Touch Revolution M19A Series Manuel utilisateur
M19A Series
Touch Screen LCD Monitors
USER’s GUIDE
Rev.A
The information contained in this document is subject to change without notice.
This document contains proprietary information that is protected by copyright. All rights
are reserved. No part of this document may be reproduced,translated to another language
or stored in a retrieval system, or transmitted by any means, electronic, mechanical,
photocopying, recording, or otherwise, without prior written permission. Windows is a registered
trademark of Microsoft, Inc. Other brand or product names are trademarks of their respective
holders.
The test results show that this device meets the FCC rules. Those limits are set to protect
residential areas from the devices with harmful emission. This device will produce, use and
radiate radio frequency energy. In addition, failure to follow the user’s manual to install or use
this device might produce harmful interference with radio communication. Not withstanding
the foregoing, it does not guarantee that this type of harmful interference does not occur in
some special installations. The interference caused by this device to the reception of radio
or television signals may be veried by turning it on and off. Any changes or modications to
this TFT LCD would void the user’s authority to
operate this device.
Important Recycle Instruction:
Lamp(s) inside this product contains mercury. This product may contain other
electronic waste that can be hazardous if not disposed of properly. Recycle or
dispose in accordance with local, state, or federal Laws. For more information,
contact the Electronic Industries Alliance at WWW.EIAE.ORG. For lamp specic
disposal information check WWW.LAMPRECYCLE.ORG.
Table of Contents
Usage Notice
Precautions............................................................................................................................. 1
Introduction
About M19A Series................................................................................................................. 2
Touch Screen for M19A-0101 ...................................................................................... 3
Package Overview ...................................................................................................... 4
Installation
Product Overview ........................................................................................................ 4
Front View.............................................................................................................. 4
Bottom View (Without Stand) .................................................................................. 4
Kensington Security Slot.............................................................................................. 5
VESA Mount for your Monitor....................................................................................... 6
Start Your Installation .................................................................................................. 7
Connecting the Display (Figure 10.1)........................................................................... 9
(Figure 10.1)...........................................................................................................10
User Controls
Side Panel Controls....................................................................................................11
How to Use the OSD Menus .......................................................................................12
On-Screen Display Menus ..........................................................................................13
Appendix
Troubleshooting..........................................................................................................14
Warning Signal ...........................................................................................................15
No Signal... .................................................................................................................15
Going to Sleep............................................................................................................15
Out of Range..............................................................................................................15
Product Dimensions ...................................................................................................16
Compatibility Modes ...................................................................................................17
Touch Screen Driver Installation .................................................................................18
M19A-0101 Install Instructions:...............................................................................18
Usage Notice
! Warning - To prevent the risk of re or shock hazards, do not expose
this product to rain or moisture.
! Warning - Please do not open or disassemble the product as this may
cause electric shock.
Precautions
Follow all warnings, precautions and maintenance as recommended in this user’s manual to
maximize the life of your unit.
Do:
• Turn off the product before cleaning.
• Touch screen surface may be cleaned using a soft clean cloth moistened with mild
window glass commercial cleaners or 50/50 mixture of water and isopropyl alcohol.
• Use a soft cloth moistened with mild detergent to clean the display housing.
Don’t:
• Do not touch the LCD Display screen surface with sharp or hard objects.
• Do not use abrasive cleaners.
• Do not operate the product under the following conditions:
- Extremely hot, cold or humid environment.
- Areas susceptible to excessive dust and dirt.
- Near any appliance generating a strong magnetic eld.
- In direct sunlight.
1
Introduction
About M19A Series
The M19A-0101 Series is a 19" at panel screen with an active matrix, thin-lm
transistor (TFT) liquid crystal display (LCD).
Features include:
• Direct Analog signal input
• Direct Digital signal input
•Active matrix TFT LCD technology
•1280 x 1024 SXGA resolution
•19" viewable display area
•31.47 ~ 80 KHz horizontal scan
•56 ~ 75 Hz high refresh rate
•0.294mm x 0.294mm pixel pitch
•Auto adjustment function
•Multilingual OSD user control
•Kensington security slot
•100 mm VESA mount
• Removable base for exible mounting solutions.
•M19A-0101 - Projected Capactive touch screen with USB controller
• Built-in speakers-1W x 2
Touch Screen for M19A-0101
• Projected Capactive touch screen for nger input only
• Surface: Clear glass
• Interface: USB controller
• HID: Windows®7,VISTA, XP, 2000, ME, 98
• Driver: Linux kernel 2.6.x (32 bit & 64 bit)
2
Package Overview
LCD Display Power Cord VGA Signal Cable
USB Cable ( A to B) Audio-in Cable DVI-D Cable
3
DC Power Supply
(sold separately)
Quick Start Guide
Cable Cover
Screw
Installation
Product Overview
• Front View
• Bottom View (Without Stand)
VGA IN
AC INAUDIO DVI IN
USB DC IN
4
Kensington Security Slot
The monitor can be secured to your desk or any other xed object with Kensington lock
security products. The Kensington lock is not included.
5
VESA Mount for your monitor
This monitor conforms to the VESA Flat Panel Mounting Physical Mounting Interface
standard which denes a physical mounting interface for at panel monitors, and
corresponding with the standards of at panel monitor mounting devices, such as wall and
table arms. The VESA mounting interface is located on the back of your monitor.
To mount the monitor on a UL certied swing arm or other mounting xture, follow the
instructions included with the mounting xture to be used.
VESA
Mounting
Interface
Slots (x4)
100mm
100mm
75mm
75mm
AA
A
A
B
B
B
B
*A/B: The distance between the shielding surface and the bottom of the screw hole is
8 mm.
! Warning!
Please select the proper screws!
Please use four M4 screws of adequate length for mounting your monitor.
Please note: the mounting stand must be able to support at least 15.4 lbs (7Kg)
6
Start Your Installation
1. Lay the LCD at on an even surface.
2. Remove the stand back cover by pulling in the direction of the arrow as seen in step 2
diagram.
3. Move the stand into position as seen in step 3 diagram.
4. Connect the cables to the appropriate connectors as seen in Step 4 diagram.
7
Step 2
K
USB VGA
Power
Audio
Step 4
K
Step 3
Ce manuel convient aux modèles suivants
1
Table des matières
Autres manuels Touch Revolution Moniteur
