Touch Revolution TDS-32F Series Manuel utilisateur
TDS-32F Series
Touch Screen LCD Monitors
USER’s GUIDE
Rev.D
The information contained in this document is subject to change without notice.
This document contains proprietary information that is protected by copyright. All rights
are reserved. No part of this document may be reproduced,translated to another language
or stored in a retrieval system, or transmitted by any means, electronic, mechanical,
photocopying, recording, or otherwise, without prior written permission. Windows is a registered
trademark of Microsoft, Inc. Other brand or product names are trademarks of their respective
holders.
The test results show that this device meets the FCC rules. Those limits are set to protect
residential areas from the devices with harmful emission. This device will produce, use and
radiate radio frequency energy. In addition, failure to follow the user’s manual to install or use
this device might produce harmful interference with radio communication. Not withstanding
the foregoing, it does not guarantee that this type of harmful interference does not occur in
some special installations. The interference caused by this device to the reception of radio
or television signals may be verified by turning it on and off. Any changes or modifications to
this TFT LCD would void the user’s authority to operate this device.
Table of Contents
Usage Notice
Precautions............................................................................................................................. 1
Introduction
About TDS-32FP Series ......................................................................................................... 2
Touch Screen for TDS-32FP (Bezel Less) ............................................................................ 3
Package Overview ...................................................................................................... 4
Installation
Product Overview ........................................................................................................ 5
Front View .............................................................................................................. 5
Bottom View ........................................................................................................... 5
VESA Mount for Your Monitor ...................................................................................... 6
Start Your Installation .................................................................................................. 7
Connecting the Display (Figure 9.1)............................................................................. 8
(Figure 9.1) ............................................................................................................. 9
User Controls
Rear Panel Controls ...................................................................................................10
How to Use the OSD Menus .......................................................................................11
On-Screen Display Menus ..........................................................................................12
Appendix
Troubleshooting..........................................................................................................13
Warning Signal ...........................................................................................................14
No Signal ...............................................................................................................14
Going to Sleep........................................................................................................14
Out of Range..........................................................................................................14
Product Dimensions ...................................................................................................15
Compatibility Modes ...................................................................................................16
Touch Screen Driver Installation .................................................................................17
Usage Notice
! Warnin
g
- To prevent the risk o
f
fi
re or shock hazards, do not expose
this product to rain or moisture.
! Warnin
g
- Please do not open or disassemble the product as this ma
y
cause
e
l
ec
tri
c
s
h
oc
k.
Precautions
Follow all warnings, precautions and maintenance as recommended in this user’s manual to
maximize the life of your unit.
Do:
• Turn off the product before cleaning.
• Touch screen surface may be cleaned using a soft clean cloth moistened with mild
window glass commercial cleaners or 50/50 mixture of water and isopropylalcohol.
• Use a soft cloth moistened with mild detergent to clean the display housing.
• Disconnect the power plug from AC outlet if the product is not going to be used for
an extended period of time.
Don’t:
• Do not touch the LCD display screen surface with sharp or hard objects.
• Do not use abrasive cleaners, waxes or solvents for your cleaning.
• Do not operate the product under the following conditions:
- Extremely hot, cold or humid environment.
- Areas susceptible to excessive dust and dirt.
- Near any appliance generating a strong magnetic field.
- In direct sunlight.
1
Introduction
About TDS-32FP Series
The TDS-32FP Series is a 31.5" flat panel screen with an active matrix, thin-film
transistor (TFT) liquid crystal display (LCD).
Features include:
• Direct Analog signal input
• Direct Digital signal input
• Active matrix TFT LCD technology
• 1920 x 1080 resolution
• 31.5" viewable display area - 16:9 aspect ratio
• 31.47 ~ 67.5 KHz horizontal scan
• 47 ~ 63 Hz high refresh rate
• 0.36375mm x 0.36375mm pixel pitch
• Auto adjustment function
• Multilingual OSD user control
• 400mm x 200mm VESA mount
• TDS-32FP - Projected Capactive touch screen with USB controller
• Audio - 8W x 2
2
Touch Screen for TDS-32FP (Bezel Less)
• Project Capacitive touch screen for finger input only
• Surface: Glare treatment
• Interface: USB controller
• Transmittance: 90%±5%
• HID: Windows® 7
• Driver: VISTA, XP, 2000, CE, XP Embedded,
Linux kernel 2.6.x (32 bit & 64 bit), Apple® Mac OS
3
Package Overview
LCD Display
USB Cable (A to B)
Power Cord
Audio-in Cable
Quick Start Guide Touch Driver CD
VGA Signal Cable
DVI-D Cable
Cable Cover Screw
Remote Key
(sold separately)
4
Installation
Product Overview
• Front View
• Bottom View
5
USB
COM OUT
REMOTE KEY
COM IN
AUDIO OUT
AC IN
DVI IN
VGA IN
AUDIO IN
VESA Mount for Your Monitor
This monitor conforms to the VESA Flat Panel Mounting Physical Mounting Interface
standard which defines a physical mounting interface for flat panel monitors, and
corresponding with the standards of flat panel monitor mounting devices, such as wall and
table arms. The VESA mounting interface is located on the back of your monitor.
To mount the monitor on a UL certified swing arm or other mounting fixture, follow the
instructions included with the mounting fixture to be used.
400
200
4- R13
! Warning!
Please select the proper screws!
The distance between the back cover surface and the bottom of the screw hole
is 8 mm. Please use four M6 screws diameter with proper length to mount your
monitor.
Please note: the mounting stand must be able to support at least 44.1 lbs (20Kg).
6
7
Start Your Installation
Please follow these instructions so that you can hook up the cables to associated connectors.
1. Lay the LCD flat on an even surface and take off cable cover as seen in the step 1 diagram.
2. Connect the cables to the appropriate connectors as seen in the step 2 diagram.
3. Take screw from the accessory box, and put all cables under the cover lip, then use a
Philips Head screw driver, insert the screw (CBM M3x6) into cable cover and monitor as
seen in the step 3-1 or step 3-2 diagram either.
Step 1
Step 3-1 Step 3-2
COM-InVGA
COM-OutDVI
USBPower
Audio-Out
Audio-In
Step 2
Table des matières
Autres manuels Touch Revolution Moniteur
