TRENDnet TEG-160WS Manuel utilisateur

Quick Installation Guide

TEG-160WS

TEG-240WS

H/W: C1

Table of Contents

English ......................................................................................................

Troubleshooting ........................................................................................

1. Before You Start

2. Hardware Installation ........................................................................

3. Web Management Utility ....................................................................

................................................................................

Table of Contents

Version 07.29.2008

System Requirements

Application

?TEG-160WS/TEG-240WS

?Quick Installation Guide

?Utility & User Guide CD-ROM

?2 Mounting Brackets with Screws

?Power Cord

?Web Browser: Internet Explorer (5.0 or above), Netscape (6.0 or above)

?Computer with Network adapter installed

?Optional Mini-GBIC modules (e.g. TEG-MGBSX, TEG-MGBS10,

TEG-MGBS40, TEG-MGBS80, TEG-MGBS10D3_5, TEG-MGBS40D3_5)

for Mini-GBIC slots

Package Contents

1. Before You Start

English

2. Hardware Installation

English

2. Connect a CAT-5e or 6 RJ-45

network cable from the computer to

an available Ethernet port of the

TEG-160WS/TEG-240WS.

1. Connect the Power Cord to the

rear of the TEG-160WS/

TEG-240WS and then to a power

outlet.

Note:

1. After hardware installation is complete, use the Web Browser to configure

the TEG-160WS/TEG-240WS. To access the Web Browser configuration,

open your web browser, and enter the default IP Address http://192.168.0.1

and default password "admin". Make sure your computer and the

TEG-160WS/TEG-240WS are configured to the same network segment.

2. The Mini-GBIC slots are shared with Port 15 and 16 (TEG-160WS) and port

23 and 24 (TEG-240WS) Gigabit Ethernet ports. When the Mini-GBIC slots

are in use, port 15 and 16 (TEG-160WS) and port 23 and 24 (TEG-240WS)

Gigabit Ethernet ports are disabled.

English

Note: If you would like to easily discover all the Web Management Switches on

the network, assign IP Address, change the password, and upgrade to new

firmware, then install the Web Management Utility. Follow the steps below.

3. Click Start > Programs >

web_management_utility, and

then click

web_management_utility.

3. Web Management Utility

For Windows User

1. Insert the Utility & User’s Guide

CD-ROM into your computer's

CD-ROM Drive and then click

Install Utility.

2. Follow the Installation Wizard

instructions. Click OK.

English

4. Click Discovery, and then double-

click the Switch that appears in

the Discovery List.

5. Click the Switch in the Monitor

List and then click Configuration

setting.

6. Configure the IP Address, Subnet

mask, Gateway, and Password.

Click Set.

English

7. Click OK.

8. Click Access Web.

9. Type in your Password and then

click Login. By default, the

Password is admin.

For more information regarding the Web-based Smart Utility configuration and

advanced settings, please refer to the User's Guide included on the Utility &

Driver CD-ROM or TRENDnet's website at www.trendnet.com

To ensure the highest level of customer service and support, please take a moment to

Thank you for choosing TRENDnet

Q1:

A1:

Q2:

A2:

Q3:

A3:

Q4:

A4:

Q5:

A5:

After connecting the TEG-160WS/TEG-240WS to a power outlet, the LEDs do not turn

on.

Check the connection of the power cord to the TEG-160WS/TEG-240WS and the power

outlet. Also check that the power outlet is receiving power.

After installing the Web-Management Utility, I clicked Discovery and the Utility is unable

to discover the TEG-160WS/TEG-240WS. What should I do?

Make sure that the TEG-160WS/TEG-240WS is powered on and that all connections are

secure. Also check that your computer's IP Address is on the same network segment as the

TEG-160WS/TEG-240WS. The default IP Address of the Switch is 192.168.0.1 and the

default password is admin.

When I access the TEG-160WS/TEG-240WS using a web browser, I get a screen that

tells me “only one user can login”. What should I do?

Another computer is configuring the TEG-160WS/TEG-240WS. Please wait until the

user logs off. If the other user has already logged off and you still get the same screen, then

disconnect the power cord from the TEG-160WS/TEG-240WS, wait for 5 seconds, reconnect

the power cord to theTEG-160WS/TEG-240WS, allow 5 seconds for the Switch to power on,

and then attempt to access the web configuration page to login.

I forgot the administration password. How do I reset my TEG-160WS/TEG-240WS?

Press on the reset button using a pen or paperclip for 10 seconds. The default

password is admin.

When I connect a computer to the Switch's gigabit port, the LINK/ACT LED turns on, but

the 100Mbps LED remains off.

For the TEG-160WS, when the 1000Mbps LED remains off, the computer's connection

speed is 10Mbps or 100Mbps (if the 100Mbps LED is on). For the TEG-240WS, if the

SPEED LED is off, the computer's connection speed is 10Mbps. When the SPEED LED is

yellow, the computer's connection speed is 100Mbps. Make sure that you have a Gigabit

Ethernet adapter installed. Also make sure to use a Cat-5e or Cat 6 Ethernet cable.

If you still encounter problems or have any questions regarding the TEG-160WS/TEG-240WS,

please refer to the User's Guide included on the Utility CD-ROM or contact Trendnet's Technical

Support Department.

Troubleshooting

Certifications

This equipment has been tested and found to comply with FCC and CE Rules.

Operation is subject to the following two conditions:

(1) This device may not cause harmful interference.

(2) This device must accept any interference received. Including interference that may

cause undesired operation.

NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV

INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS

EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO

OPERATE THE EQUIPMENT.

Waste electrical and electronic products must not

be disposed of with household waste. Please

recycle where facilities exist. Check with you Local

Authority or Retailer for recycling advice.

ADVERTENCIA

En todos nuestros equipos se mencionan claramente las caracteristicas del adaptador de alimentacón

necesario para su funcionamiento. El uso de un adaptador distinto al mencionado puede producir

daños fisicos y/o daños al equipo conectado. El adaptador de alimentación debe operar con voltaje y

frecuencia de la energia electrica domiciliaria existente en el pais o zona de instalación.

Product Warranty Registration

Please take a moment to register your product online.

Go to TRENDnet’s website at http://www.trendnet.com/register

20675 Manhattan Place

Torrance, CA 90501

USA

Autres manuels pour TEG-160WS

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels TRENDnet Routeur réseau

TRENDnet

TRENDnet TEG-S81g Manuel utilisateur

TRENDnet

TRENDnet TW100-BRV304 SHEETS Manuel utilisateur

TRENDnet

TRENDnet TE100-S16 - DATA SHEETS Manuel utilisateur

TRENDnet

TRENDnet TEW-711BR Manuel utilisateur

TRENDnet

TRENDnet TEG-448WS - Switch Manuel utilisateur

TRENDnet

TRENDnet TE100-S5Pplus Guide de démarrage rapide

TRENDnet

TRENDnet TEW-818DRU Manuel utilisateur

TRENDnet

TRENDnet TEW-827DRU Manuel utilisateur

TRENDnet

TRENDnet TPL-202E2K - Powerline Fast EN Adapter Manuel utilisateur

TRENDnet

TRENDnet TE100-S2424V Manuel utilisateur

TRENDnet

TRENDnet TEW-652BRP Manuel utilisateur

TRENDnet

TRENDnet TW-100 Manuel utilisateur

TRENDnet

TRENDnet TEW-231BRP Manuel utilisateur

TRENDnet

TRENDnet TW100-BRF214 Manuel utilisateur

TRENDnet

TRENDnet AC3200 Manuel utilisateur

TRENDnet

TRENDnet TEW-435BRM - 54MBPS 802.11G Adsl Firewall M Manuel utilisateur

TRENDnet

TRENDnet TEW-929DRU Manuel utilisateur

TRENDnet

TRENDnet TEW-721BRM Manuel utilisateur

TRENDnet

TRENDnet TW100-BRV204 SHEETS Manuel utilisateur

TRENDnet

TRENDnet TW100-W2plus Manuel utilisateur

TRENDnet

TRENDnet TE100-S16 - 10/100Mbps Ethernet Switch Manuel utilisateur

TRENDnet

TRENDnet TEW-721BRM Manuel utilisateur

TRENDnet

TRENDnet TEW-452BRP - 108Mbps Wireless Super G Broadband... Manuel utilisateur

TRENDnet

TRENDnet TEW-829DRU Manuel utilisateur

Manuels Routeur réseau populaires d'autres marques

Allnet

Allnet ALL0333AU Manuel utilisateur

HomeSeer

HomeSeer HT-SEL Manuel utilisateur

Sercomm

Sercomm Genesis OC3505D Manuel utilisateur

Billion

Billion BIPAC 5102 Series Manuel utilisateur

TP-Link

TP-Link TD-8817 Manuel utilisateur

Motorola

Motorola MR1900 Manuel utilisateur

Digi

Digi IX14 Manuel utilisateur

Cisco

Cisco NCS 540 Manuel

XAVi

XAVi X8821e Manuel utilisateur

BEC

BEC 6200WZL Manuel utilisateur

MikroTik

MikroTik hAP ac3 Series Manuel utilisateur

Korenix

Korenix JetNet 5428G Series Manuel utilisateur

NETGEAR

NETGEAR FS526T - Switch Manuel utilisateur

Korenix

Korenix JetNet 5710G Series Manuel utilisateur

Automated Logic

Automated Logic ZN551 Manuel du propriétaire

Cisco

Cisco ASR 1000 Series Manuel de l'opérateur

EnGenius

EnGenius ESR-9710 Manuel utilisateur

Cisco

Cisco 805 Series Instructions d'utilisation et de sécurité