Transition Networks SM24TAT4XA Manuel utilisateur
Publication date: Nov, 2014
RevisionA1.1
1
24-Port Gigabit PoE+ Managed Switch
SM24TAT4XA
Installation and Getting Started Guide
Publication date: Nov, 2014
RevisionA1.1
ii
ABOUT THIS GUIDE
PURPOSE This guide gives specific information on how to operate and
use the management functions of the switch.
AUDIENCE The guide is intended for use by network administrators who
are responsible for operating and maintaining network
equipment; consequently, it assumes a basic working
knowledge of general switch functions, the Internet Protocol
(IP), and Simple Network Management Protocol (SNMP).
CONVENTIONS The following conventions are used throughout this guide to
show information:
WARRANTY See the Customer Support/ Warranty booklet included with
the product.
A copy of the specific warranty terms applicable to your
Manufacture products and replacement parts can be obtained
from your Manufacture Sales and Service Office pr authorized
dealer.
NOTE:Emphasizes important information or calls your
attention to related features or instructions.
W
ARNING
:
Alerts you to a potential hazard that could cause
personal injury.
C
AUTION
:
Alerts you to a potential hazard that could cause loss
of data, or damage the system or equipment.
Publication date: Nov, 2014
RevisionA1.1
iii
COMPLIANCES AND
SAFETY STATEMENTS
FCC-CLASS A This equipment has been tested and found to comply with the
limits for a Class A computing device pursuant to Subpart J of
part 15 of FCC Rules, which are designed to provide reasonable
protection against such interference when operated in a
commercial environment.
This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference to
radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which
case the user will be required to correct the interference at his
own expense.
You are cautioned that changes or modifications not expressly
approved by the party responsible for compliance could void
your authority to operate the equipment.
You may use unshielded twisted-pair (UTP) for RJ-45
connections - Category 3 or better for 10 Mbps connections,
Category 5 or better for 100 Mbps connections, Category 5, 5e,
or 6 for 1000 Mbps connections. For fiber optic connections, you
may use 50/125 or 62.5/125 micron multimode fiber or 9/125
micron single-mode fiber.
CE MARK
DECLARATION
OF CONFORMANCE
FOR EMI AND
SAFETY (EEC)
This equipment has been tested and found to comply with the
protection requirements of European Emission Standard
EN55022/EN61000-3 and the Generic European Immunity
Standard EN55024.
EMC:
EN55022(2006)+A1:2007/CISPR Class A
Publication date: Nov, 2014
RevisionA1.1
4
22:2006+A1:2006 4K V CD, 8KV, AD
IEC61000-4-2 (2001) 3V/m
IEC61000-4-3( 2002) 1KV – (power line), 0.5KV – (signal line)
IEC61000-4-4(2004) Line to Line: 1KV, Line to Earth: 2KV
IEC61000-4-5 (2001) 130dBuV(3V) Level 2
IEC61000-4-6 (2003) 1A/m
IEC61000-4-8 (2001) Voltage dips:
>95%, 0.5period, 30%, 25periods
IEC61000-4-11(2001) Voltage interruptions:
>95%, 250periods
RELATED
PUBLICATIONS
The following publication gives specific information on how to
operate and use the management functions of the switch:
The User’s Manual
Date Revision
5/30/2013 A1
11/19/2014 A1.1
Publication date: Nov, 2014
RevisionA1.1
v
Contents
ABOUT THIS GUIDE........................................................................................................ii
COMPLIANCES AND SAFETY STATEMENTS......................................................iii
INTRODUCTION................................................................................................................1
OVERVIEW.................................................................................................................................... 1
DESCRIPTION OF HARDWARE.................................................................................4
NETWORK PLANNING ...................................................................................................7
INTRODUCTION TO SWITCHING..................................................................................... 7
APPLICATION EXAMPLES.................................................................................................... 7
INSTALLING THE SWITCH........................................................................................10
SELECTING A SITE................................................................................................................. 10
ETHERNET CABLING ............................................................................................................. 10
EQUIPMENT CHECKLIST......................................................................................................11
PACKAGE CONTENTS.............................................................................................................11
MOUNTING..................................................................................................................................11
CONNECTING TO A POWER SOURCE........................................................................... 14
CONNECTING TO THE CONSOLE PORT....................................................................... 14
Operation of Web-based Management.............................................................17
MAKING NETWORK CONNECTIONS....................................................................18
CONNECTING NETWORK DEVICES............................................................................... 18
TWISTED-PAIR DEVICES................................................................................................... 18
FIBER OPTIC SFP DEVICES............................................................................................... 22
CABLE LABELING AND CONNECTION RECORDS.......................................25
TROUBLESHOOTING ....................................................................................................26
Basic Troubleshooting Tips.............................................................................................. 26
POWER AND COOLING PROBLEMS......................................................................28
Installation ................................................................................................................................ 28
IN-BAND ACCESS.................................................................................................................... 28
Publication date: Nov, 2014
RevisionA1.1
vi
CABLES.................................................................................................................................29
TWISTED-PAIR CABLE AND PIN ASSIGNMENTS ................................................. 29
STRAIGHT- THROUGH WIRING...................................................................................... 30
1000BASE-T PIN ASSIGNMENTS................................................................................... 31
CABLE TESTING FOR EXISTING CATEGORY 5 CABLE........................................ 31
FIBER STANDARDS................................................................................................................ 32
SPECIFICATIONS...........................................................................................................33
PHYSICAL CHARACTERISTICS........................................................................................ 33
SWITCH FEATURES.................................................................................................................. 2
MANAGEMENT FEATURES.................................................................................................... 2
STANDARDS................................................................................................................................. 2
COMPLIANCES.......................................................................................................................... 35
COMPLIANCES.................................................................................................................36
Publication date: Nov, 2014
RevisionA1.1
1
INTRODUCTION
OVERVIEW The SM24TAT4XA is an affordable managed switch that
provides a reliable infrastructure for your network. These
switches deliver more intelligent features to improve the
availability of your critical business applications, protect your
sensitive information, and optimize your network bandwidth to
deliver information and applications more effectively. Easy to
set up and use, it provides the ideal combination of
affordability and capabilities for entry level Networking
includes Small Business or enterprise application and helps you
create a more efficient, better-connected workforce.
The SM24TAT4XA is able to provide up to 24 ports of Gigabit
Ethernet connectivity as well as 4 ports of 10G Ethernet
connectivity. It provides ideal flexibility to design suitable
network infrastructure for business requirement. The switch
supports the advanced security management capabilities and
network features to support includes data, voice, security, and
wireless technologies. Besides, these switches are easy to
deploy and configure, providing stable and quality performance
network services your business needs.
Publication date: Nov, 2014
RevisionA1.1
2
Front of the Switch
Back of the Switches
Publication date: Nov, 2014
RevisionA1.1
3
SWITCH
ARCHITECTURE
The switch performs a wire-speed, non-blocking switching fabric.
This allows wire-speed transport of multiple packets at low
latency on all ports simultaneously. The switch also features
full-duplex capability on all ports, which effectively doubles the
bandwidth of each connection.
This switch uses store-and-forward technology to ensure
maximum data integrity. With this technology, the entire packet
must be received into a buffer and checked for validity before
being forwarded. This prevents errors from being propagated
throughout the network.
NETWORK
MANAGEMENT
OPTIONS
The switch can also be managed over the network with a web
browser or Telnet application. The switch includes a built-in
network management agent that allows it to be managed
in-band using SNMP or RMON (Groups 1, 2, 3, 9) protocols. It
also has an RS-232 console port connector on the front panel for
out-of-band management. A PC may be connected to this port
for configuration and monitoring out-of-band via a null-modem
serial cable. (See Appendix B for wiring options.)
NOTE:For a detailed description of the management features,
refer to the User’s manual.
Publication date: Nov, 2014
RevisionA1.1
4
DESCRIPTION OF
HARDWARE
1000BASE-T
PORTS
The switch has 24 10/100/1000BASE-T RJ-45 ports. All RJ-45
ports support automatic MDI/MDI-X operation, auto-negotiation
and IEEE 802.3x auto-negotiation of flow control, so the
optimum data rate and transmission can be selected
automatically.
SFP
TRANSCEIVER
SLOTS
SM24TAT4XA supports 1G/10G dual speed SFP+ slots on port
25 to 28.
Please visit our web page below for the detail of the available SFP+/SFP modules:
http://www.transition.com
Ce manuel convient aux modèles suivants
1
Table des matières
Autres manuels Transition Networks Changer
Transition Networks
Transition Networks SISTG1040-242-LRT Manuel utilisateur
Transition Networks
Transition Networks SM8TAT2SA-DC Manuel utilisateur
Transition Networks
Transition Networks ETHERNET POCKET HUB 401 Manuel utilisateur
Transition Networks
Transition Networks SISPM1040-582-LRT Manuel utilisateur
Transition Networks
Transition Networks E-TBT-HB-0400 Manuel utilisateur
Transition Networks
Transition Networks STACKMASTER TR SMHB-TR-16 Manuel utilisateur
Transition Networks
Transition Networks SISPM1040-384-LRT-C Manuel utilisateur
Transition Networks
Transition Networks SM TAT4X Series Manuel utilisateur
Transition Networks
Transition Networks SM24DPa Manuel utilisateur
Transition Networks
Transition Networks SISTM1040-262D-LRT-B Instructions d'utilisation et d'entretien
Transition Networks
Transition Networks Milan MIL-SM2401MAF Manuel utilisateur
Transition Networks
Transition Networks MIL-SEM24T4GPA Manuel utilisateur
Transition Networks
Transition Networks StackMaster SMHB-E-FL-12 Manuel utilisateur
Transition Networks
Transition Networks SESPM1040-541-LT Series Manuel utilisateur
Transition Networks
Transition Networks SM8TAT2SA Manuel utilisateur
Transition Networks
Transition Networks SM TAT4X Series Manuel utilisateur
Transition Networks
Transition Networks SM24DPB Manuel utilisateur
Transition Networks
Transition Networks MIL-S2400S Manuel utilisateur
Transition Networks
Transition Networks SISTM1040-262D-LRT Manuel utilisateur
Transition Networks
Transition Networks SISPM1040-362-LRT Manuel utilisateur
