp Lite APS 1024 INT Manuel utilisateur

Tripp Lite

Tripp Lite N482TAP-4SM73LC Manuel utilisateur

Tripp Lite

Tripp Lite SRCOOLNETLX Manuel utilisateur

Tripp Lite

Tripp Lite SmartOnline Series Manuel utilisateur

Tripp Lite

Tripp Lite HC350S Series Mode d’emploi

Tripp Lite

Tripp Lite SRCOOLNET2LX Manuel utilisateur

Tripp Lite

Tripp Lite Power Accessory Module PAM-1 Instructions d'installation et d'utilisation

Tripp Lite

Tripp Lite SmartOnline SU5000RT4UTFTAA Manuel utilisateur

Tripp Lite

Tripp Lite HC350S Series Mode d’emploi

Tripp Lite

Tripp Lite PVXXXXFC Manuel utilisateur

Tripp Lite

Tripp Lite AG-0514 Series Manuel utilisateur

Tripp Lite

Tripp Lite IP Remote Access Unit Manuel utilisateur

Tripp Lite

Tripp Lite SmartRack SRCABLEDUCT1UHD Manuel utilisateur

Tripp Lite

Tripp Lite Power Accessory Module PAM-2 Manuel utilisateur

Tripp Lite

Tripp Lite B021-000-19-HD2 Manuel utilisateur

Manuels Unité de contrôle populaires d'autres marques

Festo

Festo Compact Performance CP-FB6-E Manuel de la liste des pièces

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Manuel utilisateur

JS Automation

JS Automation MPC3034A Manuel utilisateur

JAUDT

JAUDT SW GII 6406 Series Guide rapide

Spektrum

Spektrum Air Module System Manuel utilisateur

BOC Edwards

BOC Edwards Q Series Manuel utilisateur

KHADAS

KHADAS BT Magic Manuel utilisateur

Etherma

Etherma eNEXHO-IL Manuel utilisateur

PMFoundations

PMFoundations Attenuverter Manuel utilisateur

GEA

GEA VARIVENT Manuel utilisateur

Walther Systemtechnik

Walther Systemtechnik VMS-05 Manuel utilisateur

Altronix

Altronix LINQ8PD Instructions de montage

Eaton

Eaton Powerware Series Manuel utilisateur

WAGO

WAGO 750-407/040-000 Manuel utilisateur

Sony

Sony CCU-590 Manuel utilisateur

Graco

Graco 25D614 Manuel utilisateur

Task Force Tips

Task Force Tips YE-RF-900 Manuel de programmation

Shini

Shini SPV-U Series Manuel utilisateur